Question about 2000 Ford Focus

Open Question

Diagram for throttle position sensor for 2000 ford focus

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

ZJLimited
  • 17970 Answers

SOURCE: how to change a throttle position sensor on a 94

How to Replace a Throttle Position Sensor
(DIY & Save up to $135.75 ) - Time: 2.1 hours

Parts:
1. Throttle Position Sensor - $ 55.44

Tools:
1. Scan Tool
2. Screwdriver
3. Multimeter

Procedure:
1. Locate the OBD data link connector (DLC). Refer to your owner’s manual for the specific location.

  • Tip: The OBD-I data link connector is usually located in the engine compartment near the battery or the fuse box. The OBD-II connector (post 1995 cars) is usually located beneath the instument panel next to the steering column.
2. Turn your key to the“ON” position. Do not start the engine.

3. Plug your scan tool into the OBD data link connector. Turn on the scan tool and select the appropriate steps to read the diagnostic trouble code (DTC).

    6db8845.jpg

Scanner plugged into OBD-II data link connector.
  • Tip: The OBD-II diagnostic trouble code (DTC) is a 5 character alphanumeric code. The first digit is a letter that indicates the component group, the second digit is OBD mandated or manufacturer specfic, the third digit is a subgroup, and the fourth and fifth digits define the component and basic problem.
  • 4. Locate the throttle position sensor.
6182d26.jpg

  • Throttle position sensor

  • 5. Disconnect the electrical connector from the throttle position sensor.
fc565b1.jpg

  • Electrical connector removed
6. Test the resistance of the throttle position sensor (TPS) with a digital multi-meter. If the resistance is out of specifications, the TPS must be replaced.
  • 7. Remove the throttle position sensor.

  • d3a8007.jpg

    Removing sensor mounting screws

    8. Install the new throttle position sensor. Tighten the mounting screws and attach the electrical connector.
  • 9. Erase the diagnostic trouble code (DTC) with the scan tool using the“delete” or“erase” command. Road test your vehicle to see if the check engine light returns.
fde01cf.jpg

    Check engine light

  • Tip: If the check engine light returns, repeat the diagnostic process for additional DTCs or take your vehicle to a certified repair shop.
Direct OE replacement

Hope helped with this. Good luck (remember rated this help).

Posted on Nov 05, 2009

  • 85 Answers

SOURCE: Where is the camshaft position sensor on a 2000 Ford Explorer?

in the rear like where the dist would normaly be

Posted on Dec 31, 2009

c17hydro
  • 2984 Answers

SOURCE: where is the throttle positioning sensor located

Please don't forget to rate!



b487a12.gif
Disconnect and remove the TP sensor from beneath the throttle body


1d94cbf.gif
View of the throttle position sensor mounting-4.9L, 5.0L and 5.8L MFI engines shown, others similar



76a43b3.gif

Exploded view of the throttle body mounting-5.0L and 5.8L engines

Posted on Mar 06, 2010

  • 645 Answers

SOURCE: my 2000 ford focus se read p1120. already replaced

does your engine idle fast or slow? You may need to clean the idle selonoid or the throttle body. They carbon up and stick.

Posted on May 22, 2010

  • 1 Answer

SOURCE: 95 f250 7.3 is throttle position sensor on the pedal

i have a f350 ps and it starts and idles but i have no throttle nothing happens when i push the pedal and the check engine light comes on

Posted on Sep 30, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 2003 Ford Focus would not accelerate, and kept dying on me, now wont start, do you know what could be wrong?


A strong possibility of a defective Throttle Positioning Sensor (TPS)...It can be tested with a volt meter...TPS is located on the throttle body (see diagram below) & has a three pin connector with following wire colors; Brown (ground)...Yellow (+5 volts)...And White (TPS output)...Set meter to 5 volt dc...Push point,of safety pins into the Yellow and Brown wire at rear of connector...Do not disconnect connector...connect + lead to Yellow pin and - lead to Brown pin...Turn key on...Meter must read at least .08 volts...Open throttle full...Meter must read at least 4 volts...If not TPS is defective...Send results...NOTE>>>Diagram is based on a 2.0L Single Overhead Cam Engine, if your vehicle is different let me know...saailer




c39c38e9-1e2b-4d1e-b695-576183306462.jpgCost about $30

Jun 25, 2014 | 2003 Ford Focus

1 Answer

What does a throttle positioning censor for an 05 ford focus look like


I suggest you google 05 ford focus throttle positioning sensor. This sensor keeps you air intake throttle at the proper position when the engine is cold and changes position when the engine has warmed up. to locate the sensor, remove the hose that comes from the air filter housing to the engine. the hose you removed was connected to the air throttle. you can manipulate the position of this throttle by having someone push the gas pedal down slowly while you watch the throttle move. notice that the gas pedal cable is connected to the mechanism that opens and closes the air throttloe. also notice that beside this mechanism, you have an electric throttle positioning sensor. Pay close attention to the existing throttle positioning sensor before you remove it if you are planning on replacing this sensor. because if you do not install the new sensor in the same degree that the old one was in, you will throw the calibration off. word of advice. buy some throttle cleaner from your local auto parts. turn the car on with the air filter to throttle body hose off and have someone push the gas pedal down slightly to keep the engine from turning off. spray the throttle body cleaner til all the black crud comes off the inside of the throttle body. this dirty crud is what was making your throttle stick and not working properly.

May 01, 2014 | 2005 Ford Focus

1 Answer

2000 ford focus wagon dieing on slow speed


check throttle position sensor

Mar 10, 2013 | 2003 Ford Focus

2 Answers

My ford focus runs rough , high idle, and want keep running in park


Check pcv hose from intake to pcv valve. Check while running, they will collapse and leak

Apr 20, 2011 | 2000 Ford Focus

1 Answer

Hello, i have a 2000 ford focus with error code: p1120. I cannot locate the throttle position sensor under the hood, would you please help?


the throttle sensor is on the end of the throttle pedal ,and another motor on the inlet manifold where the butterfly is ,now iam not sure here as to what the significance is of sensor A is as to weither its
the engine side or the interior one on the throttle pedal .
P1120 Throttle Position Sensor A Out Of Range Low (Ratch too low)

Jan 29, 2011 | 2000 Ford Focus

1 Answer

My x reg 1.8i ford focus surges when i come to a standstill


Check out the mass air flow sensor. If there is no luck there then go with the throttle position sensor. Good Luck

Apr 04, 2009 | 2000 Ford Focus

1 Answer

How easy is it to fix the throttle position sensor myself?


Yes U can fix it yourself if u have common hand tools.

Dec 16, 2008 | 2000 Ford Focus

2 Answers

2006 Ford Focus 1.6


Check throttle position sensor.

Jul 03, 2008 | 2000 Ford Focus

2 Answers

Ford focus 2000 1:8cc


Throttle position sensor is on the throttle body, on the opposite of the throttle cable.

Jun 26, 2008 | 2000 Ford Focus

Not finding what you are looking for?
2000 Ford Focus Logo

Related Topics:

363 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

fordexpert

Level 3 Expert

5470 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...