Question about 2006 Jeep Wrangler

1 Answer

Timing Belt When do you change timing belt on 99 Wrangler. and is it easy to do myself?

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Sergeant:

    An expert that hasĀ over 500 points.

    Champion:

    An expert who has answered 200 questions.

  • Expert
  • 289 Answers

Hi..We can't do of our own.It can be changed only
by the mechanic.
try it out..
thank u..
rate me..

Posted on Mar 12, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Change timing belt


timing belt? on a Jeep? 05 wrangler
what engine is this>?
ah the 2.4L
front cover
  1. Before servicing the vehicle, refer to the Precautions section.
  2. Remove the crankshaft vibration damper.
  3. Remove the generator drive belt tensioner assembly.
  4. Remove the timing belt front cover bolts, and remove the covers.


rear cover
  1. Before servicing the vehicle, refer to the Precautions section.
  2. Remove the front covers.
  3. Remove the timing belt.
  4. Hold the camshaft sprocket with Special Tool 6847, or equivalent, while removing the center bolt.
  5. Remove the timing belt idler pulley.
  6. Remove the rear cover fasteners and remove the cover from engine.

Apr 04, 2014 | 2005 Jeep Wrangler

1 Answer

Timing adjustment, 99 Lexus RX300


There is no adjustment on it,Because of having a timeing belt.If the timeing is off the belt has probaly slip.You will have to have a new timeing belt installed.

Oct 20, 2012 | Cars & Trucks

1 Answer

Where can i get a timing belt diagram for a 99 volkswagon beetle 1.8l turbo?


pretty good utube video for the procedure, type in 1999 vw timing belt

May 21, 2012 | Cars & Trucks

1 Answer

99 amigo Timing???????


you should not change the belt maybe now its not in the same position and that's a big problem

Mar 13, 2012 | 1998 Isuzu Amigo

1 Answer

Cost for timing belt replacement, 1991 wrangler


The belt cost about $35 at Autozone, and it depends on the garage on cost, I would say no more then $50 to do this.

As a side note it takes about 10 min or less to change this belt with a simple hand tools, however replacing the belt tensioner is recommended if worn out, as this will eat your new belt.

Hope this helps.

Dec 29, 2010 | 1991 Jeep Wrangler

1 Answer

At what mileage do you change a timing belt in a 2007 sonata, 99% of mileage is highway.


Most car manufacturers recommend replacing timing belts after 60,000 miles. I have seen cars go 200,000 on a timing belt. But I wouldn't recommend that. Personally, that Max I would go, even if 99% of your driving is highway, is 80,000 miles. I'm not 100% sure about the sonata, but if it is front wheel drive and your replacing the timing belt, think about replacing the water pump at the same time. That is always good practice to remember.

Jun 17, 2009 | 2006 Hyundai Sonata

1 Answer

Question about timing belt


the factory wants the belt changed at 90,000 miles, u are living on borrowed time, if the belt breaks it can damage the crankshaft position sensor and that is more money, $500.00 is a little high shop around some more for a better prive $400 is reasonable, it is a gravy job as we say..

May 30, 2009 | 1999 Toyota RAV4

3 Answers

I have changed the timing belt on a 99 Dodge Stratus with a 2.4 liter engine. All timing marks are aligned properly according to Haynes diagram and the engine will still not start. It tries to start


check your distributor position,double
check all marks again,make sure when u line up
the crank marks at #1 cyl. at compression and cam shaft marks!!

G

May 28, 2009 | 2001 Dodge Stratus

3 Answers

How Do I Change the Timing Belt on my 2004 Accent?


The timing belt is inside the valve cover. You have to remove the the valve cover gasket. Underneath that you will find the valves, the head (the top of the engine block). There is a pulley that is used to tighten the timing belt. The pulley is attached to the piston and valve timing. This pulley is usually marked as to where it should be positioned in relationship the timing of the pistons and the cam shaft rotation. This is what is referred to as stting the timing in the engine, and the timing of the distributor. Since your belt is broken the engine has lost track of its timing, so you might have to refer to a manual on your model of car to set the timing. You will also need to replace the valve cover gasket when you put the valve cover back on.

Dec 18, 2008 | Hyundai Motor 2004 Accent

1 Answer

Timing Belt 2003 Volkswagon Passat V6 30V


i would like to advice you not to do this job, the person who is doing this work must have more knowlage about mechanical mainy must know how is the timing belt fitted,
timing belt is not like altaranator belt.
find a good mechanic,
if you are intersting to do like this job easy go technical schools, .

Sep 11, 2008 | 2003 Volkswagen Passat

Not finding what you are looking for?
2006 Jeep Wrangler Logo

Related Topics:

53 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

61037 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...