Question about 2005 Nissan Frontier

Open Question

2000 Nissan Frontier has no spark - 2005 Nissan Frontier

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
mnabi01
  • 94 Answers

SOURCE: 1998 Nissan frontier: where is the ignition coil?

the coil is inside the distributor under the cap.

Posted on Jan 29, 2009

Ad
dealt_soul
  • 296 Answers

SOURCE: 2000 NISSAN FRONTIER VIBRATION

Check tire balance, rear wheel bearings and i would replace u joints front and back, anyway if they have never been repaced.

Posted on Feb 15, 2009

  • 2 Answers

SOURCE: change brake light bulb on a 2000 Nissan Frontier

The entire bed line will need to be removed. The long screws that hold the metal bracet where the bed extender attaches also hold the tail light assembly in place.
I pulled the bed liner up at a 45 degree angle and layed it on top of the cab. This revealed the screws. Take both screws out and lay to the side along with the metal bracket for the bed extender.
Now firmly grab the edges of the tail light assembly and pull...there are 2 hard rubber nipples that snap in to hold the assembly. You will feel like you might break it but you won't..just pull straight back hard. The assembly will "POP" out and then you can just twist the back of each bulb there are (3) and pull out..now you will see the bulbs..just pull the bad bulb straight out and push the new one into place. Now just reassemble. Total time will be 30-45 min. for this repair.

Posted on May 04, 2010

  • 1596 Answers

SOURCE: 2005 nissan frontier se 4.0 No start No spark.

Ignition Control Module is the Obvious Problem here

Posted on Jun 04, 2010

2003nissan
  • 1 Answer

SOURCE: nissan frontier 2001 has spark and fuel cranks but

my truck won't start but .. no click just a little kinda grind and then stop .. is it the starter ?

Posted on Jun 08, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Getting no spark


coils and perhaps the wires they do fail

Nov 27, 2015 | 2000 Nissan Frontier

1 Answer

I would like to know the proper spark plug gap for a 2000 nissan frontier?


It depends on which engine you have fitted.

If it is the V6 3.3 ltr engine the plug gap is .039 inches

If it is the 2.4 liter engine the gap is .044 inches.

S

Dec 24, 2010 | 2000 Nissan Frontier

2 Answers

My nissan frontier 2000 v6 is not firing what can be the cause


Sparks plugs, spark plugs wires, coils, defective battery or fusible link.
Ignition swith faulty

Jun 26, 2010 | 2000 Nissan Frontier

1 Answer

My 2000 Nissan Frontier has sputtering problems and the tac goes crazy. changed the fuel pump, sending unit, spark plugs, cap & rotor. what could be wrong?


your tach is run by the engine computer, possible cause. also by the crankshaft position sensor, most likely cause, I would start there. some sensors will run within perimeters and be bad enough to cause a lot of problems

Jun 14, 2010 | 2000 Nissan Frontier

1 Answer

2000 frontier. died while driving now getting no fire. wut do i do? fuses are good and fuel pump is fine. just imeditaly quit firing.


Scan for codes. How do you know the fuel pump is fine? Did you test it? Did you crank it and look for spark?

Feb 20, 2010 | 2000 Nissan Frontier

2 Answers

What is eng oil capacity for a nissan frontier 4 banger 2000 model


Including filter; the oil capacity for a 2WD, 2000, Nissan, Frontier, 4cyl (Ka24de) is 3-3/4 quarts. Straight out of the Haynes manual.

Nov 28, 2009 | 2000 Nissan Frontier

2 Answers

2001 Nissan Frontier 4x4 crewcab supercharged. P0340. won't start. also p0325 power to distributor, no spark, resistor ok, coil resistance ok, distributor checks out ok on scope.


P0340....Camshaft Position Sensor 'A' Circuit (Bank 1 or Single Sensor)
P0325....Knock Sensor 1 Circuit (Bank 1 or Single Sensor)if you have no spark it your cam sensor

Nov 14, 2009 | 2000 Nissan Frontier

1 Answer

My 2000 nissan frontier v6 hasthe back spark plug hole stripped out. any way to repair without removing the head?


Hello;
There is a tool made to chast threads on heads. If yours is chaseabble, then get the tool. Use heavy grease to capture the filings. If you cannot do tyhis, then you can put in a thread insert. All depends on if you can get the drill at the spark plug hole perfectly.
Hope this helps;
Rich
RPM Northwest

Jul 06, 2009 | 2000 Nissan Frontier

1 Answer

Any tricks to changing spark plugs in 2000 nissan frontierr 4door V6 2 wheel drive


go to parts store and buy a spark plug wire remover so you don't brake the plug wires unless your going to use them, and be sure to use dialectic grease on the end of the boots.

Jun 28, 2009 | 2000 Nissan Frontier

Not finding what you are looking for?
2005 Nissan Frontier Logo

Related Topics:

63 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...