- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Hi, I know from my past experiances the spark plug wires at the boot ends than slide onto the sparkplugs usually over time short out due to the metal tubes that protect the sparkplugs from heat kind of ark across from the metal tube through the plug boot causing an error code. Sometimes in the dark you can actually see them arking at the tube on the engine, and also hear a crackling noise. As to the code for the O2 sensor that's a normal wear and tear item that may need replaced. As all vehicle age over time electrical connections, and things have issues develop and cause havick with sensors and computers in these vehicles too.
As with the 441 code and then the other code for the O2 sensor showing up may mean both O2 sensors are going bad if your system has 2 sensors in the exhaust, usually one before the cat converter and one behind it. A lot of this also is due to what gasoline you use in the vehicle over time. Lower octane gas may be what is causing things to act up.
These codes are making me lean towards the ignition coil pack.My stepson's 2001 Sable 3.0 v6 had one cylinder misfiring(5-code P0305),which shares a coil with cylinder 1(code P0301).I diagnosed it by trading wire 1 and 5 at the coil,and the code changed to P0301.You have codes for the two cylinders on the same coil,so this is most likely it.(these codes would also trigger P0300(Multiple Misfires Detected) and P0316(Misfire Detected First 1000 Revs)).
PO 134 = 02 SENSOR CIRCUIT NO ACTIVITY DETECTED (BANK 1 SENSOR1)
PO 153 =02 SENSOR CIRCUIT SLOW RESPONSE (BANK 2 SENSOR 1)
PO 154 =02 SENSOR CIRCUIT NO ACTIVITY DETECTED (BANK 2 SENSOR 1)
PO 155= 02 SENSOR HEATER CIRCUIT MALFUNCTION (BANK 2 SENSOR 1)
PO 171= SYSTEM TOO LEAN (BANK 1)
PO 174= SYSTEM TOO LEAN (BANK 2)
I WOULD SAY YOU HAVE FAULTY OXYGEN SENSORS CAUSING THE ENGINE TO RUN TOO LEAN REPLACE THEM AND YOU SHOULD BE BACK IN BUISNESS
Ford Code Entry Instructions
Once the unit has been turned on the display will show ' CODE - - - -'
Press preset [ 1 ] repeatedly for the first digit
Press preset [ 2 ] repeatedly for the second digit
Press preset [ 3 ] repeatedly for the third digit
Press preset [ 4 ] repeatedly for the third digit
To save the code press the [ 5 ] key to accept.
The set should now operate.
EVAP is for Evaporative emissions control system, so no this is not EGR, that is Exhaust Gas Recirculation system, as far as the P1665 goes it is related to the other trouble code P0440, u will need to replace the EVAP system Purge flow control solenoid. This should correct both problems after u replace the part disconnect the battery for 5 min's to reset system.