Question about 2005 Lexus Ls 430
Posted by Anonymous on
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: Duration of brake pads? Cost?
pads always depend on the driver. the easier you are on them the longer they will last. the more you ride the brakes the shorter they will last. according to autozone.com front pads will run you about $36 and for the rear pads $30 for some cheapies and $46 for some good ones.
Posted on May 08, 2009
There is a clip that pries up with small flathead screwdriver. The harness and bulb are held in lens with a plastic ring that screws on and off.
Posted on Sep 15, 2009
Testimonial: "good info "
The adjustment screws/nuts should be located either on the top of the headlamp assembly,
behind the headlamp assembly, or near the frame rail by the radiator
You will have vertical adjustment screws for each independent beam (separate highs and separate lows, but will be same screw if highs and lows are the same bulb). You may also have additional horizontal adjustment screws as well
Park your car on a level ground 30 feet from a wall and measure the height from the ground to the bulb and mark on a wall (do this for highs beams and low beams if the bulbs are separate, if highs and lows are the same bulb, only do it for the lows)
For Low Beams: If the headlights read VOR, then aim the brightest part or cutoff part just below the mark on the wall. If it says VOL or nothing, aim them 2 inches below the mark on the wall.
For High Beams (if separate from low beams): Aim the headlight directly at the line you marked on the wall.
Posted on Sep 30, 2009
THEY MAKE THE SYSTEM AND HAVE INSTRUCTIONS YOU CAN DOWNLOAD.
PLEASE NOTE: NOT ALL BRANDS/MODELS OF OPENER WILL WORK WITH THIS SYSTEM.
HOPE THIS HELPS
Posted on May 26, 2010
SOURCE: 2001 lexus ls430: warning
yaw sensor is out of calibration, most likely from hoisting vehicle in air. sensor needs to be calibrated before light will go out. jump pin 3 and 5 of dlc under driver side dash. connect jumper wire with ignition off, turn ignition on, vsc light should flash, let it flash for awhile (10 sec). turn ignition off and disconnect jumper wire.(do this with vehicle station on ground).
Posted on Sep 21, 2010
Tips for a great answer:
Nov 29, 2014 | Lexus Cars & Trucks
Oct 07, 2013 | 2005 Lexus Ls 430
Aug 30, 2012 | 2005 Lexus Ls 430
Mar 05, 2010 | Lexus LS 430 Cars & Trucks
Feb 04, 2010 | 2001 Lexus LS 430
Dec 27, 2009 | 2005 Lexus Ls 430
May 08, 2009 | 2006 Lexus Ls 430
Mar 15, 2009 | 2005 Lexus Ls 430
Jul 22, 2008 | 2002 Lexus LS 430
Sep 22, 2014 | 2005 Lexus Ls 430
19 people viewed this question
Usually answered in minutes!