Question about 2003 Dodge Caravan

1 Answer

Inter tie rode

How to change it

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Dodge Master
  • 1,209 Answers

You will need to remove the rubber accordion dust boot from the end of the rack of the rack&pinion. With the outer tie rod unhooked and removed and the rubber boot out of the way you should be looking at a nut that has a think flat washer bent up around the edges. You will need to get a small chisel and bend the washer back as flat as possible, this will allow you to get on the nut and remove the inner tie rod. Install the new one and make sure you bend up the washer around the new nut, this ensures it will not back out. install new boot and re-install outer tie rod and then it sill need to go to the alignment shop to have the toe set.

Posted on Apr 21, 2013


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Worndering all over road iv replaced stearing box inter tie rod and r,f.wheel bearing alignment 3deg out on camber and caster on one side all is in good shape

check the wheel bearing adjustment again
have a wheel alignment done to correct the camber and castor settings

Oct 28, 2015 | Cars & Trucks

1 Answer

Chevrolet Trailblazer Problems

When does it shake? Low speed, off brake... Bad tires. High speed off brake... Balance tires. High speed on brakes... Rotors. Trucks and AWD can be transfer case, diff, ujoints, out of balance driveshaft and tires. Have your car lifted and walk around it, always check tires, ballpoints, tie rode ends

Nov 20, 2013 | Cars & Trucks

1 Answer

Replace tie rod end

Sounds like good may be able to replace both side tie rods MUST get your alignment set after the installation. Please follow this problem, as steering and control issues will bad:( If questions, get a second opinion, and estimate...

Nov 06, 2013 | Oldsmobile Cars & Trucks

1 Answer

On a 2005 Chevy silverado 1500 how to change inter tie rods

there is a special socket type tool a lot of auto parts store rent them

Sep 30, 2012 | Toyota Camry Cars & Trucks

1 Answer

Tire rod end left sidefrom gearbox is broken how do i dismantel

if its the outer tie rod than loosen the jam nut on the threaded part of the inner tie rod. You will then be able to unthread the outer tie rod from the inner. Count the number of turns and install the new one with the same number of turns.

If its the inner tie rod you will need an inner tie rode remover/installer tool and a torque wrench.

Feb 03, 2012 | 2001 Mercury Sable

1 Answer

Stering goes it oposit of my turn

You need to raise the front tires of the ground and check for loose front end parts. Grab the tires at the 3 and 6 o'clock position and push/pull. If you feel any play you have worn outer tie rods, inner tie rodes, ball joints or wheel bearings ( if there really bad). If you don't feel anything loose check your tire pressure. The tires should be inflated to around 30-35 psi.

Jan 15, 2012 | 2007 Chevrolet Equinox LS New Cars

1 Answer

2000 ford taurus V6 DOHC overheats when a/c is turned on

one fan is tied to the a/c when engine warm and a/c on it will run and the other is tied to the temp sensor if it does not run at anytime fan sensor could be bad if does run and thermostat has not stuck half close your radiator needs roded out (Cleaned)

Aug 17, 2009 | 2000 Ford Taurus

Not finding what you are looking for?
Cars & Trucks Logo

58 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts


Level 3 Expert

76691 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8531 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides