Question about 1999 Jeep Grand Cherokee

Open Question

How to fix engine ticking noise 1999 jeep grand cherokee

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

chryslertech
  • 115 Answers

SOURCE: remove the camshaft position sensor from my 1999 jeepcherokee

The Camshaft Position Sensor (CMP) on the 4.7L V - 8 engine is bolted to the front side of the right cylinder head. Disconnect the sensors connector. Take out the bolt that holds the sensor in place. Lightly pry out the sensor being careful not to break it. Clean out the hole and install the new sensor( put a little oil on the new sensors o-ring to help installation).

Posted on Feb 27, 2009

  • 1 Answer

SOURCE: oil pressure gage at zero

I have the same problem,an erratic reading on the oil pressure gauge.I have been in touch with Chrysler Jeep (USA) and this is a common problem.The oil pressure sensor needs to be replaced this is on the oil pump by the oil filter.I changed mine and no more problems.

Bear

Posted on Apr 05, 2009

techbuster
  • 5081 Answers

SOURCE: shift indicator light 1999 Jeep Grand Cherokee

There are two parts to it, a voltage resistor, and the EL panel itself.

You need to remove the console first. There are 2 screws under the front rubber pad, two under the cup holder, two in the bin. Remove those six first, take the storage bin out, then slide the rear cupholder out, remove the two screws under the cup holder, and one in front of it.

There are a total of 6 flat screws, and 3 self tapping screws you have removed.

Put the parking brake on, shift the tranny to N, and the transfer case to the middle position if equipped.

Remove the entire console. Slide the shifter beezel as far up vertically as you can. There are 4 clips you ned to remove to do it.
You will see a blue and black wire running into the back. Follow those wires to the resistor. You will see a transparent EL panel attatched to the resistor by two clips.

Usually, one or both of these clips has come loose, causing the light to work intermittantly. Clip them back on, and turn on the headlights to confirm that the light works correctly now.

Re-install everything in the opposite order.

Posted on Oct 11, 2009

Onifade
  • 268 Answers

SOURCE: what engines will fit in 1999 jeep grand cherokee

Engines from 1995 - 2001 can fit in.

Posted on Dec 14, 2009

  • 1 Answer

SOURCE: Ticking/Tapping when car starts but goes away???

I had what sounds like the exact same problem. It was an exhaust leak from the left (driver's) side exhaust manifold. This engine has a history of the manifold bolts breaking and causing the exhaust leak. The engine is also used on some Dodge vehicles. It sounds like a tick and I almost mistook it for a bad lifter. I took it to the local Jeep dealer who confirmed the exhaust leak. I replaced the left manifold completely and replaced bolts/gaskets on both sides (left/right) and it fixed the problem. Be careful, as the dealer tried to gouge me on the price. You are looking in the ball park of $600 parts/labor. I got parts for $120 and it took the better part of a work day to do the job.

Posted on May 28, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What would cause a Ticking noise in a jeep grand cherokee


Most time a ticking noise is caused by a valve lifter malfunction or a worn pivot on a rocker arm. if the noise appears to be coming from the valve cover (inside) that's usually where the problem is. Depending upon which engine you have the repair procedure will vary. (consult a haynes or chilton manual)
Before taking anything apart though many times a lifter noise will respond to a good engine additive like marvel oil or lucas engine conditioner. Neither one will harm the engine and it may quiet it down for you!
If you think my answer helped, please rate it. If you have another question or did not understand the answer, just ask.

Jun 16, 2010 | 2001 Jeep Grand Cherokee

2 Answers

Ticking/Tapping when car starts but goes away???


I had what sounds like the exact same problem. It was an exhaust leak from the left (driver's) side exhaust manifold. This engine has a history of the manifold bolts breaking and causing the exhaust leak. The engine is also used on some Dodge vehicles. It sounds like a tick and I almost mistook it for a bad lifter. I took it to the local Jeep dealer who confirmed the exhaust leak. I replaced the left manifold completely and replaced bolts/gaskets on both sides (left/right) and it fixed the problem. Be careful, as the dealer tried to gouge me on the price. You are looking in the ball park of $600 parts/labor. I got parts for $120 and it took the better part of a work day to do the job.

May 26, 2010 | 2005 Jeep Grand Cherokee

2 Answers

2006 Jeep Grand Cherokee just started making a clicking or rattling noise when starting up. The noise isn't audiable when driving. I've checked the oil level and it is normal. It is time for an oil change,...


so it goes away after a bit, that could be cause theres no oil on the top part of your engine, thats normal. wait till it gets older, it will be louder.

Jan 04, 2010 | 2006 Jeep Grand Cherokee

1 Answer

I have a 1999 Jeep Grand Cherokee Limited that is making a rattling/ticking noise under the hood and I cannot figure out what it is! We did an oil change and added Rislone, it quieted it some but not...


how many miles on it,sounds like lifter noise which is normal for high mileage jeeps,but if you have over 140k it is not a good idea to run synthetic oils as they are thinner than conv oil and it might start to consume oil.

Sep 26, 2009 | 1999 Jeep Grand Cherokee

2 Answers

I have been told the ticking noise my engine is


these is an old fix, and yes it is ok to do this, but it is better to add a can of Berrymans Chemtool run about 25 miles and drain oil.

Apr 02, 2009 | 2001 Jeep Grand Cherokee

1 Answer

Jeep grand cherokee99 fan noise


When veh is cold See if you can spin the fan freely if not replace it!

Mar 31, 2009 | 1999 Jeep Grand Cherokee

3 Answers

Oil pressure gage at zero when engine is running on my 1999 jeep grand cherokee v8. plenty of oil in engine


if the engine is running normal and there are no odd sounds from engine. probably needs oil pressure switch or bad connection at switch. any ticking noises and i would have pressure checked with guage

Nov 27, 2008 | 1996 Jeep Grand Cherokee

Not finding what you are looking for?
1999 Jeep Grand Cherokee Logo

Related Topics:

99 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...