Question about 2007 Mazda B Series

Open Question

My 2008 double cab 2.5 is going through injectors like crazy, also now refuses to start on the key but will pull start

Had new injectors fitted, then drove 1800 miles. Now being told that i need new injectors again. Original dealer is no longer trading so i can't nor would i want them to touch the car again. Being told that i need injectos & fuel pump this time. Car refuses to start using the key but will start if towed, but then cuts out after about 30 mins driving, then needs tow starting again.

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
WildBill49
  • 97 Answers

SOURCE: total shut down. Will not start. Blown computer.

Hi Candy!

I have never personally seen the scenario you have described, but it would take severe overcharging OR a very strong voltage spike to blow your computer, so they are on the right track...

As far as the money goes, you should only have had to pay for the first replacement if the work was done by a reputable shop... Did the first repair not come with some sort of warranty? I would strongly suggest that the Ford shop that gave up be asked to either cover the subsequent repairs OR refund what you spent on their NON-repair. You might need to be a little tenacious in your approach on this, and if you are denied at one level, ask to speak to their superiors. If you are persistent, calm, and reasonable, I'm sure you will receive some type of accomodation!

Sorry for your troubles, but hang tough... I'll send a copy of your complaint and my answer to New Bern Mazda for you, and also to Mazda USA. And please don't forget to rate my support: Your rating is my ONLY compensation for providing this assistance!

Thanks!
WildBill

Posted on Jul 13, 2008

Ad

SOURCE: Car wont start

could possibly be a flat battery possible could be the starter motor also when you unlock the car with the key the immobilizer should of disarm

Posted on Jan 27, 2009

  • 1 Answer

SOURCE: Need to tow 04 mazda rx 8

Top left and right corners of the front grill pull away to reveal the fixing holes. Make sure you WD40 the threads as Mazda coat the threads with paint. insert towing eyes and turn slowly unscrew and screw a bit at a time as you have a good chance of cross threading if you don't. Keep lubricating as you go. Make sure you take the plastic inserts off completely before towing as you will loose them when towing. replace when completed towing. Good luck and hope what ever the reason for towing it is not serious.

Posted on Mar 08, 2009

landsend
  • 1066 Answers

SOURCE: I own a Mazda 2003 Tribute LX V6 3.0L. The other

check your engine and battery ground wires and the fuze links.

Posted on Mar 09, 2009

  • 31 Answers

SOURCE: Hi. My mom just got a 2008 Mazda 5. On the way

This model uses an engine immobilizer as part of the anti-theft. You could leave the wrong key in the ignition for days, with no success. The key has an electronic resistor built into it that the car's ignition will read. Even if the key is cut correctly, if the chip inside doesn't transmit the right signal, the car will not, under any condition, start............

GM's PASS-KEY System, such as those used on a Chevrolet, allows for any key that was cut to fit the ignition, but did not transmit the right code, to start the car after 17 minutes delay. The idea was that a thief would not want to wait around very long. Your mom's Mazda is more demanding, and therefore, more secure. Please review section 3, pages 20 through 22 of the owners manual. I've posted the link to a digital copy of it below this message. Do consult with your selling dealer, because this rarely happens on next-to-new cars. They should replace her keys and reprogram the immobilizer for free. It should definitely be covered under warranty, especially since she's only driven it such few times.

Hope this Helps!

Owners Manual Link
http://www.mazdausa.com/MusaWeb/pdf/manuals/2008_Mazda5_OM.pdf

Posted on Jan 06, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Nissan navara 2002 twin cab diesel zd30 malfunction light comes on randomly


NISSAN NAVARA questions and answers

www.roadtestreports.co.uk/vans/nissan/navara/qanda/
Results 1 - 40 of 322 - Ask and answer questions on a variety of NISSAN NAVARAmodels. Help and advice ... Have a Navarra Rally Raid 2004 double cab pick up. ... Navara V6 2011 - loss of power & engine management light on. .... ZD30 I have changed the diesel filters after noticing that it's jerking when I'm on full throttle.

