Question about Chevrolet Cars & Trucks
Check wire harness in passenger door pull plastic sleeve back repair wires and your window and door will work I had the same issue.
My window didn't work and door didn't lock had about 6 broken wires cost 7 bucks for some wire easy fix.
Posted on Jun 22, 2013
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
I promise this works 'cause I used it:
Put the key in the ignition, move the intermittent wiper control to the middle possition and then turn the key on.
just to clarify it's the ring that controlls the intermittent wiper speed and not the int / low/ high switch.
What this does is it resets the multiplex unit that controlls the accessories such as the power door locks. This problem usually happens once the battery has been removed or disconnected and reconnected. Every once in a while the multiplex systems lock up. Especially on the 98s. That's how you wake em up.
Posted on Mar 31, 2009
I had the same problem with now power to windows, mirrors and seat. The common soulution is the orange and or black wire in the boot have broken between the door and post.
Posted on Dec 07, 2008
I had the same problem to the T. I look online for all the same solutions and I can only tell you what worked for me. Actually what I think worked, HAHA! I went out to my truck and unplugged both battery terminals from battery and placed them together to supposedly reset the electrical system, "so I was told." After this for about 20 min or so, I went back out and in this order; re-installed positive terminal followed by negative terminal to battery. After this I checked locks and windows and surprise they worked. I've seen a lot of people say that all they did was wait and they worked later, so maybe it was that and not what I did, but who cares, they work now. Give it a shot and if it works for you, GREAT let me know, I HATE CHEVY CAUSE OF THIS......they wanted me to pay for a stupid diagnostic before they would help me........well screw you I fixed myself. LATER
Posted on Mar 06, 2009
SOURCE: door locks and power window
Just did this procedure I got from coloradofans.com forums:
"any type of power/voltage change seems to trigger this issue
The most common symptom is power locks fail and only the driver window quits, however that is on the extended cab.
Steps to fix and it works every time.
take door panel off driver's door
Disconnect the wiring attached to window and power lock control unit
disconnect battery cables
connect the negative to the positive cable(((NO BATTERY CONNECTED)))
This will act to short residual voltage in the system
5 minutes later
place the key in the ignition and turn to the run position
connect the wiring to the window/lock controller
connect the negative cable to the battery
then the positive
open drivers side door
turn key to the off position((do not remove yet)) you should get a series of dings through speakers telling you the key is still in the ignition
once it begins dinging pull the key out and you should hear the door lock solenoids trigger and the windows should work." - Coloradofans.com forums
Posted on Mar 20, 2010
Tips for a great answer:
Mar 20, 2013 | 2008 Chevrolet Equinox
Jul 24, 2017 | Chevrolet Equinox Cars & Trucks
Jul 29, 2011 | 2004 Pontiac Montana
Mar 20, 2011 | 2005 Chevrolet Equinox
May 07, 2010 | 2005 Chevrolet Equinox
Apr 02, 2010 | 2005 Chevrolet Equinox
Mar 23, 2010 | 2005 Chevrolet Equinox
May 09, 2009 | 2007 Chevrolet Equinox LS New Cars
Dec 27, 2008 | 2003 Chevrolet Equinox
168 people viewed this question
Usually answered in minutes!