Question about Hyundai Elantra

Open Question

Finding 2010 Hyundai Elantra front jack points

Posted by Anonymous on


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

66 chrgr
  • 1011 Answers

SOURCE: finding crank sensor

Hello it will be located behind the timing belt and behind the crank pulley The timing belt DOES NOT HAVE TO COME OFF but the crank pulley does.

Posted on Jul 25, 2009

  • 171 Answers

SOURCE: how to replace 2002 hyundai elantra hub and bearing

With the car on ground, break loose the drive-axle nut, and the wheel nuts , than jack up the car, support it properly, remove the wheel ,remove the axle-nut.
Remove the brake caliper assembly-- support it properly.
Remove the two bolts that hold the hub bracket to the Macpherson strut assemble, remove the lower arm ball joint and remove the steering tie- rod ball-joint attached to the hub bracket. That's it.Slide off the hub /with the bracket off the drive-shaft.
Follow steps backwards to assemble back.

Posted on Apr 09, 2010

  • 776 Answers

SOURCE: i have a 2010 hyundai elantra and it is leaking

A 2010 Elantra?... it's still under warranty. Take it in to the Hyundai Service Dept and have it diagnosed & repaired under warranty.

Posted on Jun 29, 2011

  • 4803 Answers

SOURCE: how do you take the front driver side door panel

It is pretty easy, but care must be taken so as to not damage the door panel. I recommend purchasing a door panel clip removal tool for this purpose. They are available at most parts retailers for just a few dollars. Using these tools to relaese the plastic clips on the door panel can save you a lot of aggravation and expense.

> Remove the triangular-shaped cover that covers the inside portion of the door mirror mountings. It simply "un-clips".

> Remove the screw that retains the bezel over the indide door release handle and remove the bezel.

Remove the two scres retaining the door panel to the door frame. One is under the triangle cover behind the mirror that you removed, and the other goes straight down into the pocket of the door pull.

Then use the special door clip release tool (recommended) or another suitable tool to pop the clips loose around the perimeter of the door panel. Lift out and up to remove door panel.

Installation is the reverse order.

Posted on May 28, 2012

  • 21873 Answers

SOURCE: When do I need to change fuel filter in 2010

I don't show a fuel filter part number, so it is probably inside the gas tank. Most companies have gone to this style in the past few years.
You might check with the dealer to make sure.

Posted on Aug 24, 2012

Testimonial: "Great! Thanks!"

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Replace left front fender

Replace left front fender - Fixya
Dec 29, 2015 - replace left front fender - Hyundai Motor 2003 Elantra question. ...Question about Hyundai Motor 2003 Elantra. Open Question ... How do i remove left front fender clip on a Lincoln ls 2002? Jan 04, 2015 ' 2002 Lincoln LS.

Replace 2003 hyundai elantra front passenger outside door ...
Mar 26, 2013 - Question about Hyundai Motor 2003 Elantra. Open Question.Replace 2003 hyundai elantra front passenger outside door handle. Need to replacebroken exterior door handle on front passenger .... replace left front fender.

Dec 29, 2015 | Hyundai Motor 2003 Elantra

1 Answer

My Hyundai Elantra dashboard light don't come on and front right head light out

You either have a bad fuse or burnt out lamps. Fuse is easier to replace.

Aug 28, 2015 | 2010 Hyundai Elantra Touring

1 Answer

Where is the oil filter on a 2010 hyundai elentra

should be located either on the front (bumper) or rear (fire wall) of engine near the bell housing where the engine and transmission meet

Jul 25, 2011 | 2010 Hyundai Elantra

1 Answer

I have a 2010 hyundai elantra and it is leaking water from under the dash when it rains

A 2010 Elantra?... it's still under warranty. Take it in to the Hyundai Service Dept and have it diagnosed & repaired under warranty.

Jun 28, 2011 | 2010 Hyundai Elantra

1 Answer

I need to know what tools i will need to replace a cv shaft for on my front driver side 2000 hyundai elantra

HI there is nothing really special you need the only thing that really makes t easier is a puller to press the axel out of the knuckle. But the common tools will be A good floor jack, jack stands, metric wrenches and scoots up to 19mm a small 3# hammer and assorted length pry bars.

Aug 27, 2010 | 2000 Hyundai Elantra

2 Answers

How do I remove front rotors from a 2003 hyundai elantra

First jack the front end up. Then remove the wheels. Then remove the calipers. Then the rotors should fall right off the car into your hands. They are not pressed on or hubs

Jul 16, 2010 | Hyundai Motor 2003 Elantra

2 Answers

We can't find the rear jack points

They should be listed in your owners manual, if you don't have it,

Contact your local dealer service dept they will tell you where you can safely jack the car.

Mar 29, 2010 | 2006 Hyundai Elantra

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

77 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts


Level 3 Expert

78936 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8836 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides