Question about 1993 Jeep Grand Cherokee
I have a 1993 Jeep Grand Cherokee that worked fine before and now it just wont move when putting it in gear?
i also have a 98 jeep grand cherokee i was wondering if i could use the transmission from the 98 and put it in the 93 ? but the 98 is 4 wheel drive while the 93 is 2 wheel drive but can be switched to 4 wheel drive
No, not with out a lot of work. Electronics are most likely different on the 2 also.
Posted on Mar 11, 2009
OK...I have a 93 outside...one diagram I have shows an ignition module next to coil...but there is none on mine, (4.0 engine)
Two items to check are crank sensor and cam sensor inside distributor. Test procedure can be found in just about any manual including haynes.
You will need a decent volt/ohm meter to do testing. You can also check codes by turning ignition switch on/off three times, leaving it on the third time. Check engine will flash code #'s (ex: one flash, pause two flashes= the number twelve.then followed by a longer pause then another set of flashes etc.)
Posted on Mar 05, 2009
Not if it locked mechanically. Ive had good luck using a pipe wrench sideways on the balancer to turn some over that were pretty frozen up.
Posted on May 07, 2010
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Tips for a great answer:
Dec 05, 2012 | Cars & Trucks
Jan 25, 2012 | 1992 Jeep Cherokee Sport
May 18, 2011 | Jeep Grand Cherokee Cars & Trucks
Jan 17, 2011 | 1993 Jeep Grand Cherokee
Mar 05, 2009 | 1993 Jeep Grand Cherokee
Nov 15, 2008 | 1993 Jeep Grand Cherokee
Sep 21, 2008 | 1993 Jeep Grand Cherokee
875 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: