Question about 1993 Toyota Camry V6

1 Answer

I am unable to replace the to center brake indicator bulb

I am unable to get into the fixture to replace the bulb in the top center brake indicator light. Does one approach it from inside the car and remove the cover, or unscrew the fixture inside the trunk? I have been unable to do either.

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert whose answer got voted for 500 times.

  • Master
  • 1,392 Answers

Should be able to pry the cover off from the inside. Being that the car is 26 years old, the plastic may be brittle and break. Take it easy, and you should be able to do it that way, or they may be 2 screws on the sides of it.

Posted on Mar 11, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

How do i replace brake light bulb on 2005 mazda bounty

Gain access to the light fixture, remove the bulb holder, remove the burned out bulb and replace with new, test, then re-install the bulb holder and re-install the fixture.

Aug 30, 2014 | Cars & Trucks

1 Answer

Brake light and tail light out on same side. Replaced bulb in brake light but still neither still works.

Look at the wiring harness that runs to your tail light fixture. make sure that the harness connections have not loosened. check harness casing and bulb iixtures for breaks or corrosion... sounds like you have a short going on. with the light switch on, try wiggling the wiring where it goes into the fixture. if the light flickers at all while doing this you have a short going on in the fixture and it may need to be replaced.

Feb 28, 2013 | 1996 Dodge Stratus

1 Answer

Astra center brake light not working

Does the light fixture get power? If so replace the bulb or the whole assembly.

Oct 05, 2012 | Vauxhall Astra Cars & Trucks

1 Answer

The rear brake lights or indicators dont work on my holden astra

Make sure all the wires are pluged into the light fixtures and that there not corroded

May 30, 2012 | Cars & Trucks

1 Answer

Need to change rear brake light bulb on a 2000_L sedan. Owners manual addresses only the turn signal bulb change proceedure. The brake light fixture is flat not round.

there is an access cover in the trunk.Open that and just pull the bulb fixture out replace the bulb and place back in the hole.

Apr 07, 2012 | Saturn Cars & Trucks

2 Answers

I have no brake lights & it isn't the fuse. What can I do?

Check the brake light switch at the top of the brake pedel. You should have continuity between the wires when the pedel is down

Nov 07, 2009 | 2005 Jeep Liberty

1 Answer


this is not a bulb u must replace the entire LED fixture, to do this remove the inside trim at rear around rear hatch opening, then you will need to drop the headliner down to access the retainers that hold the third brake fixture in, very easy job.

Jul 09, 2009 | 1996 Ford Explorer

2 Answers

Replacing a brake light Tercel 1999

1999 Tercel rear light bulb replacement. Snap off 2 black caps to pull back carpet. Remove 2 screws on outside of trunk at the edge of trunk lid. The light fixture will loosen up. Sqeeze the tongs on the square white plastic plug on the inside and push plug through hole. You may have to give the light fixture a tug. Turn bulb holder and pull it out. Pull out bulb and put in new one.

Apr 02, 2009 | 1997 Toyota Tercel

1 Answer

Need to replace right rear brake light bulb. can't get into the area.

Is it the rear tail light itself, or the side marker? I may have the same issue if its the side marker. However, the tail light itself is simple, remove the panel in the trunk side, and there are three seperate light fixtures, the bottom being the main tail light, the middle is the signal indicator and the top is the upper brake light.

Mar 16, 2009 | 2005 Scion xB

2 Answers

PT Cruiser Brake Light

The bulb in the rear light has burned out and to replace it follow these instructions: 1) go to your owner's manual to find out the part number. You can find and purchase the replacement bulb at Target, any auto parts store and even at Walmart for under $4.00; 2) pop open the trunk door; 3) get a phillips screw driver and unscrew the 2 screws holding the rear brake light fixture to your car body; 4) as soon as you turn over the fixture you'll see where to pull out the burned out bulb and replace it with the new one(s). Good luck!

Jul 14, 2008 | 2006 Chrysler PT Cruiser

Not finding what you are looking for?
1993 Toyota Camry V6 Logo

37 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts


Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8567 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides