Question about 2007 Jeep Grand Cherokee Overland
I am looking for a Liftgate Lock Actuator motor for a 2007 grand Cherokee. Where can find it without the dealership?
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
I just had the same with mine, pull the rubber boot back on the drivers side front door and look for a severed wire, mine was black...simply spliced the wires back together and problem solved!
Posted on Mar 23, 2009
You need to remove all the skrews from the door. Normaly there is one in the handle of the door, one behind the in door lach handel and one under the bump out for the arm rest on the door. Than you need to take a flat head skrew driver slowly priying the panel off. There are plastic clips on the backside of the panel it is ok if you brake a few.
Posted on May 01, 2009
You need to remove the panel from the liftgate and unlock and open it manually at the latch. It is not fun, but you can get the panel off with the hatch closed.
Posted on Jun 13, 2009
First, if the noise is from the upper part of the engine and is more of a tapping than a knock, likely you have a problem in the valvetrain, most often a bad lifter or worn rocker arm. If the noise is low, deep inside, the noise is from a bearing. This is generally accompanied by lower than normal oil pressure. Regardless of the underlying cause, correcting the cause will not stop the knock. To do that correctly, the engine needs to be removed and all crankshaft bearings and the crankshaft itself need to be replaced (crank can sometimes be "undercut" and thicker bearing shells can be used depending upon the amount of wear.) If caught very early, sometimes only one bearing can be replaced in-car, but in 99% of all cases I have ever seen, most will fail again, sometimes more severely if done this way.
Posted on Dec 10, 2009
Tips for a great answer:
Jul 08, 2014 | Jeep Grand Cars & Trucks
Aug 22, 2010 | 2000 Jeep Grand Cherokee
Jun 07, 2010 | 1999 Jeep Grand Cherokee
Mar 02, 2010 | 2000 Jeep Grand Cherokee
Jan 02, 2010 | 2007 Jeep Grand Cherokee Overland
Dec 13, 2009 | 2000 Jeep Grand Cherokee
Jun 13, 2009 | 1997 Jeep Grand Cherokee
May 23, 2009 | 2008 Jeep Cherokee Grand
Apr 24, 2009 | 2000 Jeep Grand Cherokee
Feb 09, 2009 | 2001 Jeep Grand Cherokee
200 people viewed this question
Usually answered in minutes!