Question about 2006 Mazda 3

1 Answer

2006 mazda check engine light came on and when at stop light it spits and spudders

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Mazda Master
  • 5,680 Answers

Get the OBDII scanner and read code then try to fix.

Posted on Apr 22, 2013

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Spit and spudder


Clean the idle speed control valve in the upper intake near the throttle valve with CRC brand throttle cleaner.

Jan 10, 2014 | 1996 Toyota Camry

1 Answer

I have a mazda 6 sports wagon 2005 that has started slipping out of gear while driving. It stayed in third gear until I stopped and shut it off for a few minutes. The engine light came on. When I star


Check Mazda Service Bulletin 05-016/06.

2005-2006 Mazda6 3.0L vehicles produced before Feb 24, 2006 equipped with a 6-speed AW6A-EL automatic transaxle.

Slippage or shock when pressing accelerator fully from 4/5/6.

My car is experiencing this now... the"solution" according to Mazda is to replace a transmission that they knew bad.

Aug 13, 2012 | 2006 Mazda 6

2 Answers

I HAVE A 95 MITS. ECLIPSE IT BACK FIRES SPITS AND SPUDDERS. I PUT NEW PLUGS NEW EVAP SYSTEM. I WAS TOLD MY O2 SENCER WAS BAD. WOULD THAT MAKE IT RUN BAD


Not to cause back firing,spudder

It will effect the performance some,
as it reports exhaust gases & that is
used to adjust injector timing

May 27, 2011 | Mitsubishi Eclipse Cars & Trucks

1 Answer

I have a 1979 fiat spyder 2000 and i am having problems. it seems once the engine warms up, usually 5-7 miles down the road, it starts missing. i push down on the gas and the engine shakes, spits, and...


It sounds like the air bypass valve is not closing after warmup and this sounds like a temperature related problem. Air bypass is used much like the old choke on carburated cars for cold starts.

Aug 12, 2010 | 2006 Fiat 124

1 Answer

Check engine light on took to auto zone and had the computer code checked the result was #3 misfire wife told me it spit and spuddered. I have drove it all day with no problems i tried to reset the...


The light may have to be turned off with a scan tool. A misfire can happen once or twice and then vanish - maybe a single bad fuel pulse into the cylinder caused it. If it happens consistently then you'll need to look at it. For now though, have the light turned off and don't sweat it.

Nov 19, 2009 | 2004 Chevrolet Impala

1 Answer

2000 passat v6; check engine light+spuddering when accelerating


good chance with that problem you were close most likely a misfire will cause that. it would be either your spark plugs or coil pack. also make sure your vacuum lines are good and air filter is good. also bad gas can cause that problem. the worst outcome would be your throttle body going out on you.

Oct 17, 2009 | 1999 Volkswagen Passat

1 Answer

89 mazda b2200 spuddering and stalls


it could be the oxygen sensor for the mazda and the blazer you have something wrong with the distributor cap

May 26, 2009 | 2001 Chevrolet Blazer

1 Answer

I have a 1990 buick lesabre custom 4 door


Hi there,

I had the same problem with my 89 Buick Le sabre. It turned out that I had to replace the computer. It was giving the wrong signals and cutting off the fuel. My engine light came on each time it happened. Since the computer was changed it has run like a charm. It cost about $500.
Also when they ran the tests for the eng light data the computer was giving the wrong info and so many of the wrong parts were first replaced.

Sep 06, 2008 | 1990 Buick LeSabre

Not finding what you are looking for?
2006 Mazda 3 Logo

Related Topics:

52 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

yadayada
yadayada

Level 3 Expert

76848 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8582 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...