Question about 2005 Ford Freestar

Open Question

How to remove clock spring on a 2005 ford freestar

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

chiquititas
  • 1010 Answers

SOURCE: 2005 Ford Freestar rear air electrical

The blend door is stuck or not receiving the control knob information to change the temperature.

Your car uses an electronic blend door actuator. you will need to locate this devise under the dash. You may have to remove the dash to get to it. You will want to make sure that there is power coming in to the new switch and going out to the Blend Door Actuator. If you do not have power to the switch then find out why and fix the broken wire, if you have power to the motor but it won't move then replace the Blend Door Actuator (BDA).

Make sure the black wire to the BDA is grounded. The do the following:
Test the orange wire going to the BDA and the Yellow wire from the BDA to the switch for postive power. This will tell you if the BDA is getting power in from the car and out to the switch. Then make sure you get a power reading from the Red with White strip and the Red with Lite Green strip, this will tell you that the switch is sending the power back to the BDA to control the temp. If power is coming in to the BDA and not going out to the switch then the BDA is bad. If power is going to and from the switch back to the BDA then that also says the BDA is bad. If the ground is broken that will cause the BDA not to respond.

Posted on Jun 23, 2008

  • 1 Answer

SOURCE: where is the low tire reset button located on 2005 ford freestar?

It is on the same button as the Trip Odometer. Cycle through until you see Tire Reset and hold the button down.

Posted on May 04, 2009

  • 130 Answers

SOURCE: CD stuck in player of 2005 ford freestar

Take another cd and push the stuck one all the way back then try and eject it. If it doesn't come out right away do the process again this time when you hit eject take another cd and push down or up on it. Wiggle it around so it catches the rollers in there. Using CDs with homemade labels causes jams when the stickers peel up.

Posted on May 15, 2009

  • 32 Answers

SOURCE: changed caliper on 2005 ford freestar and now brakes are spongie.

When bleading the brakes have someone there watching to make sure the master cylinder never runs out of brake fluid or all of your time spent bleading them will be waisted.

Posted on Jun 08, 2009

  • 1 Answer

SOURCE: 2006 FORD FREESTAR VAN THE RADIO CONTINUE TO PLAY

ford is equiped with a gem modual this will keep accsesory power live until the door has been opened after the key has been removed, radio heater blower, windows...... will all work until the door is opened. just like the headlights that remain on after the vehicle is shut off and then auto off. normal on newer fords and is a feature not a problem.

Posted on Oct 30, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I remove the door panel moving right on my 2004 Ford FREESTAR


Ford Freestar Repair Manual, Service Manual Online 2004 ...

? 0:43
www.youtube.com/watch?v=g6JN4OSAHvo
Dec 23, 2014 - Uploaded by david gelf
Ford Freestar Repair Manual / Service Manual Online - 2004, 2005, 2006, 2007 If you need a Ford Freestar ...

Jul 28, 2015 | 2004 Ford Freestar

1 Answer

How to change clockspring on 2006 freestar


Changing a clockspring is not for the novice repairman. You will need to disable the airbag system, remove the steering wheel airbag, make sure the wheels are straight and remove the steering wheel. Then you will need to use a clockspring compressor and remove the retaining ring and un-plug the electrical connectors. Then plug in the new clockspring and install the clock spring and retainer, then remove the alignment lock from the new clockspring after it is installed. Then finish installing the steering wheel, air bag, and re-arm the system.

Jul 08, 2014 | 2006 Ford Freestar

1 Answer

Replaced clock spring on a 2006 ford freestar now it wont start pats light flashing


I hope that you did not remove the alignment before it was installed, This will cause your problem,

Nov 09, 2013 | Cars & Trucks

2 Answers

Need to replace spark plugs on a 2005 Ford Freestar mini van, not sure how to get to back spark plugs #1, 2, &6 how do I get to them.


You have a coil on plug or COP. to get to it you'll need a 1/4 drive extension.with a swivel socket and a 7mm socket youll just have manuver your way in , now if anything is in the way and your confident of removing what is the way you will suceed in removing the COP which allows you to remove the sparkplugs.

Apr 26, 2011 | 2005 Ford Freestar

1 Answer

HOW DO YOU REPLACE THE MANUAL SUPPORT CYLINDER ON THE REAR LIFT GATE OF 2005 FORD FREESTAR


there is a half circle spring clip at each end of the cylinder, pry it off with a pocket screwdriver.

Aug 08, 2009 | 2005 Ford Freestar

1 Answer

The cruise control in my 2005 Ford Freestar just stopped working yesterday, then this afternoon the radio controls in the steering column stopped working as well


clock spring in the steering column is my guess. They are delicate and have to do with anything in the steering wheel like airbag, horn, or anything that is operated by buttons on the wheel. These wires have to turn constantly with the steering wheel and the "clock spring" goes bad often enough

Jul 08, 2009 | 2005 Ford Freestar

1 Answer

2004 freestar


the most common cause of this in your Ford based on my dealer related repairs would be a part called the rotating ribbon contact (Ford refers to this part as the Clock-Spring contact.) that connects the steering wheel airbag to the steering column wiring, this contact coils and uncoils as the wheel is turned left and right and makes a solid connection to all steering wheel mounted components and controls. To change this part you must dis-arm the airbag and remove the steering wheel, if u do this repair yourself it is very important that u dis-arm the SRS system before starting work, this can be done by disconnecting the battery for 1 hour.

Feb 03, 2009 | 2004 Ford Freestar

1 Answer

How do I glue on the rear view morror for my Ford Freestar 2005


THERE IS A SPRING CLIP, U NEED THE SPECIAL LITTLE TOOL TO RELEASE THE MIRROR PAD SPRING CLIP.. ANY FORD DEALER WILL HELP U.

Dec 11, 2008 | 2005 Ford Freestar

Not finding what you are looking for?
2005 Ford Freestar Logo

Related Topics:

134 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

fordexpert

Level 3 Expert

5501 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...