Question about 2005 Chevrolet Silverado 1500HD

Open Question

2005 chevy silverado spare tire hoist assembly

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
smartr10U
  • 1305 Answers

SOURCE: Replacing Chevy Trailblazer Spare tire mount/hoist.

Check out item 330335042615 on Ebay...
it''s the whole jack, handle etc... 50 bucks!
Tah dah!

Posted on Jun 09, 2009

Ad
  • 1 Answer

SOURCE: spare tire won't release.

This is the worst GM engineering i have ever seen !!!! The secondary locking mech. rust itself in the locked position on will NOT allow the tire to lower. After lowering the tire down approx. 2-4" the saftey lock is still engaged. I was able to reach above the tire and remove the bolt holding the hoist in place. {15 mm wrench}. Keep a floor jack under the tire to support it and as not to fall on your head. After removing the bolt the hoist is hooked on the frame member and must be lifted off to remove. Once you get it on the garage floor it is possible to disengage the locking mech. with a few tools and a big hammer. Good luck This should be a Recall

Posted on Nov 29, 2009

  • 12173 Answers

SOURCE: 2005 CHEV SILVERADO SPARE TIRE HOIST JAMMED.

put weight on it or have someone pull down while turning release need tension so cable can come down

Posted on Jan 25, 2010

  • 447 Answers

SOURCE: removing the spare tire from a 2005 Chev Silverado

These can be very difficult to deal with. What I've found is that the safety catch gets filled with grit and won't release properly. We usually support the tire with blocks so the weight of the tire is not on the cable and then you can, sometimes, reach up and work the safety catch enough to get it to disengage...But I have seen them so stuck that we've had to cut the secondary lock off which means you have to replace it if you want your spare back under the chassis again. I see the most problems with these in gravel and dirt road areas or areas that use lots of salt and sand in the winter.

Posted on Jun 01, 2010

  • 4340 Answers

SOURCE: How do you remove the spare tire on a Chevy 2005

There is a place at the rear, into which you put the jack handle, then turn counter clockwise and a cable releases the tire.

Posted on Aug 22, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Spare tire won't lower on 2005 chev silverado


you can try pulling on tire while turning crank handle. if cable is bound up in wench assembly you may have to hold the spare up and cut the cable then replace the wench

Jul 26, 2011 | 2005 Chevrolet Silverado

1 Answer

How do you remove the spare tire on a Chevy 2005 Silverado Truck?


There is a place at the rear, into which you put the jack handle, then turn counter clockwise and a cable releases the tire.

Aug 22, 2010 | 2005 Chevrolet Silverado

2 Answers

2005 CHEV SILVERADO SPARE TIRE HOIST JAMMED.


put weight on it or have someone pull down while turning release need tension so cable can come down

Jan 25, 2010 | 2002 Chevrolet TrailBlazer

1 Answer

The cable for the spare tire on my 2006 1500 works fine (it's all the way down) but the retainer did not lower at all so I cannot pick up the spare tire. Can anyone help? Thanks


  1. Rotate the hoist shaft counterclockwise until approximately 15 cm (6 in) of cable (1) is exposed.
  2. While holding the latch pin (3), fully depress the latch button (2) and release the secondary latch from the hoist assembly. Some side-to-side and/or up-and-down movement may be necessary to disengage the latch mechanism.
  3. Continue rotating the hoist shaft counterclockwise in order to lower the hoist the rest of the way.
  4. If this does not release the secondary latch, the spare tire hoist will need to be replaced. See the following procedure.
Important: If the spare tire hoist has been fully raised without a spare tire in place, the secondary latch mechanism may have become engaged. If this has occurred the hoist will not lower and the following steps will need to be followed:

Nov 01, 2009 | 2005 Chevrolet Silverado

1 Answer

Can't release spare tire retainer


push the tire up with you knee and move the hang down rod over so the tire can drop.It can be a little hard.

Jul 24, 2009 | 2005 Chevrolet Silverado

3 Answers

Spare tire won't release.


This is the worst GM engineering i have ever seen !!!! The secondary locking mech. rust itself in the locked position on will NOT allow the tire to lower. After lowering the tire down approx. 2-4" the saftey lock is still engaged. I was able to reach above the tire and remove the bolt holding the hoist in place. {15 mm wrench}. Keep a floor jack under the tire to support it and as not to fall on your head. After removing the bolt the hoist is hooked on the frame member and must be lifted off to remove. Once you get it on the garage floor it is possible to disengage the locking mech. with a few tools and a big hammer. Good luck This should be a Recall

May 20, 2009 | 2005 Chevrolet Silverado

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

146 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76132 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...