Question about Volkswagen Golf

Open Question

Carnt find map sensor on engine vw lupo

How to fit map sensor

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
Richy1978
  • 23 Answers

SOURCE: erratic idling

are the leads fitted correctly

Posted on Oct 16, 2008

Ad
  • 1 Answer

SOURCE: MY VW LUPO IS HUNTING

The hunting and clicking is caused by a stuck vapor canister purge valve. The valve is on a vacume line. When it gets stuck open too much air enters the engine at idle or low rpm. This will cause the engine to hunt and stall as soon as any load is put on it if you do not rev it hard. The engine will over-run when coming to a stop and probably stall. It can come and go putting the chack light on. The quick fix is to just un-plug the solenoid. facing the enginebay it is located on the left hand side just infront of the suspention mount it is half balck half blue on every lupo i have seen. unpluging it will mean the car is driveable again but the check light does come on. It is 100% safe as long as nothing else happens that goes undetected because the light is already on. The part is about £70/80 from VW,  they may or may not know what you are talking about but i would not bother going to VW. The part is easy to find at a scrapyards if there are Lupos / Polos.  A number of other VAG cars share the part as well.  Any other problems come along to clublupo.co.uk 

Posted on Jan 06, 2009

  • 1071 Answers

SOURCE: MAP SENSOR..?

could be a throttle issue

Posted on Aug 19, 2009

Lloyd Six
  • 560 Answers

SOURCE: vw lupo engine code fault 17852 this code is not

It is a manufacturers fault code, it means implausable signal from G212

In English that means replace EGR valve :o)

Posted on Dec 09, 2010

  • 1 Answer

SOURCE: VW Polo Map sensor fault code idling pooly

Hi, I have a 2001 polo 1.4 mpi it lackes power when you hit a hill it just dies, It has had new cat, fuel filter, fuel pump and throttle body, but is still the same it just dose not want to give me full rev's?

Posted on Apr 11, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Engine management fault fitted map sensor and still wont start


Check that the hose for the MAP sensor is not disconnected or blocked. Then check that the vacuum port for the hose is clear on the engine side. After that, start looking at a shorted wire.

May 23, 2014 | Cars & Trucks

1 Answer

Where is the map sensor located on a 1.9 litre vw jetta?


For exact location and replacing procedure of VW jetta MAP sensor,click the link below and follow the details with diagrams:-----Where is MAP Sensor Located on VW Jetta http://technoanswers.blogspot.com/2012/11/where-is-map-sensor-located-on-vw-jetta.html
---------These will help.Thanks.

Nov 25, 2012 | Cars & Trucks

2 Answers

Crankshaft sensor for vw polo where is the


Crankshaft sensor is located on the right side of the cylinder block behind or under the starter. It is fitted into the rear crankshaft oil seal hausing

Sep 12, 2010 | 2002 Volkswagen Passat

1 Answer

MAP SENSOR..?


could be a throttle issue

Aug 19, 2009 | 2002 Volkswagen Golf

4 Answers

VW Polo Map sensor fault code idling pooly


Hi, I have a 2001 polo 1.4 mpi it lackes power when you hit a hill it just dies, It has had new cat, fuel filter, fuel pump and throttle body, but is still the same it just dose not want to give me full rev's?

Mar 30, 2009 | 2002 Volkswagen Golf

1 Answer

Erratic idling


are the leads fitted correctly

Oct 15, 2008 | 1999 Volkswagen Beetle

3 Answers

MY VW LUPO IS HUNTING AND MAKING A CLICKING NOISE UNDER THE ENGINE IM HAVE THE ECT CHANGED ON SATURDAY I HAD JUST HAD A M.O.T IT FAIL CAUSE EXHAUST EMISSIONS WERE TOO HIGH I HAVE SOME TIMES A CHECK LIGHT...


The hunting and clicking is caused by a stuck vapor canister purge valve. The valve is on a vacume line. When it gets stuck open too much air enters the engine at idle or low rpm. This will cause the engine to hunt and stall as soon as any load is put on it if you do not rev it hard. The engine will over-run when coming to a stop and probably stall. It can come and go putting the chack light on. The quick fix is to just un-plug the solenoid. facing the enginebay it is located on the left hand side just infront of the suspention mount it is half balck half blue on every lupo i have seen. unpluging it will mean the car is driveable again but the check light does come on. It is 100% safe as long as nothing else happens that goes undetected because the light is already on. The part is about £70/80 from VW,  they may or may not know what you are talking about but i would not bother going to VW. The part is easy to find at a scrapyards if there are Lupos / Polos.  A number of other VAG cars share the part as well.  Any other problems come along to clublupo.co.uk 

Jul 17, 2008 | Volkswagen Fox Cars & Trucks

1 Answer

Idling clatter on vw lupo


Hi

If this is the 3 cylinder Lupo then it could very well be the timing chain getting noisy.

Its around about a 3 to 4 hour job if I remember rightly, so at a VW main dealer labour costs would be over £200 ($400) plus around about £120 ($240) or so for the parts (chain and tensioner).

These are English prices though, so although I've put dollars in brackets, prices may still differ.

Just as a matter of interest, the main cause of chain stretch is lack of servicing, oil changes to be exact. If the service schedule is kept up then a timing chain will last several hundred thousand miles.

Very best regards

Geordie

Jun 02, 2008 | 1999 Volkswagen Golf

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

98 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volkswagen Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

yadayada
yadayada

Level 3 Expert

76691 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8531 Answers

Are you a Volkswagen Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...