Question about 2002 Volvo S40

1 Answer

Rubber Headlight Cover

I lost the black rubber cover that goes behind the bulb in the headlight of my Volvo s40. I need to order a replacement, but I can't figure out what it is called. Thanks!

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Sniper:

    An expert who has posted more than 50 answers, of which 90% or more were rated as helpful.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

  • Expert
  • 76 Answers

Headlamp bulb access cover is a good description. I'd start there.

Posted on Mar 12, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to remove front headlight assembly


Hi,

1 Open the RAV4's hood. Locate the back of the headlight assembly, just behind the headlight. You should see a ring-shaped plastic cover.

  • 2 Turn the locking plastic ring clockwise about 1/2 inch and it should pop off.
  • 3 Remove the rubber grommet covering back of the headlight. Simply pull it out of the headlight assembly.
  • 4 Depress the spring latch holding the bulb in place behind the headlight. This is a wire latch that looks somewhat like a bent paper clip. Press it down and move it to the side, away from the light bulb. It should come free and flip open, freeing the bulb.
  • 5 Disconnect the light bulb from the plug. Replace it with the new light bulb, and replace the latch and rubber grommet. Replace the plastic ring cover and turn your headlights on to ensure proper installation.

  • Thanks

    Aug 07, 2011 | 2003 Toyota RAV4

    1 Answer

    Removing and installing new headlight bulb


    need more information..... 2000 Volvo S40, you gain access from inside the engine compartment and reach in behind the light, remove the spring holding it in place, remove and be careful not to touch the glass on the new bulb. The electrical connector is inside the housing and covered with a rubber plug

    May 26, 2011 | Volvo S60 Cars & Trucks

    1 Answer

    Need to change headlight bulb in gmc envoy 2003


    Drivers side- stick your hand behind the headlight and remove the rubber cover, and twist out the light.

    Passenger side- remove the air cleaner top, and move the air cleaner out of the way. You now have complete access to this side to remove the rubber boot covering the bulb.

    Dec 22, 2010 | 2003 GMC Envoy

    1 Answer

    How do you replace a low beam headlight bulb in a 2006 Chevy Trailblazer?


    Drivers side- reach hand behind headlight and remove the rubber cover, then turn and remove bulb.

    Passenger side- remove air cleaner top and move the air cleaner out of the way. Now you have access to the rubber cover to replace the bulb

    Dec 13, 2010 | 2006 Chevrolet Trailblazer Ext

    1 Answer

    Rubber bulb headlight cover


    Hi,

    The rubber cover protector for the base of the headlight halogen lamp can be ordered to your nearest Toyota dealer.

    The rubber cover protects the headlight's interior from water, moisture, and dirt. The headlight could function without it, but the your headlight will become darker when the dirt will be burn inside.

    Hope that helps you out!

    Thanks for using Fixya as guide to fix your problems!

    Dec 07, 2010 | 1994 Toyota Corolla

    1 Answer

    How to take out and replace headlight bulbson 2002 passat


    here are instructions from autozone.com
    1. Open the hood and if equipped with a rubber access cover, remove the cover over the back of the headlight assembly, and then disconnect the electrical connector from the bulb.
    2. If a rubber seal/cover is mounted around the bulb, disconnect the electrical connector from the bulb, and then remove the rubber seal/cover.
    3. Once the electrical connector has been disconnected, squeeze the ends of the retaining bracket inward, then pivot the retainer away from the rear of the headlight assembly.
    4. Grasp the bulb securely and remove, noting the location of the alignment tabs for installation. Allow the bulb to cool before removing it from the headlight assembly.
    NOTE Do NOT touch the glass portion of the new bulb. This will shorten the life of the bulb.

    3899d95.gif

    Fig. On some models, a rubber cover is removed to access the bulb-1.8L Passat model shown



    c3a2c45.gif


    Fig. Once the cover is removed the wiring can be accessed and disconnected-1.8L Passat model shown



    3737c70.gif


    Fig. The bulb is retained by metal bracket. The ends are squeezed toward one another to release them from their retainers-1.8L Passat shown



    To install:

    NOTE Do NOT touch the glass portion of the new bulb. This will shorten the life of the bulb.

    1. Install the new bulb into the headlight housing and squeeze the ends of the retaining bracket inward while pivoting the retainer toward the rear of the headlight assembly. Release the retaining bracket making sure it is fully seated in its retainer.
    2. The balance of assembly is in reverse order of removal.

    Oct 19, 2010 | 2002 Volkswagen Passat

    1 Answer

    How do you change the low beam headlight, the manual says call a dealer. Come on, for a headlight. Can anyone tell me how to remove everything to do it myself, i have the bulb. candace


    Driverside- Reach behinde the headlight remove the rubber cover twist the bulb out and replace. Not hard just have to be patient and you will see how easy it is. Took me 5 min.

    Pass Side- Ok you would think how to I reach back there? Ok ready>> Take out the three screws that hold on the airbox cover. Take off the airbox cover the whold back of the light is now exposed. Take off the rubber and replace the light or lights. Super simple.

    Aug 05, 2010 | 2005 Chevrolet TrailBlazer

    1 Answer

    Need to change the left side low beam headlight.


    It might be hard to get to like that. You will see a silver metal bar with a 90 degree angle at the top that goes straight down behing the headlight assembly, which you can pull up on. It holds the headlight in. Once you pull this up pust the headlight slightly sideways as there is a plug holding the headlight in at the back, then just pull forward to give youself space to work. Clip off the two clips and slide the back cover off then you can change the bulb out.

    Jul 09, 2010 | 2005 Volvo S40

    2 Answers

    Headlight


    Remove the grill first.. it is on snap locks and will pop out .There are 2 slide up brackets on the left and right top of the plastic headlight cover. slide the 2 brackets up the headlight unit will be unattached except for the light wires holding it in place, just unclip them. pop off the rubber cover for the light you wish to change. Twist bulb 1/2 turn to remove. Use gloves so your hands don't touch to bulb.

    Nov 17, 2008 | 2003 Chevrolet TrailBlazer

    Not finding what you are looking for?
    2002 Volvo S40 Logo

    Related Topics:

    244 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Volvo Experts

    yadayada
    yadayada

    Level 3 Expert

    61249 Answers

    Colin Stickland
    Colin Stickland

    Level 3 Expert

    21949 Answers

    Mark Jones

    Level 2 Expert

    76 Answers

    Are you a Volvo Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides

    Loading...