Question about 1998 Jeep Grand Cherokee

Open Question

Horn on 1998 jeep grand cherokee laredo does not work

How do i test the horn to see if it is still a good part?

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
Mikey108
  • 475 Answers

SOURCE: 1998 jeep grand cherokee

Under the glove box beneath the dash the resistor should be screwed into the heater housing.

Posted on Oct 08, 2008

Ad
  • 27 Answers

SOURCE: 1998 jeep grand cherokee laredo

Shifter interlock switch. Move shifter back and forth several times while pressing brake pedal.

Posted on Dec 31, 2008

  • 5 Answers

SOURCE: 2001 jeep grand cherokee laredo brake lites

sometimes the actual sockets go bad where you plug your bulbs into dust water ect gets in and sometimes its just faulty.i know im a tech for chrysler jeep and dodge but they are not cheap if you have a test light use it and touch the inside where the bulb goes if there is power then its not that.could also have a short.

Posted on Jan 19, 2009

  • 6982 Answers

SOURCE: 1998 Jeep Grand Cherokee horn works sometimes and

You will find the problem in one of three places...Either the horn contacts inside the steering wheel are bad, the relay is sticking or the horn itself has failed or is failing. All give similar symptoms.

Posted on Jul 28, 2009

c17hydro
  • 2984 Answers

SOURCE: 1998 Jeep Grand Cherokee Laredo 4.oL I got a code po113

Trouble Code: P0113 (4.0L L6 VIN S Auto)
IAT Sensor Circuit High Input Print this code dataprint_icon_codes.gif Number of Trips to Set Code: 1
OBD II Monitor Type: CCM Details
Indicators: MIL Details

Trouble Code Conditions:
Check with ignition on or engine running; battery voltage more than 10v; The PCM detected the IAT Sensor input was over 4.90v (exc. Dakota, Durango, Ram) or 4.98v (Dakota, Durango, Ram) for 3 seconds.

Possible Causes:
  • IAT Sensor signal circuit shorted to VREF (5v)
  • IAT Sensor signal circuit is open, or the ground circuit is open
  • IAT Sensor is damaged or it has failed (an internal open circuit)
  • PCM has failed


d1eaead.gif

Posted on Dec 01, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 1998 grand Cherokee Laredo with a 4.0 in


spark to all 6 cylinders'
compression good is first. all 6
then spark x6, if PCM sees no spark? it CUTS fuel by DESIGN. (logic)
the fuel.
if you have spark, the test fuel works, "spray"

ever get a full tuneup this decade or every 60k miles.
no? well , now is the time, huh?
spark good to all cylinders, NOT just one, pretend its 6 engines. dig?

Sep 23, 2014 | 1998 Jeep Grand Cherokee

1 Answer

Can i use a transmition from 1998 grand cherokee laredo 4wd to a jeep laredo 1998 4.0 4wd. will work same trnsmition?


Hi Jose, I've never tried but if you go visit a breakers yard and compare the physical dimensions of both boxes and they match up, there is no reason why they should not. Most manufactures use the same units in a variety of models and if you've found a similar vehicle with identical uses the parts are most likely interchangeable. Regards John

Apr 01, 2012 | 1998 Jeep Grand Cherokee

1 Answer

Jeep grand cherokee alarm system


The 1995 Jeep Grand Cherokee Laredo Anti-Theft System is equipped with Vehicle Theft Security System (VTSS). VTSS system monitors vehicle doors, hood, liftgate and ignition. If an attempt is made to enter or operate vehicle without proper disarming of system, vehicle horn will sound, headlights, taillights and parking lights will flash, and engine will be prevented from running.

The following wiring diagram and electronics circuit contains detail schematics of The 1996 Jeep Grand Cherokee Laredo Anti-Theft System. Herein you will find interconnection between electronics parts of the system such as body control module, auto headlamp light sensor. VTSS led, driver door module, passenger door module, cylinder lock switch, junction block, power distribution center, and grounding. Herein you will learn also how the Vehicle Theft Security System works, removal, installation, testing and troubleshooting procedures.

Try HERE and also, remember that here can find the Jeep Grand Cherokee Service Repair Manual.

Hope this helps; also keep in mind that your feedback is important and I`ll appreciate your time and consideration if you leave some testimonial comment about this answer.

Thank you for using FixYa, have a nice day.

Nov 25, 2011 | 1995 Jeep Grand Cherokee

1 Answer

Horn wont blow in 2004 grand cheroke laredo jeep


get assistant to hold horn on then tap it with a hammer and see if it will work ,often works

Nov 14, 2010 | 2004 Jeep Grand Cherokee

1 Answer

Turning off Alarm


close the doors while on the outside... lock and unlock the drivers door with the key. then open the door and you should be able to start the vehicle

Mar 31, 2010 | 1998 Jeep Grand Cherokee

1 Answer

Where do I go to find digram of 4wd linkage for 1998 grand cherokee laredo


You will probably find what you are looking for here:
1998 Jeep Grand Cherokee Service Manual
http://rapidshare.com/files/138412864/ServiceManual.Jeep.Grand.Cherokee.1998_by_Parasico.rar
otherwise i still recommend downloading this for reference...

Goold Luck!

Mar 06, 2010 | 1998 Jeep Grand Cherokee

1 Answer

Horn won't work


Under the right front fender

Nov 13, 2009 | 1996 Jeep Grand Cherokee

1 Answer

How do I replace head light on 1998 Jeep Laredo?


1998 Laredo, but...
- Cherokee (Headlight Remove / page 8 and next)
- Grand Cherokee (Headlight Remove / page 5 and next)

Hope helped (remember rated this help). Good luck.

Oct 30, 2009 | Jeep Grand Cherokee Cars & Trucks

1 Answer

Minor Electirc Troubles (1998 Jeep Grand Cherokee Laredo)


Definately take it back to the radio installer

Jan 20, 2009 | 1998 Jeep Grand Cherokee

Not finding what you are looking for?
1998 Jeep Grand Cherokee Logo

Related Topics:

57 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...