Question about 1996 Chrysler Cirrus

1 Answer

Battery light came on, and then turned off car and didn't come back on. Any ideas? Battery replaced 1 year ago.

Posted by on

  • CampinFamily May 11, 2010

    when did the light come on?? when starting or while driving?


1 Answer

  • Level 1:

    An expert who has achieved level 1.


    An expert that hasĀ over 10 points.

    Welcome Back:

    Visited the website for 2 consecutive days.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 7 Answers

Alternator. Check your belt, make sure its tight and still there. Make sure its grounded right and the plug didnt vibrate loose. make sure there is no metal, besides the post clamps, touching your battery also. If this doesnt fix it, take it to auto zone and have them check the alternator.

Posted on Mar 12, 2009

3 Suggested Answers

  • 17 Answers

SOURCE: security system shut down car.ignition was

The security system will not shut down the car while running, if the car shut off while engine was running you may have another problem. Do you have a "chip" or black pellet in your key, if so the wires going to the key cylinder may be broken at the cylinder or the key may be worn if you are having a security problem

Posted on May 23, 2010

  • 111 Answers

SOURCE: 96 Ford Explorer battery drains

Hi. The problem is something on the car is draining the battery, but finding what is draining the battery is not easy.The first thing that comes to mind is if there is a light in the trunk is it going out when the door is closed?This is a simple thing but enough to drain the battery in a week.
One of the main parts of the electrical system is the alternator which has the main battery + cable attaches to it and therefore leakage (drain ) can occur when a part of the alternator goes faulty (usually the regulator ) I have replaced quite a lot for this problem.
The way an auto electrician would find the problem would be to put an amp meter on a battery cable and isolate one system at a time until nil or nearly nil amps are recorded.
Ihope i have been of some help to you, the problem is not an easy one to solve (like looking for a needle in a hay stack).
John( South Wales UK )

Posted on Apr 30, 2011

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

96 SC400, new battery,replaced few years ago.hear more clicking.I NEVER DRIVE IT. Live in Fl. gas turns to Corn pretty dam quick. Any ideas would be most help full and appreciated! Thanks

you need to drive to keep battery charged, trickle charger kept on battery will keep it fully charged. Change battery every 3 years, thats what I do. good luck

Mar 05, 2015 | Cars & Trucks

1 Answer

How to fix 98 dodge caravan electrical / battery problems

Alternator voltage may be to hight that make the battery to dry out,or maximum output amp not ok and battery cant be fully charge

May 04, 2014 | 1998 Dodge Caravan

1 Answer

My driver side brake lights went out. I replaced the blubs and the running lights work plus the passenger brake lights work. so I am lost

Its your turn signal switch in the steering colum. just pull your steering wheel and then the switch. I didn,t want to pay $80 for a new one, so I fixed it with bondo! That was about a year ago...still working fine.

Feb 17, 2014 | 1993 Buick Regal

1 Answer

Passenger side reverse light bulb stays lit when lights are turned on. Replaced bulb but didn't solve problem?

Sometimes such a problem is because the ground wire for that light is bad, and so the electricity is feeding to ground through the back-up light.
Try to run a new ground wire from that light socket to the steel body ground.
Be blessed.

Feb 16, 2013 | 2005 Chrysler 300

1 Answer

2006 Kia Rio will not turn over

the timing belt will not have anything to do with the motor turning over trying to start. First make sure u do have a very strong battery. Could be a bad connection or a broken wire to starter also.

Feb 07, 2013 | 2006 Kia Rio

1 Answer

Check engine light is on . Replaced mass air flow sensor last time it came on and solved problem. It's only been 2 months sense its been changed . Have a K&S filter system , made sure I didn't...

take the vehicle to AutoZone and have them read the OBDII code in the computer so you actually have some idea what might be wrong instead of guessing

Jun 01, 2011 | 2000 Toyota Tacoma PreRunner

1 Answer

Light of ABS is always on . on my Golf 2001 manual diesel. I have had no problem with ABS but light stays on since 1 year ago, Can I turn it off

Only way to turn it off would be to remove the ABS sensor (bad idea and potentially dangerous) or to replace the brake sensor. The part runs between $40-60 and is relatively easy to install.

Feb 20, 2011 | Volkswagen GTI Cars & Trucks

1 Answer

Brake and battery light are on in my 85 toyota pick up

sounds like a alternator take the truck to a local rebuilder and have him test it

Apr 09, 2009 | 1991 Toyota Pickup

Not finding what you are looking for?
1996 Chrysler Cirrus Logo

Related Topics:

66 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts


Level 3 Expert

69244 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22026 Answers


Level 3 Expert

813 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides