Question about Kia Cars & Trucks
I bought a second hand car its KIA CARNIVAL II PARK 2002 145 High Power Direct Injection Diesel Engine 2.9 HPDI chassis no: KNAMA75432S68965 The engine temperature is rising up and the engine is stooped I changed the Engine with an other used one and engine can not work i tested with the Diagnosis Bosch KTS 570 instrument there is thee codes appears instead of error faults these codes are 4373 6016 4385 please can you help me to write to me the faults instead of the errors and what is the problem of it
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
REMOVE RAD CAP AND RUN ENGINE AT 3000RPM WITH ALL HEATERS ON SOUNDS LIKE AIR LOCK, ALSO CHECK IF HOSES ARE HOT
Posted on Mar 30, 2009
hi from uk for your info there was a recall back in2004/5 for the getz relating to the abs system going faulty my wifes 2003 getz gsi was recalled and i took car to dealers for her to enquire what fault has there beenon some getz with abs system? as fault had not occured on ours ? apparently there had been a fault with the wire loom to pump particularly the earh cable deteriating ? so this loom had to be inspected and replaced under warranty however as i had waxoiled all underneath our getz including abs pump due to its location low down the loom was ok but was changed anyway and recorded and a dated sticker placed on cars glove compartment door inside to verify loom changed ? SO b4 you progress any further i would check with hyundai tech dept to whether you car had been inspected or whether slipped through unchecked ? your gran should have had a recall as we did for modified loom hope this helps?
Posted on Dec 09, 2009
It is located on the intake side of the engine by the flywheel, One bolt holds it in. 8 or 10 mm.
This can be tested with an ohm meter. readings should be between 500 to 700 ohms. Anything out of this range replace it
Posted on Jun 19, 2011
Testimonial: "Very Helpful thanks"
Tips for a great answer:
May 11, 2016 | Kia Cars & Trucks
Apr 16, 2014 | 2002 Kia Sedona
May 03, 2013 | Kia Carnival Cars & Trucks
Jan 30, 2013 | 2006 Kia Carnival 2.7
May 16, 2012 | 2002 Kia Sedona
Mar 02, 2012 | Kia Carnival Cars & Trucks
Mar 21, 2010 | 2002 Kia Sedona
40 people viewed this question
Usually answered in minutes!