Question about 1986 Ford Ranger 2WD

1 Answer

1986 ford ranger truck will turn over but wont fire. cant find out how to get the distrubor off to check modular. what do you think is wrong. how do we fix

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Ford Master
  • 2,749 Answers

Don't remove dist.
instead remove (1) plug wire stick small screwdriver into wire end place it near(1-8 inch) a large bolt or exaust manfold (don't hold it ) have a friend crank over starter did you see a spark NO replace TFI module
grey thing on back lower distributor your gonna need a torx stubby wrench to get it off
and don't forget the white grease that comes with new one thats for heat disp.

Posted on Mar 12, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1986 ford ranger wont shift into overdrive


could have faulty governor.throttle cable need adjustment.the 83 - 90 models you need to adjust front and rear bands in the transmission.

Apr 06, 2013 | 1986 Ford Ranger 2WD

1 Answer

I currently own a 1986 Ford Ranger 2.9 V6, RW Drive. Was driving like a charm!! I was driving it yesterday morning, no problems, I parked it after 10 minutes of driving... Last night I went to start it, it...


I just checked you do indeed have a timing belt.
Sounds like the problem,worth the cost and time to change the water pump as well since your digging into the front of the engine anyway.
The tensioner should be good for another 100,000 miles

Nov 25, 2010 | 1986 Ford Ranger 2WD

1 Answer

Firing order diagram for 1986 ford 2.3l


1986 Ford Ranger 2WD 2.3 liter SOHC L4 VIN "A"

55ef2f7.gif


Remember rated this. TY for using Fixya.


Aug 07, 2010 | 1986 Ford Ranger 2WD

1 Answer

My 1986 ford ranger wont fire when it is warm,if i hold the gas pedal down it will fire but wont start until it cools off,what could it be


there is a sensor in the distributor cap you will ned a special tool to remove it it is most likely the cause and it is fairly cheep.

Feb 05, 2010 | 1987 Ford Ranger

1 Answer

I have a 1986 V6 Ford Ranger 2.9L. I was told that i needed to replace the Rotor, Distributer Cap, Spark Plugs. I did so (a mechanic did) and now my truck wont start. It tries and wont idle. I checked the...


You need to turn the engine over to find Top dead center,
Then remove the cap and see if the rotor is pointing to #1,Then verify the wires have started in that position and are rotating in the right direction.

Dec 25, 2009 | 1986 Ford Ranger 2WD

1 Answer

1986 ford ranger staled out and wont restart has fuel and spark


fuel shutoff switch most fords have them passenger side under the dash, probably was tripped by accident

Mar 08, 2009 | 1986 Ford Ranger 2WD

1 Answer

I NEED A VACUUM INE DIAGRAM FOR A 1986 FORD RANGER 2.9 EFI


Make sure that your truck vaccume line goes into the intake manifold where there is a vacuume spiggot at the base of the carb. You may have iadvertantly hooked it up to the wrong place.

Feb 13, 2009 | 1986 Ford Ranger 2WD

1 Answer

1986 ford ranger 2.9 liter 2 wheel drive


youll have to see if your coil is firing

Feb 07, 2009 | 1986 Ford Ranger 2WD

1 Answer

Firing order diagram for 1986 ford ranger


you will find this site usefull , here is the diagram for 1986 ford ranger 2wd 2.9liter v6 firing order .

http://www.autozone.com/N,26200242/shopping/specsSelect.htm


Fix Ya vote is my Reward , thanks .

Jan 08, 2009 | 1986 Ford Ranger 2WD

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

202 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

70387 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Ron Lankford

Level 3 Expert

5386 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...