Nissan Patrol GR Y61 ZD30 starting problem - YouTube

? 1:23
https://www.youtube.com/watch?v=JxHKfYDCgFQ
Jan 16, 2013 - Uploaded by sspyropoul
After replacing the diesel filter seals and water trap i had no problem .But you ... They still glow for like 15 ...Missing: twin ‎cab ‎randomly

Nissan D22 Navara receives YD25 2.5-litre diesel

www.themotorreport.com.au/.../nissan-re-power-their-d22-navara-range
Jan 31, 2008 - Nissan's popular Navara D22 workhorse range has been ... On top of the 4x4 DX single cab's equipment, the dual cab ST-R adds .... the yd25 engine have a overheating problem, so how comes nissan is ... I believe it is a ZD30 engine. .... with no problems except a cracked injector line (pretty random fault).

Jan 13, 2016 | Nissan Cars & Trucks

2 Answers

1987 Delta 88. Car stopped running on the freeway. Starts, but runs like the timing is off. It appears injectors are always open. New ignition module, coils and cam sensor. Pulled rail and with key


Are you saying the injectors are getting power from a source other than the key switch ? They should be powered with the key on and the computer provides the ground connection to make them open. I could see one injector sticking open, but not all 6 injectors.

Oct 06, 2014 | 1987 Oldsmobile Delta 88

1 Answer

Starts cold but not when warm


Are you certain that the pump is on when the no start occurs? Do you hear it turn on with key on, not start, when the engine won't fire? It should turn on for 2 seconds to pressurize the line to the injectors. If you could, check fuel pressure when the no start occurs.

If it is the injectors, buy a cheap "noid light" to check the injector circuit. Buy the one that fits your injector harness connectors. You pull off a connector to one injector and put the noid light in the connector. When cranking the engine over the noid light should be blinking-that is the pulse that fires the injectors. The injectors have battery voltage to them any time the key is on. When the ecm momentarily grounds the injector circuit (internally in the ecm), the injector is pulsed. If the noid light does not blink or even light up when cranking, the injector circuit has a problem in the power side or the ground side.

Feb 09, 2014 | 1991 Chevrolet C/K 2500

1 Answer

Hi rpm in Peugeot 206,extreme smoking from exhaust, car refuses to move in drive,started when going up hill,struggles in reverse,milky oil residue in coolant container.Was advised to change the engine,did...


two things one is failed O2 sensor .the other is your exhaust has a blockage inside it.but your hand over the tail pipe can your feel pressure .if yes .change the O 2 sensor.but you can try a fuel system cleaner in your fuel tank .get one that cleans the O 2 sensor.

Dec 07, 2013 | Cars & Trucks

1 Answer

Car wouldn't start .told crankshaft sensor faulty / replaced but still not start & smells as if flood cab


Before you go for anything, try the following: 1) check if there is any spark goes from distributor or coil to leads .
2) check if your car fitted with injection system,if the injectors are spraying correct or are not. If not means that too much fuel in the combustion chamber and kill the spark.
3)remove the spark plugs - after you start for couple of times - if are dry or wet. if are wet probably you have problem with the injector or spark lead,coil or distributor.
4) blocked catalytic converter.
5) ECU ( Electronic Control Unit.) faulty.

Jan 02, 2013 | Cars & Trucks

2 Answers

2000 ford super duty 7.3 diesel will not cold start


you need to have the engine coolant switch checked,since the computer relies solely on sensors,the ect tells the computer how cold or hot it is so the computer will make it a rich or lean mixture to start the engine,if it tells the computer that it is 75 degrees the computer will lean the mixture like starting a car in the winter without a choke.

Jan 06, 2010 | 2000 Ford F350 Super Duty Super Cab

1 Answer

92 Jeep Wrangler that won't start


The timing belt might have slipped if it did you could crank until the cows come home and it wont start, thats the first place I would look,since yo have fuel and spark.

Mar 17, 2009 | 1992 Jeep Wrangler

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

27 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...