Question about 1990 Nissan 300ZX

1 Answer

Changed injector now car wont turn over - 1990 Nissan 300ZX

Posted by on

  • Dave  C
    Dave C May 11, 2010

    Is it possible, when you took the injector off, that a good amount of gas went into the injector hole? If so, the engine is hydraulically locked. Try pulling the spark plugs and cranking it.


×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

...and then you may need to change the oil, since if a lot of fuel is in the cylinder for a while, it may seep past the rings and into the crankcase/oil thereby contaminating it.

Posted on Apr 13, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2002 mercury grand marquis 4.6l turns over but wont crank up


How about the injector? In the engine junction fuse box the fuse for the injector power is in there make sure its not open

Mar 06, 2012 | 2002 Mercury Grand Marquis

1 Answer

3.8 the car wont start.i checked the fuel rail and theres is fuel,but the injector fuse wos blown.i changed it but still wont start.


I would check to see if you now have power to the fuel injectors. There could be high resistance in the fuel injectors, which may have caused the fuse to blow.

May 08, 2010 | 1996 Chevrolet Camaro

1 Answer

I HAVE HONDA ACCORD 93 AND IT WONT START , CAN


yes it could be the fule filter . You will need to find out if there is fuel going to the injectors this is easy done by removing the inlet pipe to the injector rail and turning the ignition to postion 2 just before cranck. If there is no sign of fule then it couls be your filter .If there is fuel at the injector rail let me no and i will assits further

Oct 28, 2009 | 1992 Honda Accord

1 Answer

If i turn the ignition on,after about 4 minutes the car wont start and the rev counter starts to jump up and down. if i start the car first the same thing happens and it stalls after about 4 minutes.


check to see that all your injectors are working, if so then change your fuel filter and if problem still opersists use some fuel injector cleaner

Oct 05, 2009 | 1992 Toyota MR2

1 Answer

No power to injectors 350 tbi


Check the crank sensor for failure. It is relatively easy to change and it is what tells the computer that the engine is turning over. If there isd no crank signal the computer wont fire the injectors.

Aug 15, 2009 | 1990 Chevrolet C1500

1 Answer

Got a 93 nissan altima 2.4 eng wont turn over


did you hydo lock motor with fuel? or do you mean the engine wont start?

May 24, 2009 | 1993 Nissan Altima

1 Answer

I have a 95 Maxima I changed the fuel injectors and now the car wont start.  so i put the old injectors back and it still wont turn over,  It stay on for about 2 sec can anyone help me


I assume you bled off fuel pressure before you installed the injectors. Try this to pressurize the fuel system. Turn the key to "on" position and wait 5 seconds. AT same time, listen carefully for a buzz sound that means the fuel pump is running to pressurize the system. It will shut off after 5 seconds. Then, turn off the key and wait 30 seconds for the computer power relay to shut off. Then, turn the key to "on" again. Thsi will run the fuel pump for another 5 seconds. Repeat 5 times. Fuel system should be pressurized now.
If it doesn't start now, you may have done something while you were changing the injector. good luck

Jan 09, 2009 | 1987 Ford Tempo

1 Answer

1999 F 250 crank but wont start


look on injector pump make sure there are no loose wires

Dec 09, 2008 | 2000 Ford F250 Super Duty Crew Cabs

1 Answer

Car quit and wont restart


It could be a any or a combination of failing components. If you haven't changed the fule filter recently (say within the past 20,000 miles) I'd change it first. Next. check the fuel pressure at the service port near the injectors to ensure you're getting the right fuel pressure to the injectors.

Aug 11, 2008 | 2000 Toyota Camry

1 Answer

Car wont start


hi its probably dragged sh#t from your tank, is your petrol pump external if so,so is the fuel filter. change it, its easier than trying to flush it. once thats done. foot on excelerator and turn over if problem solved car will start within 20 seconds max. if however its air locked, crack the fuel line open at the injectors and turn over with some one watching for petrol to come through as soon as it does stop and tighten up injectors, car should then start, if it still doesnt start it could be muck actually in your in injectors, they will need taking out and cleaning,,,,but we will get to that if all others fail, please let me know what happens, i hope this helps

Jun 24, 2008 | 1997 BMW 328

Not finding what you are looking for?
1990 Nissan 300ZX Logo

Related Topics:

70 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

60541 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

705 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21927 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...