Question about 1998 Land Rover Discovery
FUSES ARE OKAY NEED LOCATION OF RELAY
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
This usually is the starter, especially if your truck has had an oil leak going for a while as the oil will run down into the starter and cause it to intermittenly fail. Also check your battery terminals and make sure you have a good connectivity.
Posted on Mar 27, 2009
As a Land Rover Tech I can tell you that it is true that there is no filter on the series2 there is a small screen at the bottom of the pump pickup that acts as a filter,If you feel this is clogged you can remove the pump by pulling up the rear cargo area carpet as recommended above then just use break clean to clean the screen.Make sure you replace the pump gasket as a faulty gasket will cause a check engine light and a little trick I use is to put a small amount of vaseline on the gasket to ease installation.Also a quick note on series 1 filters is that the lines usually cease up causing the connections to break or damage when removing.I highly recommend getting the repair kit available at the dealer or rovers north before attempting to replace the filter .
BUT IN REGULAR 2004 lan-drover discovery there is fuel filter located.
Removing the fuel filter
The fuel filter is located on bulk head, to left hand side of the engine.
1: Start by cleaning the area around the filter head.2: Place a container beneath the fuel filter to catch any spillage.3: Loosen the bleed screw using a 10mm spanner4: Unscrew the drain tap on the bottom of the filter until the fuel starts coming out into your the container.5: Once all the fuel is drained from the filter, unscrew the whole filter assembly.
Fitting the new fuel filter 6: Clean the seal & seating on the new filter.7: Put a small amount of fuel around the rubber seal to lubricate it.8: Screw the new filter onto the filter head and tighten by hand.10: Tighten the bleed screw.11: You can now crank the engine until fuel is drawn through the system and the engine starts.Job done!
This will help. Thanks please keep updated.please do rate the solution positively .thank you for using fixya
Posted on Mar 18, 2010
Tips for a great answer:
Oct 18, 2014 | 1998 Land Rover Discovery
Mar 11, 2014 | 1998 Land Rover Discovery
Feb 27, 2011 | 1998 Land Rover Discovery
Apr 08, 2010 | 2001 Land Rover Discovery Series II
May 03, 2009 | 1998 Land Rover Discovery
Apr 07, 2009 | 2003 Land Rover Discovery
Mar 31, 2009 | 1998 Land Rover Discovery
Mar 19, 2009 | 1997 Land Rover Discovery
Jan 07, 2009 | 1995 Land Rover Discovery
May 01, 2017 | 1998 Land Rover Discovery
166 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: