Question about 1997 Mitsubishi Mirage

Open Question

Replace mitsibishi mirage 1997 transmission solenoids

Need to know how to locate remove and install TRANSMISSION SOLENOIDS

Posted by Anonymous on

3 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 5370 Answers

SOURCE: Shifting solenoids on 2002 Lancer.

For Automatic transmission problem,click the link below:---- Automatic transmission troubleshooting:----

http://howtobyme.blogspot.com/2011/11/automatic-transmission-will-not-go-into.html

---------
Automatic transmission shift lever issues?-------

http://technoanswers.blogspot.com/2012/01/automatic-transmission-shift-lever-hard.html

-----------
AUTOMATIC TRANSMISSION FLUID LEVEL? --

http://schematicsdiagram.blogspot.com/2011/07/how-to-check-automatic-transmission.html

--------------

AUTOMATIC TRANSMISSION FLUID AND FILTER?

http://schematicsdiagram.blogspot.com/2011/07/how-to-change-automatic-transmission.html

-----------
Transmission fault light on car dash?

http://schematicsdiagram.blogspot.com/2011/12/transmission-fault-light-on-car-dash.html

--------
Transmission shifting problem?

http://schematicsdiagram.blogspot.com/2012/01/transmission-shifting-problem-on-toyota.html

--------
Transmission Slips out of 2nd gear?

http://repairhelpcenter.blogspot.in/2012/02/transmission-slips-out-of-2nd-gear.html

-----------
OD light flashing and transmission fluid leaking?

http://repairhelpcenter.blogspot.in/2012/02/od-light-flashing-and-transmission.html

----------
Why Transmission fluid leaks near radiator?

http://repairhelpcenter.blogspot.in/2012/02/transmission-fluid-leaks-near-radiator.html

----------
Transmission fluid leaking?

http://technoanswers.blogspot.in/2012/02/ford-windstar-transmission-fluid.html

-------------
****** wont go in reverse?

http://technoanswers.blogspot.in/2012/02/dodge-neon-wont-go-in-reverse.html

-------------
Automatic transmission will not go into reverse?

http://technoanswers.blogspot.in/2012/02/dodge-automatic-transmission-will-not.html

----------
Transmission is making buzzing noise?

http://technoanswers.blogspot.in/2012/02/transmission-is-making-buzzing-noise.html

-----------

This will help.

Thanks.

Posted on Mar 02, 2012

  • 12 Answers

SOURCE: where is the transmission filter on a mirage

the filter should be inside the transmission pan. you will need to drop the pan carefully because it is full of fluid. once that is done the filter should be visable.

Posted on Apr 04, 2013

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

We're are the solenoids


only the maker knows this try them

Nov 23, 2015 | Cars & Trucks

1 Answer

How to replace auto transmission solenoids in audi a4b5 1.8 1997


In general you drain the transmission fluid from the pan, drop the transmission pan and filter, then the solenoids are readily visible and accessible. Disconnect the wiring harness on the solenoid and the fastener/lock on the solenoid and remove it. Worst case you may have to disconnect the solenoid wiring harness and drop the valve body. I've found audiworld a great source of information. Get a Bentley manual for your car.

Jun 22, 2014 | 1997 Audi A4

1 Answer

I have a 2007 Dodge RAM 1500. Where is the shift solenoid located.


All the shift solenoids are in the transmission. You will have to remove the oil pan from the bottom of the transmission to access these. All the solenoids are on a package/ housing. They come off as a unit. You can replace these one at a time, but you really need to know what your looking for. It could be a bad solenoid , bad wiring in the transmission, bad connection at the plug going to the transmission, bad wiring going to the transmission. Computers will pop out a code, but you have to check everything that is related to that sensor/ solenoid.

Aug 03, 2011 | 2007 Dodge Ram 1500 Quad Cab Sport

1 Answer

I have a 97 toyota camry 2.2, will not shift into overdrive.\r\ncode for the problem is PO755 B, where is this solenoid located. Transmission is A140E


solenoids on this vehicle transmission is located inside the transmission. You must drain the transmission oil, then remove the transmission oil pan to access it.

