Question about 1996 Oldsmobile Cutlass Ciera
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Rought idel, stalls alot, poor excelaration, starts hard, playing with gas peddel to keep running, they are also symptoms of fuel pump getting weak, or going out, should have fuel pressure test.
Posted on Feb 14, 2009
Get a Chilton's book on the car. It will take you thru the whole job, and give you the torque specs for putting it back together. You will need a torque wrench, foot pounds, and a good socket set.
Posted on May 04, 2009
my 89 cutlass did the same thing....She would bog down ( when the service engine light came on)....Light would go off and she would run fine...Shop replaced fuel fiter and KNOCK SENSOR, runs great now, the service engine light stays off too. Ran a can of MG injector cleaner thru too.
Posted on Oct 15, 2009
SOURCE: how to replace a water pump
This will probably be easiest water pump you'll ever have to replace. Since its bad it probably has leaked enough coolant out that you wont even have to drain the radiator. Use a half inch breaker bar to take tension off the belt at the tensioner(below the power steering pump), remove belt. The pump is the closest pulley to you when standing in front of the car. Use a 10mm wrench or socket to remove 4 bolts on the pulley, and then there is I believe 6 8mm bolts that hold the pump onto the housing. Give the pump a tap with a hammer, and the pump will come right off. If the gasket is still attached to the housing scape it off using care not to gouge the surface. you should cover the inside with a rag so no pieces fall into the system. Use some RTV sealant on the new gasket(light coating) both sides, let it cure for 5 mins, then reinstall gasket and pump. The bolts don't take much torque but make sure they are good and tight. Now reinstall the belt and fill the radiator. Give the sealant about an hour to really set-up before you start the engine. With radiator cap removed start the engine let it warm-up and fill the radiator as needed. Replace the cap, fill overflow tank to proper level and take it for a ride watching the temp gage. All should be good. If the temp is high after a mile or 2 their is probably air in the system that needs to be bled out.
Posted on Jun 06, 2010
Tips for a great answer:
Dec 08, 2015 | Oldsmobile Cars & Trucks
Jul 03, 2014 | 1990 Oldsmobile Cutlass Ciera
Mar 09, 2014 | 1989 Oldsmobile Cutlass Ciera
Nov 05, 2010 | 1996 Oldsmobile Cutlass Ciera
May 16, 2010 | 1996 Oldsmobile Cutlass Ciera
Jan 13, 2010 | 1995 Oldsmobile Cutlass Ciera
Oct 23, 2009 | Oldsmobile Cutlass Cruiser Cars & Trucks
50 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: