Question about 2010 Dodge Grand Caravan
Van shaking at stop and engine shuts down while starting with factory remote start
Posted by Anonymous on
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Charlie. You have replaced the ECM on your van?.
Kedwin,, Your problem is, the computer on that 3.3 L.
Need to be programed with the VIN nember of your car.
The Antitheft System will disable the injectors due a incorrect VIN, Bucause the body computer is not recieve the correct pasword between 5 seconds after start up.
YOU have 2 options. 1 get a ALOHA Smith. some of they have the computer required to program ECMs.
The other option is: Get a new ECM from the dealer, They will program if ask for that.
NOTE:::::: Other way is . Put the body control module with the computer from the same car.
OK... I hope this work for yours.
If NOT letme know I can look for more information.
Posted on Jul 17, 2008
SOURCE: Airbag dash light
Transport Canada Vehicle Recalls & Defects Database Transport Canada Recall # 2007169 Recall Date: 2007/05/30 Notification Type: Recalls Audit System: Airbag Manufacturer Recall Number: G09 Units Affected: 51,000 Category: Minivan Recall Details: On certain vehicles the left or right front supplemental airbag sensors may crack under certain conditions, which can allow water to enter into the sensor. This can cause the airbag warning lamp to illuminate. A malfunction of one or both of the supplemental sensors will not adversely affect safety or cause a failure to comply with government standards. The single-point sensor in these vehicles, which is located in the airbag control module, is operational even if both supplemental sensors are inoperative. DaimlerChrysler has decided to launch a Customer Satisfaction Notification to advise customers that these front airbag sensors will be replaced with redesigned sensors to reduce the potential for damage. This action is not being conducted under the Motor Vehicle Safety Act.
Posted on Mar 07, 2009
Been working on my dad's 97 Caravan longer then i can remember for things you mentioned and have been not able to get him to sell it.
I found that the electrical connections are prone to corrosion and have replaced lots of the wire and pin connection in the wire harness, thank god i have time on my hands.
The instrument panel where the wire harness connects, i found that the solder goes bad and i had to re solder the connector on the back side of the circuit board, where the harness goes so you need to remove the instrument panel from the dash,
Here is a link that can help you retrieve DTC codes and do research on your caravan. I'ld tell you everything what i needed to do to keep my dad's caravan running but that would be a novel. http://www.allpar.com/fix/stall.html
Good luck and keep me posted, glad to help you keep yours running too.
Posted on May 26, 2009
I would check the iac(idle air control valve) first it controls the idle, and then if it is still acting up you may have to change the crank/cam position sensor
Posted on May 28, 2009
SOURCE: 2003 Dodge Caravan Battery?
Sounds like time for new battery, give it a full charge & have it tested, but have alternator checked as well, even though it appears alternator is o.k. because it runs, but just in case it's an intermittent problem with alternator
Posted on Jul 05, 2009
Tips for a great answer:
Nov 02, 2013 | 1998 Dodge Caravan
Dec 15, 2012 | 2008 Dodge Grand Caravan
Mar 09, 2012 | Dodge Cars & Trucks
Jul 12, 2011 | 1998 Dodge Grand Caravan
Jan 15, 2011 | 1997 Dodge Grand Caravan
Jan 25, 2010 | 2003 Dodge Caravan
Jan 19, 2010 | 1997 Dodge Caravan
Aug 30, 2009 | 1998 Dodge Grand Caravan
Nov 07, 2008 | 1998 Dodge Caravan
Oct 04, 2016 | 2010 Dodge Grand Caravan
41 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: