Question about Cars & Trucks

Open Question

90 hp vro v4 Johnson engine jst re wired new key switch with 6 connections and turned key it gos to start but will not think fuel is nt going through pump ?

Posted by Anonymous on


2 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

  • 1050 Answers

SOURCE: Buick Regal dying

You have a problem in the fuel pump relay circuit for sure then. I'm betting the relay, but it could be that dropping resistor.

Posted on May 11, 2009


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

I was hooking up new battery to my boat. Three wires to pos terminal and four to grnd terminal. I stupidly switched two leads, not the heavy duty starter wires, but maybe a 10 guage pair.

You have done some serious damage with out a doubt. Could have damaged any computer hooked up to ignition system along with alternator, regulator, ad infinitum. Best bet is just go out and get a nice cold beer and refer this to a real pro. Going to cost you so get a case (beer) to be on the safe side.

Sep 16, 2017 | Cars & Trucks

3 Answers

90 lesabre limited Fuel pump fuse blows every time I start the car It's a 20a fuse, I'm not even sure if it's a final pump fuse I can't find any diagrams showing what is what. Right side of dash

20 AMP is a big fuse, I would say its the fuse to the motor check this web site

Apr 04, 2017 | Cars & Trucks

1 Answer

What can cause 1.3rocam nt to start.We jst replaced an engine

no wires connected correctly to the cam/crank position sensors
wires to fuel pump not connected
wires to pressure regulator on manifold not connected
immobilizer not reset in the ECM with a scan tool

Jan 13, 2016 | Cars & Trucks

1 Answer

Wont start nothing happens new battery

1. Make sure your battery is fully charged.
2. Check connections from battery to starter relay.
3. Make sure you have voltage going to the start side (small wire) of the relay with the key in the "start" position.
4. If you don't have voltage going to the start side of the relay (small wire) with key in the start positon, then your starter switch is faulty (under dash usually mounted on top of steering column).
5. If you have voltage to the start side of the relay (small wire) with key in start position, and it don't click when trying to start your car, then the starter relay is bad.
6. If your starter relay clicks, but engine don't turn over, then the starter is faulty.

If you think its the starter switch here is a picture of one uninstalled:
it should be on the upper side of steering column, and you must lower it by removing the mounting bolts that are directly under the column and lowering it down.


Dec 09, 2013 | 1993 Toyota Previa

2 Answers

2003 gmc savanna, wont start, new fuel pump and ignition cylinder, I turned key to on position, let sit for 15 min and still wont start just turns over

Find fuel test valve in fuel rail on top of engine. Take cap off valve. Turn key on. Push down valve with screw driver. fuel should squirt out. If not check fuse fuel pressure relay and bad wires. If fuel does come out, remove a spark plug from engine. Connect plug wire to plug. Ground plug against engine. Crank over engine and look for spark.

Nov 03, 2013 | 2003 GMC Savana

2 Answers

Can the pcm cause the starter not to turn in my 2000 dodge neon?

Is it getting fuel? Check the pressure regulator or the fuel pump. Even if you have the plug wires on wrong it should do something.

Aug 30, 2012 | 2000 Dodge Neon

1 Answer

My car would`nt go pass 40 mph, then i tried to start it the next day and the engine just kept turning

Your fuel pump has failed.
The 40MPH speed limitation was caused by fuel pump under-supplying the engine with fuel.
The no-start condition is the fuel pump failing to supply fuel to the engine at all.
The reason your engine turned was that you have a good battery & good starter. The engine
just wouldn't catch for lack of fuel.
How to check this: attach an ODB-II code reader to the car's computer port and ask the car's
computer what it thinks is wrong with the car.
Theoretically, its possible that 1 or more fuel injectors failed, then they all failed, but the chances
of this scenario are nearly infinitesimal. A wiring harness problem (wiring from the PCM
(the computer) to the fuel injectors) could potentially cause this.... but its the fuel pump.
FIX: replace fuel pump.
How to do this for 4 (and 6) cylinder 2005 Altimas: will require you to register (free) on their site to acces their online repair guide database.

Oct 23, 2010 | 2005 Nissan Altima

1 Answer

1993 Audi 90 not starting

key may need reprogrammed

Jul 21, 2009 | 1995 Audi 90

2 Answers

Acura integra 1990 turns over fine but doesnt start

for you to check if it is the fuel pump, see if there is fuel running out of the hose if you remove the fuel filter. Another is to directly connect the pump to the battery. If the pump works that way, then it could be a efi relay issue which is found underneath the dash or a wiring issue.

Jul 10, 2009 | 1990 Acura Integra Hatchback

2 Answers

'90 civic won't start.....bad disributor????

wont rotate?..go to battery and starter circuitry

Nov 09, 2008 | 1990 Honda Civic

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

16 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts


Level 3 Expert

80339 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

john h

Level 3 Expert

15148 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides