Question about 1995 Jeep Grand Cherokee

1 Answer

CALABRATION HOW DO I CALABRATE MY OVERHEAD CONSOLE?

Posted by on

  • amktax Mar 16, 2009

    yes but my speedometer is broke also.Is that my problem be cause nothing is working on my overhead console?

  • yadayada
    yadayada May 11, 2010

    calibrate what?

×

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 23 Answers

To calibrate your compass you need to goto an empty parking lot and drive around in circles until it starts displaying the directions

Posted on Mar 13, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Compass not working on 2006 Mercury Grand Marquis


Electronic Compass The compass display and module are contained in the overhead console and are replaced as an assembly. For additional information, refer to Section 501-12 . The compass display can be turned off and on by pressing the MODE button in the overhead console. The vehicle heading is displayed as one of N, NE, E, SE, S, SW, W, or NW.
Inspection and Verification
NOTE: Press the MODE button to turn on the display.
  1. Verify the customer concern by operating the vehicle along roads of known direction to duplicate the customer concern with the compass.
  1. Visually inspect for obvious signs of mechanical or electrical damage.


Visual Inspection Chart Mechanical Electrical
  • Compass module
  • Central junction box (CJB) fuse 15 (7.5A)
  • Circuitry

  1. If an obvious cause for an observed or reported concern is found, correct the cause (if possible) before proceeding to the next step.
  1. If the fault is not visually evident, determine the symptom and GO to Symptom Chart .
Pinpoint Test A: The Compass Is Inaccurate/Inoperative
Normal Operation The compass receives battery voltage from the central junction box (CJB) through circuit 964 (DB/LG). Ground for the compass is supplied through circuit 676 (PK/OG).
    Possible Causes
  • fuse
  • circuit 676 (PK/OG) open
  • circuit 964 (DB/LG) open or short to ground
  • compass zone setting
  • compass calibration
  • compass module
PINPOINT TEST A: THE COMPASS IS INACCURATE/INOPERATIVE NOTE: Always set the zone and calibrate the compass before replacing an inaccurate compass.
NOTE: After installing a new compass, always set the zone and calibrate.
Test Step Result / Action to Take A1 CHECK THE OVERHEAD COMPASS DISPLAY
  • Key in ON position.
  • Check the overhead display.
  • Does the overhead compass display remain on after prove out?
Yes
GO to A3 .

No
GO to A2 . A2 CHECK THE COMPASS MODE
  • Press and release the SELECT switch on the overhead console.
  • Does the overhead compass display turn on?
Yes
If the compass display turns on correctly, GO to A3 . If the compass display turns on, but the heading is inoperative/inaccurate or the display indicates VAR, GO to A4 . If the compass display turns on, but it does not display all directions, or indicates CAL, GO to A5 .

No
GO to A7 . A3 CHECK THE COMPASS DIMMING
  • Turn the headlamp switch to the parking lamps ON position.
  • Does the compass display dim?
Yes
TURN the headlamp switch to the OFF position. GO to A4 .

No
TURN the headlamp switch to the OFF position. GO to A8 . A4 CHECK THE COMPASS ZONE SETTING
  • Set the compass to the correct zone for your location. Refer to Compass Zone Adjustment in this section.
  • Does the zone adjustment set correctly?
Yes
GO to A5 .

No
INSTALL a new overhead console. REFER to Section 501-12 . TEST the system for normal operation. A5 CALIBRATE THE COMPASS
  • Calibrate the compass. Refer to Compass Calibration in this section.
  • Is the compass calibrated correctly?
Yes
GO to A6 .

No
INSTALL a new overhead console. REFER to Section 501-12 . TEST the system for normal operation. A6 CHECK THE COMPASS ACCURACY
  • Position the vehicle at each of the 8 directions (N, NE, E, SE, S, SW, W, NW) and verify that the displayed heading is accurate. The vehicle must be stationary for at least 10 seconds at each direction.
  • Is the compass display accurate in each direction?
Yes
The compass is OK. REVIEW the operation of the compass with the customer.

No
INSTALL a new overhead console. REFER to Section 501-12 . TEST the system for normal operation. A7 CHECK THE VOLTAGE SUPPLY TO THE OVERHEAD CONSOLE
  • Key in OFF position.
  • Disconnect: Overhead Console C930.
  • Key in ON position.
  • Measure the voltage between the overhead console C930-1, circuit 964 (DB/LG), harness side and ground.
  • Is the voltage greater than 10 volts?
Yes
TURN the key to the OFF position. GO to A9 .

No
VERIFY the CJB fuse 15 (7.5A) is OK. If OK, REPAIR the circuit. TEST the system for normal operation. A8 CHECK THE DIMMING CIRCUIT
  • Key in OFF position.
  • Disconnect: Overhead Console C930.
  • Turn the headlamp switch to the parking lamps ON position.
  • Measure the voltage between the overhead console C930-4, circuit 484 (OG/BK), harness side and ground while rotating the instrument panel dimmer switch.
  • Does the voltage vary between 0 and 10 volts?
Yes
GO to A9 .

No
REFER to Section 413-00 for further diagnosis of the instrument cluster and panel illumination. A9 CHECK CIRCUIT 676 (PK/OG) FOR OPEN
  • Measure the resistance between the overhead console C930-2, circuit 676 (PK/OG), harness side and ground.
  • Is the resistance less than 5 ohms?
Yes
INSTALL a new overhead console. REFER to Section 501-12 . TEST the system for normal operation.

No
REPAIR the circuit. TEST the system for normal operation.

Nov 30, 2017 | Mercury Grand Marquis Cars & Trucks

1 Answer

2009 Honda Pilot overhead console removal


If you just want to replace the dome lights the clear buttons on the console can be removed carefully, The buttons will snap out from the console and the bulbs will be underneath.

Jan 30, 2013 | 2009 Honda Pilot EX-L

1 Answer

How do I remove the overhead console in my Ford 1-50 to change a light bulb. I ordered the bulb from the Ford house, but they want a small fortune to replace the bulb


With the overhead console ( non rail system ), open the sun glass bin, and grab each corner in the back, and pull down.

The overhead is held on with 4 or 6 spring clips, and pulls straight down.

The bulbs are 1/4 twist sockets installed from the back of the overhead console.

May 17, 2010 | 2006 Ford F-150

1 Answer

My 2001 Mercury Cougar moonroof is stuck, it opened a few inches then just stopped. Is there a way I can manually close it?


Check fuses #21 40 amp check relay jump 12 volts to motor circuit
Overhead Console Removal
  1. Disconnect the battery ground cable.
  1. NOTE: Remove the interior lamp as a unit.
    Ease out the interior lamp.
    • Disconnect the electrical connectors.
    v4301245.jpg
  1. Remove the overhead console screws.
    v4301246.jpg
  1. Remove the overhead console.
    • Apply an even downwards force to both sides of the console.
    • Disconnect the roof opening panel switch electrical connector (if equipped).
    • Disconnect the information and message center electrical connector (if equipped)
-----------------------------------------------------
SECTION 501-17: Roof Opening Panel 2001 Cougar Workshop Manual REMOVAL AND INSTALLATION Procedure revision date: 02/8/2001
Roof Opening Panel Motor Removal
  1. Remove the overhead console. For additional information, refer to Section 501-12.
  1. Disconnect the sliding roof motor electrical connector.
    v4101317.jpg
  1. Disconnect the sliding roof panel relay.
    v4101318.jpg
  1. Remove the sliding roof motor control unit.
    v4101322.jpg
Installation
  1. To install, reverse the removal procedure.

Oct 30, 2009 | 2001 Mercury Cougar

2 Answers

Overhead console completely dead 2002 jeep grand cherokee laradeo


Check the fuses for the overhead console, could be that if not then the console needs to be replaced.....

May 25, 2009 | 2002 Jeep Grand Cherokee

1 Answer

Overhead console


most new cars/trucks come with all the connectors for all the accessories, cheaper to make just one harness, the part u will need is the sub harness for the overhead console, many times Mopar makes a kit, they did on my truck.

Apr 11, 2009 | 2006 Dodge Durango

1 Answer

CALABRATION


to calibrate the compass goto a parking lot and and drive around in a circle several times until the compass starts working properly again.

Mar 12, 2009 | 2001 Jeep Grand Cherokee

1 Answer

TRANSMISSION


sounds like either a bad speed sensor or controller. shift points are too high, should be at 2000 or slightly less. if fluid is good and clean and shifts do not flair, check those control units. Not sure about calibrate...could mean out of calibration...Id ask
another tech about that. (i don't know everything!)

Mar 12, 2009 | 2001 Jeep Grand Cherokee

1 Answer

Domelight overhead storage rail replacement


  1. Depress the side tabs and remove the overhead storage bin.
  2. Remove the overhead console.
  3. Disconnect the 2 overhead console electrical connectors
  4. Remove the dome lamp assembly.

Jan 31, 2009 | 2006 Ford F-150

1 Answer

2000 ford explorer overhead console temperature and compass ded


The overhead console is quite prone to internal failure. Dim, intermittent, or dead displays are a common symptom of an internal failure. We offer a reasonable repair service with a lifetime guarantee. Check it out: www.autoclockrepair.com

Jan 29, 2009 | 2000 Ford Explorer

Not finding what you are looking for?
1995 Jeep Grand Cherokee Logo

Related Topics:

106 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

77499 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...