Question about 2005 Toyota Camry XLE

Open Question

Where can i found a picture of the speed sensor

Vehicle speed sensor malfunction the engine is alarm and the watch of speed doesn't work

Posted by Anonymous on

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

ZJLimited
  • 17970 Answers

SOURCE: need to know where the vehicle speed sensor is

For the 1997 Toyota Camry 3.0L EFI DOHC 6cyl the Vehicle Speed Sensor located mounted on transmission.

Check this pic as reference...

fab686f.gif

Hope this help (remem,ber rated this post).

Posted on May 07, 2010

ginko
  • 19396 Answers

SOURCE: I have a 1998 toyota

Hi.

In ordinary conditions the engine replacement should not result in VSS error. TI could not find any bulletin about ECM (the car main computer) reprogramming after engine swap but the VSS signal passes through two modules, the ABS and the ECM. If you have replaced the engine you may need to re-flash or re-program the ECM . There are a couple of forums where users complain about the same problem.The job can be done at the dealer place.

Before reprogramming the ECM do the regular troubleshooting for P0500. The problem could have been already there before the engine swap, the VSS or the VSS wiring may also have been damaged in engine replacement operations. Check the VSS mounted on transmission, Ohms are between 500 and 700, check also volt output on bridge. Check VSS wiring to ABS module and ECU and check the two-wire connector to VSS (check volts) . Check ECU connector. Check PNP switch.

Regards.

Ginko

Posted on Sep 11, 2011

  • 3 Answers

SOURCE: How can I reset my alarm on my 2003 Camry so it doesn't sound off when experiencing the slightest vibration from other vehicles.

lower the shock sensor

Posted on Jan 20, 2012

ericallen26
  • 660 Answers

SOURCE: picture of 1997 corolla vehicle speed sensor

here ya go. look on bottom12_11_2012_8_52_50_am.jpg

Posted on Dec 11, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

P0501 code?


P0501 - Vehicle Speed Sensor (G22): Implausible Signal Possible Causes
  • Wiring/Connectors from/to Vehicle Speed Sensor (G22) faulty
  • Wiring/Connectors from Transmission Control Module (J217) to Engine Control Module faulty
  • Vehicle Speed Sensor (G22) faulty
  • Malfunctioning Left Front wheel speed sensor (in vehicles that don't use a physical G22 sensor)
Possible Solutions
  • Check Wiring/Connectors from/to Vehicle Speed Sensor (G22)
  • Check Wiring/Connectors from Transmission Control Module (J217) to Engine Control Module
  • Check Vehicle Speed Sensor (G22)
  • Check ABS Brakes for faults and diagnose malfunctioning Left Front wheel speed sensor if applicable

Category:

Mar 10, 2016 | 1996 Audi A4

1 Answer

Code P0500 Speedometer doesn't work on my Toyota Tundra


Hi Coritter, Depending on the year of manufacture of your vehicle, the speed control could be related to the ABS pickup sensors mounted on the wheels. Modern vehicles manufactures tend to double up on functions and therefore a fault seemingly unrelated can be. Have a full scan carried out. If you drive a manual shift you could be lucky, because on an auto box the same speed sensors control the gear change. Regards John

Sep 09, 2012 | Cars & Trucks

1 Answer

2002 merc villager speedometer doesn't work, tach OK


The speedometer is electronic and controlled by a micro processor, the needle is operated by a special DC electric motor called a "stepper" motor, this little motor can cause this problem as well as the Vehicle speed sensor on the transmission (see photo below), either part can cause the problem, the cruise not working would lead me to believe the speed sensor is defective, but you should have a Check Engine light on and a fault code for the sensor, do you have either? Autozone and others do the fault code test for free, ask for an OBD2 fault test. Here is the picture of the sensor I mentioned.
1_29_2012_1_11_57_am.jpg

Jan 29, 2012 | 2002 Mercury Villager

1 Answer

The speedometer cable on 1994 toyota t100 is not working. can this cause check engine light to come on


This vehicle is equipped with speed sensors instead of a cable. If your speed sensor is faulty it will cause the speedometer to malfunction, and the "check engine indicator" to light up. I would still recommend having the vehicle's computer scanned for the error code stored, signaling the check engine light.

Sep 07, 2011 | 1994 Toyota T100

2 Answers

1997 miata check engine code Speed Sensor A Po500


Check your wire harness and replace the speed sensor, then clear the code....that should remedy the problem on the 97 Miata.

Aug 20, 2011 | 1997 Mazda MX-5 Miata

2 Answers

ABS and Brake lights are on, Speed Odom not working, changed speed Odom sensor on trans, still didn't work, HELP


there is a ABS sensor on the rear differential that also works as a vehicle speed sensor. most likely tkis sensor is causing your concern.

Jul 14, 2011 | 1998 Dodge Durango

1 Answer

My speedometer doesn't work except every now and


Some times it may happen due to malfunctioning of VSS. You can get further details about vehicle speed sensor at http://www.wholesalesensors.com/

Jun 17, 2011 | 1989 Chevrolet K1500

1 Answer

Code u1120 and code 0501


U1120 means the PCM doesn't receive a vehicle speed signal from the Anti-lock brake Module over the CAN C bus. This can be caused by the ABS module, PCM or something wrong with the can bus. This might be just an erroneous code and may never set again

Code P0501 Vehicle Speed Sensor Range/Performance
What does that mean? Basically this means that the vehicle's speed as read by the Vehicle Speed Sensor (VSS) is not working properly.
Potential Symptoms This code is different from the P0500 code in the fact that it may not trigger the malfunction indicator light (MIL). Potential symptoms are basically the same as the P0500 VSS code:

  • loss of anti-lock brakes
  • the "anti-lock" or "brake" warning lamps on the dash may be lit
  • the speedometer or odometer may not work properly (or at all)
  • your vehicle's RPM limiter may be decreased
  • the shifting of an automatic transmission may become erratic
  • other symptoms may also be present
Causes A P0501 DTC trouble code may be caused by one or more of the following:
  • The Vehicle Speed Sensor (VSS) is not reading (functioning) properly
  • There is a broken/frayed wire leading to the vehicle speed sensor
  • The vehicle's PCM is not correctly configured for the actual tire size on the vehicle
Possible Solutions The simplest thing to do is to reset the code and see if it comes back.
Next, check all wiring and connectors that lead to the speed sensor. The location of the sensor depends on your vehicle. The sensor could be on the rear axle, transmission, or perhaps the wheel hub (brake) assembly.
If the wiring and connectors are OK, then check the voltage at the speed sensor. Again, the exact procedure will depend on your make and model of vehicle.
If everything looks OK, replace the sensor.

In case of a problem or clarification or my solution was insufficient, don't hesitate to post me a reply.

If you are satisfied, rate my solution with the "thumbs" or (even better) add a testimonial.

Jun 10, 2011 | 2005 Dodge Dakota

7 Answers

I have 05 volvo vnl 670, isx cummins 450/500. keeps losing power, check engine ECU comes on knowbody seems to know what it is. they just keep replacing sensors.


I have a 2007 Volvo 670. The check vehicle ecu comes on. The fault code is MID 144 PID 191 FMI 5. THe truck won't go pass 1400 rpm, the speedometer doesn't work, the cruise doesn't work, the engine break doesn't work. I have to turn the truck off going down the road at highway speed for about 10 seconds and it'll go back to normal. Can anybody help?

Feb 16, 2010 | 2005 Volvo XC90

Not finding what you are looking for?
2005 Toyota Camry XLE Logo

Related Topics:

267 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

75051 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7726 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...