Question about Cars & Trucks

Open Question

1991 chevy silverado bogs down in high rpms

If i cover intake with a rag it will go into high rpms

Posted by Anonymous on


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: 1993 chevy S10 blazer 4.3 vortec

Had a similar probelm, cleaned the EGR valve and problem went away.

Posted on Dec 16, 2008

  • 82 Answers

SOURCE: engine bogs down at 3500 rpms and low trac and or abs light comes on

You are spinning your tires ... read your manual ... shut off the traction control .... spin away!

Posted on Apr 30, 2009

  • 23 Answers

SOURCE: We have a 1990 Chevy Silverado that after it runs

Have you done a basic tune up? There is also the possibility of a fuel pump that is getting bad, when cold it functions after warm..not so good. It's in the tank of course. Ignition module could also be the culprit. This is the begging stuff.

Posted on Oct 10, 2009

  • 1752 Answers

SOURCE: my integra bogs down at higher rpms

First run a tank of a strong fuel system cleaner like BG-44K. If that doesn't help, clean the throttle body. If that doesn't help, take it to a mechanic.

Posted on Nov 03, 2009

  • 1 Answer

SOURCE: Duramax Shuts off at 1000 rpms

I had tha same problem it was the high pres. fuil pump. mine was 2000 rpms and 25 to 30 mile an hr was all i could get out of mine. hope this help you out.

Posted on Sep 24, 2011

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

My 06 chevy silverado was stuck in a puddle and

Thats a mighty deep puddle to get water in the fuse box,,,, sounds like you go water in the air intake and bent some valves or push rods,,,

Sep 25, 2014 | 2006 Chevrolet Silverado

1 Answer

How to remove the flex/torque converter inspection cover on a 1991 chevy Silverado 1500 4x4 8 cyl auto

If you are asking about the tin half round guard on the bottom of the flywheel or torque converter there should just be two sheet metal screws, one on each side and it will drop down.

Oct 18, 2013 | 2002 Chevrolet Silverado 1500HD

1 Answer

2000 chevy silverado starts then stalls out

Check the throttle body for heavy carbon build-up. Remove the air intake(plastic big tube going to the front top of the engine by loosening the big clamp with a screw driver). Gently open the throttle blade and look for heavy black sooty looking deposits. Using throttle plate cleaner from the parts store spray it down and then use a rag to scrub it out, rinsing with the throttle plate cleaner till its all gone. This is a common issue with these trucks, and alot of other vehicles also.

Jan 31, 2013 | 2000 Chevrolet Silverado

2 Answers

I have a 2000 blazer that bogs down at high rpms what could the problem be?

if it is driveable, but seems to cut out, and bog down at sporatic times, and speeds then odds are it's the distributor. (the electical flow is intermittent when it should be constant) if it only happens at higher rpm then it could be the cam position or crank position sensor

Aug 26, 2012 | 2000 Chevrolet Blazer

1 Answer

1993 Chevy Silverado PU 1500, backfire, sputter, die

they might have not put the proper gap on the plugs..and might have over filled the engine with too much oil..

Apr 01, 2010 | 1993 Chevrolet K1500

1 Answer

Oil leaking on my mufflers of my 85 c10 chevy silverado. and i already changed the oil pan gasket

it could be a few things oil sending unit /intake gasket/valve cover gasket/ rear oil seal /I would wash the engine and look starting from top down

Mar 30, 2010 | 1983 Chevrolet Silverado

2 Answers

Duramax Shuts off at 1000 rpms

I had tha same problem it was the high pres. fuil pump. mine was 2000 rpms and 25 to 30 mile an hr was all i could get out of mine. hope this help you out.

Apr 20, 2009 | 2005 Chevrolet Silverado 2500HD 2WD

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

13 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts


Level 3 Expert

80417 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

john h

Level 3 Expert

15314 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides