Question about Cars & Trucks

1 Answer

I put my car in drive but the transmission doesn't kick in to make it drive.

Posted by on

1 Answer

Hi. When last did you check the transmission fluid levels? I had a similar problem a few years back and the problem was there was very little or no transmission fluids. Please check. Thanks.

Posted on Apr 20, 2013

  • Giovanny Galvan Apr 20, 2013

    I figured it out. One of the sensors on the bottom is broken and popped out of place, I just put it back and it worked fine again.

×

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

jrw4u
  • 62 Answers

SOURCE: my transmission is clicking

the bands need to be tighten in the transmission

Posted on May 01, 2009

  • 147 Answers

SOURCE: My 1996 toyota tercel (automatic

you check the ATF (trans oil) condition this good indiccator for your trans status . (burn mean clutch inside burn ) have small chips . change ATF and filter and make sure it;s in level.

Posted on Jun 22, 2011

canwoodjc
  • 3301 Answers

SOURCE: 2003 ford windstar found with puddle of

don't panic just yet . you could have a bad rear tranny seal and the fluid leaked out, It happens, the car won't move since so much fluid leaked out,, I'd take it to get it checked, because if you just refill the fluid its just going to run out again, If it was showing no signs of slippage or jerking before , then with any luck it will be something less than a complete tranny!!

Posted on Jul 08, 2011

cardenderek
  • 783 Answers

SOURCE: When you put the car

please clarify... "when you put the car into hold"?? Thank you kindly.

FixYa Support

Posted on Aug 28, 2011

awaissabair
  • 580 Answers

SOURCE: Hi I have a 1996 Toyota corolla. Te transmission

It differs with use but for a rule of thumb you can look at the fluid on the dipstick against a white cloth and if it brown to black looking not a reddish color you should have it serviced.Either a drain and fill or a complete trans flush if it is black.Your trans will thank you

Posted on Oct 12, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1990 ford f150 transmission wont shift


does it go into drive an then just not shift out of first? or does it not go into gear at all? if it doesn\'t shift out of first then check the transmission speed sensor i believe its down on top of the tranny on the f150"s if its not that check the kick-down cable

Mar 20, 2013 | 1995 Dodge Caravan

1 Answer

I just bought a transmission for my 2003 lincoln navigator but when I put it in gear it doesn't go in drive or reverse until I put it in drive 2 first then into reverse or drive. what is causing t


Is that a used unit?

If so-- then that is some elses junk

That valve body is dirty
Solenoids dirty

Can't be rebuilt or a decent unit,
with those problems

Mar 15, 2013 | Lincoln Navigator Cars & Trucks

1 Answer

Feels like slipping transmission / transfer case


either your rear driveshaft is missing, your rear axle is pooched. the same transmission drives both ends.

Jul 23, 2017 | Chevrolet Blazer Cars & Trucks

1 Answer

Transmission kicks hard when put in drive


The problem is the transmission I'd check the fluid levels. Shops are notorious for not filling fluids to the proper levels. If that isn't the problem which it may not be Then some1 did a very bad job on the trans. The fact that you have been having problems from day 1 is not good. Even so that could be a low fluid problem so I'd check that first. Hope this helps.

Oct 28, 2012 | Ford Windstar Cars & Trucks

2 Answers

2002 Dodge Neon, approx 99,000 miles, engine light came on, error code PO605 & another error code related to transmission, auto transmission - driving anything over 25 mph won't "kick up"...


Its the TCM- Replace the Transmission Control Module. WITH THE DRBIII PERFORM QUICK LEARN AND REPROGRAM PINION FACTOR.
The transmission Control Module (TCM) is located behind the passenger fender and is fastened to the frame rail forward of the suspension. Here is a picture of it...

michael_cass_533.jpg

Aug 02, 2011 | 2002 Dodge Neon

1 Answer

Hi I have a 97 grand prix and the problem I have with it, is that it doesn't accelerate it starts, but when a put in drive or reverse, it doesn't move, I don't know whats wrong with it, any...


Sounds like your transmission is slipping or your torque converter is bad.---check the transmission fluid level and see if it smells burnt and discolored.

Jun 28, 2011 | 1997 Pontiac Grand Prix

1 Answer

My 1996 toyota tercel (automatic transmission) doesn't shift into gear when I put it in gear and not sure if transmission needs to be replaced and if it doesn't get fixed soon, what will...


you check the ATF (trans oil) condition this good indiccator for your trans status . (burn mean clutch inside burn ) have small chips . change ATF and filter and make sure it;s in level.

Jun 22, 2011 | 1996 Toyota Tercel

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

85 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...