May 23, 2011 | 1997 Toyota Camry

1 Answer

When shifting into reverse or drive it take about 2 or 3 seconds to respond.now I only have low gear...no reverse or drive


You have solenoids in the valve body on top of the transmission that are failing. The best way to fix this is to either replace the entire valve body, which is very expensive, or just replaced the solenoids. There are five solenoids and a buss plate. The buss plate connects the external wires to the tops of the solenoids in the transmission. Replace all five solenoids and the buss plate and you should be good to go. Access to the valve body is pretty simple. Remove the battery and the battery tray and you will see the top transmission pan. Remove the electrical connector and all the bolts from the pan and then remove the pan. What you will see next under the pan is the valve body assembly. The solenoids are located inside the valve body. Remove the valve body top cover and you will see the solenoids. They pretty much just sit in there. I have replaced many of these solenoids for the same concern. On ocassion however there is some internal damage to the transmission. Out of the more than 50 of these I have done, I have had probably 2 that ended up needing the entire transmission.

May 19, 2010 | 1998 Saturn SL

1 Answer

My automatic transmission solenoid is causing check engine light to come on and locking transmission in 2nd gear. What needs to be done to replace the soleniod


Most transmission solenoids are located within the pan. If you replace the solenoids then it would be a good idea to change out the wiring harness that runs from the main transmission plug to the solenoids. Just lower the pan and drain it. Then, remove the one or two bolts that hold the solenoids in place. Replace the solenoids, wires, transmission filter and fluid at the same time (since you're already there). Make sure that you use a new pan gasket when you put the pan back on or it will leak fluid. Good Luck!

Nov 17, 2009 | 1999 Jeep Grand Cherokee

2 Answers

Location of the transmission solenoid on a 2003 s-10 chevy 4.3 4wd


Drop the pan ... There you will find the 1-2 and 3-4 solenoid in the valve body. They are both Identical and right next to each other toward the back
Disconnect the wire clips, then the Clips that hold the solenoids in.
Pull out the solenoids slowly as One is spring loaded but Slow is the key !!! you cannot screw up if you take your time and Pull them out SLOW...

Replace the old solenoid and reconnect the retaining clips, .. Wires and pan. Good luck and might as well replace the transmission filter since you have to remove it to get it out of the way.

Oct 24, 2009 | 2003 Chevrolet Avalanche

1 Answer

Code Reader reads Shifter Solenoid Stuck or Off


The Shift solenoids are located in the transmission oil pan. I would recommend replacing both shift solenoids while you're in there. Also replace the filter and pan gasket. The shift solenoids are located towards the rear of the valvebody and will be identical to each other. They are held in place by a retaining clip which is easily removed with a small screwdriver or similar tool. Care must be taken as parts may fly out of the bore when the solenoids are removed. Hope this helps.

Feb 10, 2009 | 1999 Chevrolet Astro

3 Answers

TRANSMISSION 2nd to 3rd GEAR HARDSHIFT


  1. the automatic transmission for bmw 328i 1997 move to front to rear

Jan 29, 2009 | 1997 BMW 328

1 Answer

AUTOMATIC TRANSMISSION GEAR SYSTEM PROBLEM


Yes,that code is a transmission code,pressure control solenoid A.On a Honda trans,there are two solenoids that control line pressure inside the trans.The two of them are made together into one assembly that Honda calls "Linear Solenoids".Most likely they are defective and need replacing,but require testing.They are mounted on the outside of the trans case,so the problem can be repaired without removing the transmission from the car.The actual diagnostic route for that trouble code involves ohms checking the wires from the vehicle computer to the solenoids.Ohms checking the solenoids,amps chekcing the solenoids,and then installing a line pressure gauge on the transmission to test the solenoids mechanically.I rebuild Honda and Acura transmissions on a regular basis,and solenoid failure is not out of the ordinary.Good luck.

Sep 13, 2008 | 2007 Honda Accord Sedan

Not finding what you are looking for?
1997 Mitsubishi Mirage Logo

Related Topics:

26 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7754 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...