Question about Peugeot 807

Open Question

How do I turn off the sensor noise activation on my peugeot 807?

The handbrake sensor keeps coming on and I wish to silence the warning. N.B. The handbrake and tyre pressure is OK

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
Jay_from_Ma
  • 99 Answers

SOURCE: I have a CLK200 Convertable with tyre pressure warning on

The light is coming on because ither your tires need to be checked for an under inflated tire, or your pressure sensor inside your tire is bad. Any major tire shop should have a reader to tell if you have a faulty sensor. Your tire pressure that the factory reccomends should be located on your driver's door or door frame on a sticker tag.

Posted on Dec 14, 2008

Ad
alicantecoli
  • 22219 Answers

SOURCE: Tyre pressure sensor

its a renault ,what else do you expect ??renault electrics are a dealewr only job encrypted software

Posted on Jan 23, 2009

AnIdea
  • 33 Answers

SOURCE: run flat tyre warning light is on i have checked tyre pressure

This will only come on when a tyre has dropped in pressure (not spare). It work on the principle that a tyre with less air has a smaller rolling circumference and therefore a different wheel speed. This is then monitored against other signals from other wheels and determined that a loss in pressure has occured.

If all tyre pressures seem ok, there could be a chance of a small unoticeable leak and would require a bath test. This is when the tyre is dipped in water and bubbles would appear where the puncture is.

Ultimately the system may just need to be reset, or has incorrectly been reset from a tyre change. For this you just press and hold the TPC button (located on the centre console above the gearstick - looks like a flat tyre with an exclamation) turn on the ignition to position 2 and the light will come on re then yellow,go out, come back on yellow. When it comes back on yellow it re-initializing the system. You can let go of the button and after 20 odd seconds the light will go out for the final time, completing the reset.

If the light continues to come on after the reset then you definitely have a puncture somewhere!

Hope this helps!

Posted on May 28, 2009

dmsr63
  • 2050 Answers

SOURCE: handbrake warnjng light comes on when driving

Sounds like the switch located on the hand brake arm that turns the "light" on out of adjustment, or as some do...it is failing. The switches are normally cheap.

Posted on Sep 17, 2009

  • 510 Answers

SOURCE: how do i reset flat tyre warning light

To reset tyre warning
switch ignition on,press reset near gearlever
Don,t think connected

Posted on Feb 13, 2010

Testimonial: "thanks very easy"

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to remove seats from a Peugeot 807


fronts are bolted in ,move seat back and forewards to gain access ,rear seats should lift out to turn into a van,,, think you lower back tilt seat then pull a lever or a strap ,my galaxy comes out easy but getting them back in ,,,,so heavy

Dec 01, 2015 | 2005 Peugeot 807 2.0

1 Answer

I need a fuse diagram 2007 peugeot 807


google " fuse diagram 2007 peugeot 807" and it comes up

Dec 04, 2014 | Peugeot Cars & Trucks

2 Answers

My red handbrake symbol keeps flashing what does this mean please


The handbrake light is usually not the handbrake light, it is a warning light for the whole braking system. You could have a problem with the abs system, low brake fluid in the master cylinder or brake pads worn down.
The brake fluid reservoir is easy to check, just lift up the hood and it should be right there mounted on top of the brake booster, in line where the brake pedal is.
The brake pads on modern vehicles have sensors that warn you when they need replacement, so have them checked.
Finally of course, you could have a loose wire on the handbrake warning switch which is mounted at the base of the handbrake, or if you're very lucky, you might just need to drop the handbrake just a fraction more before you drive off.

Oct 06, 2014 | Cars & Trucks

1 Answer

Whooshing noise and clunking on peugeot 307, abs and brake warning light comes on


The warning light means that there is a pressure differential between the two cylinders of the master cylinder.
----------
TIS2000

Sep 07, 2012 | Peugeot Cars & Trucks

1 Answer

Volkswagon Passat 2005 - driving home from work and the handbrake warning light comes on followed by the annoying alarm. Turn slightly left it stops then the ASB warning light comes on followed by the ESP...


This sometimes is triggered by the MAF(Mass Air Flow Sensor), try cleaning it with the highest percent isoproply alcohal first, do not touch the sensor with anything use a big bag to soak it into, or just replace the sensor.

Mar 29, 2011 | 2005 Volkswagen Passat

1 Answer

Hi, I have a peugeot 807 & shortly after I had the water pump changed the Antipolution warning started cumming up & the motor shakes like its about to jump out of the car,black smoke,higer fuel...


the 807 uses an additional small tank of additive which needs to be checked refilled to basically burn off the carbon build-up in the exhaust chamber this is linked to the filler cap sensor if the ceramic in the exhaust is clogged then damage can result from continuning to drive the car check this site for how it works mine cost 400 euros to sort!! http://www.psa-peugeot-citroen.com/modules/fap/anglais/index.html

Sep 19, 2010 | Peugeot 604 Cars & Trucks

1 Answer

Mazda 6 2001, IBS and handbrake warning lights keeps coming on


Check brake fluid level.  If fluid level is low, it can cause lights to flicker on and off while driving.

Nov 12, 2009 | 2003 Mazda Mazda6

1 Answer

Oil and handbrake lights flashing peugeot 106 s2


Hi, If you solve engine idle speed fault this will stop warning lights.
Oil preasure falls when engine not at norm rpm because oil pump is not turning fast enough.
Put car on diagnostics to check for any fault codes

Aug 04, 2009 | Peugeot 405 Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

350 people viewed this question

Ask a Question

Usually answered in minutes!

Top Peugeot Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

mike hayward

Level 2 Expert

279 Answers

lloyd cole

Level 2 Expert

250 Answers

Are you a Peugeot Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...