Question about Ford Taurus
Posted by Anonymous on
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
Either you may be using a key that you had copied from the original or your chip went bad in your original key. Most of cars now a days have the key censor in the key so if it is the incorrect key it will not start your car or if it does not read that chip it will not start
Posted on Feb 05, 2009
This means that your key is not being recogonized.Ethier the chip in the key is bad or the patts transciever at the lock cylinder. Do you have a spare key? If not you will have to get 2 new keyss cut and programmed.
Posted on Feb 16, 2009
Did you steal it? I heard about you thieves who steal cars then put new transmissions in!!
Seriously, try this, it may help...
Put the key in the ignition, and turn forward all the way just before cranking. Then within 5 seconds, locate, press and hold in the valet/overide button, found under the dash area, (push button, spring loaded) until the installed LED (the blinking light) in your dash area goes on solid, and the siren chirps once. (Your valet switch might be the toggle (on/off) type. in this case, key on, flip switch in opposite direction, then turn the key off.) This should reset the alarm, and reset the grounded relay on the starter wire, allowing you to start the engine. At this point, the only thing working would be the keyless entry from the alarm, if it came equipped that way. Just Repeat these steps to place it back to usable armed mode. You may get 2 chirps, confirming it, and the lights may flash twice as well. That should do it. Check out www.explorerforum.com
Posted on Dec 04, 2009
Try to close all the doors and windows and lock the car with remote or manually then open it with the key it should work .
Posted on Jul 22, 2010
SOURCE: The car wont start, the
TRY REPROGRAM KEY .PUT KEY IN IGNITION SWITCH TURN IGNITION SWITCH ON POSITION 20 SECONDS DONT START ENGINE WAIT 20 SECONDS TURN OFF SWITCH THEN TURN SWITCH BACK ON 20 SECONDS WATCH THE THEFT SECURITY LIGHT BLINKING.WHEN THEFT STOP BLINKING VECHICLE WILL CRANK.IF LIGHT STILL BLINKING.TRY FEW MORE TIMES KEY IN SWITCH ON POSITION FOR 20 SECONDS.MAKE SURE YOU HAVE THE CORRECT CAR KEYS IN SWITCH IF NOT WRONG SET OF CAR KEYS WILL SET OFF THEFT SECURITY SYSTEM.IF KEY RESETTING TRICK DONT WORK.CHECK BATTERY POWER MAKE SURE YOUR BATTERY HAS 12.5 VOLTS AND CHECK SECURITY THEFT FUSE.IF ALL LOOKS GOOD YOUR SECURITY HAS TO BE CHECKED OUT AT THE DEALERSHIP.
Posted on Oct 08, 2010
Tips for a great answer:
Sep 05, 2016 | 1998 Ford Taurus
Jan 21, 2016 | 2003 Ford Taurus
Jan 14, 2016 | Ford Cars & Trucks
Oct 18, 2015 | Ford Cars & Trucks
May 15, 2014 | 2004 Ford Taurus
Dec 18, 2010 | 2001 Ford Taurus
Nov 18, 2010 | 2004 Ford Taurus
Jul 22, 2010 | 2004 Ford Taurus
Jul 28, 2008 | 2004 Ford Taurus
Jul 20, 2018 | Ford F-150 Cars & Trucks
179 people viewed this question
Usually answered in minutes!