Question about 2006 Jeep Commander

Open Question

NO BRAKE LIGHTS ON JEEP COMMANDER BLINKERS WORK,LIGHTS WORK JUST NO BRAKE LIGHTS ON EITHER SIDE. I'VE LOOKED FOR THE FUSE BUT IT ISNT LABLED AS BRAKE LIGHTS OR ANYTHING I RECOGNIZE. CAN SOMEONE TE

Posted by on

  • Seagypsy Everett
    Seagypsy Everett Apr 20, 2013

    Brake switch was mentioned. My god where is that located? There is no rust or corosion around the sockets. Thank You

×

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 178 Answers

SOURCE: 2000 jeep wrangler brake lights don't work

hello sounds like a bad or loose wire on your brake switch up under your dash follow your brake pedal upward push down on your pedal now watch as you let it go slowley where it touches the skinny flat area of your petal touches a switch about 10 inches up from the bottom you should see a button sticking thru a bracket were your pedal touches check and jiggle wire if no lights change switch goodluck

Posted on Sep 18, 2008

Mikey108
  • 475 Answers

SOURCE: 1989 Jeep Cherokee - Electrical Problem - horn, brake lights, blinkers, radio/cd...

There could be a fusible link under the hood off the starter relay that is burnt out.

Posted on Oct 13, 2008

  • 1 Answer

SOURCE: 1989 Jeep Cherokee - Electrical Problem - horn, brake lights, blinkers, radio/cd...

I think I have found the problem. When I wiggle the ignition switch the turn signals and radio go on and off so I feel the issue is in the ignition switch. From what I understand the actual electronics for the switch are at the base of the sterring column behind the lower dash panel and is connected by a rod that may need adjusting.

Posted on Jan 04, 2009

FoRdMaStEr
  • 51 Answers

SOURCE: tail lights 99 jeep grand cherroke limited

have you checked the bulb sockets to see if they are burnt or corroded sometime i see that the plastic melts around the contacts where the socket twists into the housing. if your lucky you might get away with replacing just the socket for the brake/running light bulb. but if it is too melted your most likely going to need a new housing

Posted on Jan 07, 2009

  • 13 Answers

SOURCE: 2000 jeep wrangler, brake lights don't work

check brakelighy switch

Posted on Jun 11, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

How to fix 1999 jeep grande Cherokee Laredo left blinker won't work


Check the fuse for it on the fuse panel, the cover usually has a sticker indicating the purpose of each fuse, if that isnt the problem then check your wiring and blinker light female and male end plugs

Dec 21, 2015 | Jeep Cars & Trucks

1 Answer

Where is brake light fuse on 06 jeep commander


should be under dash or kick panle driver side if you have a owners manule it will tell you wich fuse it is with out having to try to read it down there all bent over or on your back.

Apr 19, 2013 | 2008 Jeep Commander

1 Answer

2001 jeep wrangler. Brake lights won't work but


Check the brake control switch situated just above the break pedal arm under the dashboard. Could be a wire loose or unplugged or the switch itself could be faulty

Mar 07, 2013 | Cars & Trucks

1 Answer

No dash lights 1995 Jeep. I have no dash lights. My interior lights work, brake lights work, console lights dont work, stereo lights work, high beam indicator works, blinker indicator works, everything...


Look for fuse panel under or either side of dash. Another location may be similar in engine bay.
Fuses probably labelled. Available at motor shops, garages etc.
If out of your experience then probably not expensive to ask auto electrician where to look. Many are cooperative and may tell over the phone or counter.

May 01, 2011 | Jeep Grand Cherokee Cars & Trucks

1 Answer

Dashboard lights and rear exterior running lights not working. blinkers, flashers, and brake lights work. regular tail lights won't work. Not finding a blown fuse. not finding any fuse listed as "tail...


the fuse is labled 'brake'

I would replace the fuse... and then have someone stand to the rear of the vehicle and watch the lights come on as I applied the brake... if the fuse blows again... note which tail light did NOT come on durring this test and replace the bulb.. it is grounding to itself and causing the short.

Sep 25, 2010 | 2000 Honda Odyssey

1 Answer

2002 Jeep Liberty flashers, blinkers, taillight and brake light are not working on the left (drivers side


was vehical in an accident? check fuses in pdc under hood this jeep has fuses for the rt side and left side in power distrabrution center.

Feb 23, 2010 | 2002 Jeep Liberty

1 Answer

95 jeep cherokee no rear taillights,but rear blinkers,and brake lights work fuse #19 looks good also lost dashboard lights fuse#9 looks good


check fuse #15 and see if it is the problem. also look under the hood in the power distrabution box at fuse #13 (15amp mini Blue fuse) that could be the problem as well

Nov 29, 2009 | 1995 Jeep Cherokee

1 Answer

Right rear brake light and blinker not working


Daniel,

Should still be under warranty. If you have determined it is not a burned out bulb, let the dealer trouble shoot.

Some other things to check, from a wiring standpoint, does the right side emergency flasher work? Does the right side backup light work?

If these do not, I'd look for a connector to the right side of the rear that came loose. Haven't spent that much time under my 2009 (same model style), but I'd suspect on a jeep that physically following the wires to a connector would not be hard. Also could be a ground issue to the right side lamp housing.

If those are working, morelikely a broken wire.

Jul 30, 2009 | 1997 Jeep Wrangler

1 Answer

1989 Jeep Cherokee - Electrical Problem - horn, brake lights, blinkers, radio/cd...


There could be a fusible link under the hood off the starter relay that is burnt out.

Sep 10, 2008 | 1989 Jeep Cherokee

2 Answers

1989 Jeep Cherokee - Electrical Problem - horn, brake lights, blinkers, radio/cd...


I think I have found the problem. When I wiggle the ignition switch the turn signals and radio go on and off so I feel the issue is in the ignition switch. From what I understand the actual electronics for the switch are at the base of the sterring column behind the lower dash panel and is connected by a rod that may need adjusting.

Aug 14, 2008 | 1998 Jeep Cherokee

Not finding what you are looking for?
2006 Jeep Commander Logo

Related Topics:

683 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7754 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...