Question about 2000 Lincoln Continental

Open Question

Replace light in dash clock on 2001 lincoln continental

Light in dashboard clock needs replaced

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
  • 8 Answers

SOURCE: how to replace an alternator on a 96 lincoln continental 4.6 V8

take out the top 4 bolts above the altenator, between those metal tubes on the metal bracket. then u have 1 bolt holding the wires to the altenator on that bracket aswell remove that. then remove the coolant reserve bottle and stick a breaker bar or rend of a ratchet in the tenchenor pulley square slot pull it back twords the head lights the belt will loosten then remove it from the altenator. then u will see 2 more bolts on the bottom side of the altenator by the pulleys and belt. Remove them 2 bolts all the way and the altenator will drop out of the bottom of them metal tubes and slide through the sides of them and its out... its very ez and does not need the tubes removed its a lot ezer than it looks.. sorry about my spelling im an infantryman not a teacher.

Posted on Feb 17, 2009

Ad
  • 740 Answers

SOURCE: NEED DIAGRAM FOR BELT REPLACEMENT AND INSTRUCTIONS

Here is a diagram of your belt, leave me a feed back and thanks for using FIX YA
http://www.2carpros.com/car_repair_information/tec_info/1999/lincoln/town_car/1999_lincoln_town%20car_drive_belt_routing_diagram.htm

Posted on Mar 19, 2009

VWdan
  • 114 Answers

SOURCE: Tie rod replacement- Easy or quick way.

yes total bs. A good front end shop should only charge about 3 hours for this job. I can do it in about a hour and a half.

Posted on May 04, 2009

  • 106 Answers

SOURCE: replacement

most discount automotive stores sell manuals for around $20 that show you step by step the procedure to replace the pump for your particular car

Posted on Aug 04, 2009

  • 1986 Answers

SOURCE: replace rear brake light bulb 1998 lincoln continental

pop the trunk and right behind where the lights are pull the carpet down and their will be of the following depending on the trim.

You will either see the light sockets themselves that you can twist and pull to change the bulb, or you will see the plastic nuts/screws that you can remove to remove the entire assembly in order to access the bulbs.

If it's your 3rd brake light, the screws to access the housing are located in the upper part of the trunk

Posted on Oct 26, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Spilled water on dashboard of my mk3 golf gti 2.0 8v,dashboard lights not working when i switch on main beam, can't see clocks


CHECK FUSES IF CLOCK OK THEN TAKE OUT THE DAHBOARD AND REPLACE THE BULB FOR HI BEAM INDICATION.DISASSEMBLE THE COVERS OF THE SWITCHES BEHIND THE STEERING WHEEL AND CHECK FOR WATER REMAINS.IF U NEED MORE INFO LET ME KNOW..

Dec 14, 2014 | Cars & Trucks

1 Answer

How do I replace the dashboard light on 2003 buick century


you will probably find it easier if you just take out the clocks and unplug the loom from them then its just twist and turn the bulb out find a replacement and hey presto

Nov 09, 2014 | 2003 Buick Century

1 Answer

Help our Honda Passport 2000 LX 4wd the light on the dashboard clock is off. Do I need to replace a bulb or fuse to get clock light to work? I can not find any information in the owners manual.


if all other dash lights work you will have to replace clock unit check to see if a bulb is available if so replace it but most clocks wont have a bulb that can be replaced check parts dept at dealer

Jan 13, 2011 | 2000 Honda Passport

1 Answer

How do I replace dashboard heater light? The glowing lights that indicate direction of air flow.


Heater light bulb, and all other bulbs for the air conditioning buttons, are on the same mini panel, and attached to the back of the radio front fascia. To dismount this fascia, you need 1) To pry out (no screws) the clock 2) Unscrew the one screw that holds the top of the fascia (screw is hidden behind clock) 3) Unscrew the two screws at the bottom of the fascia 4) Disconnect all connectors from the back of the fascia 5) Look for the burnt minibulb.
You could replace the bulb without disconnecting, but the cables are short, and the possibilities of marring your dashboard are high.

Jun 19, 2010 | 1999 Honda Accord

1 Answer

Dashboard light replacement


1) The clock slides out by carefully prying with a fine screw driver. Take care not to scratch the dashboard fascia. It has a mini light bulb in the back. take it to the dealer / parts shop so they can see the proper color. Accord dashboards came with 3 different color plastic covers on the bulbs. Also, when you take out the clock, you will be able to see the 3rd screw that is holding the a/c controls fascia.

Feb 03, 2010 | 1998 Honda Accord

1 Answer

Fuse replacement for my dashboard light, clock & lighter


check the fuse underdash by the driverside. the fusebox cover should have which fuse is which.

Aug 04, 2009 | 2002 Toyota Camry Solara

1 Answer

NO LIGHT DO NOT SEE TIME


You don't say which vehicle it is or whether the clock is built into the dashboard or is included on the instrument panel. (a) If it's built into the dashboard separately from the instrument panel, you need to remove the clock from the dashboard surround (it may just be a push-fit so if you can see the outer edges of the clock module try GENTLY using a small flat blade to ease the clock out of its receptacle). Once removed from the dashboard, disconnect the wiring plug, then look for a small bulb unit in the back of the clock module. Replace the bulb with a new one, reconnect the wiring connector and test that the clock lights up when the ignition is switched on before re-inserting the module back into its original location on the dashboard. (b) if the clock is part of the instrument panel, you will need to remove the instrument panel in order to get access to the relevant bulb (which will probably be on the rear of the instrument cluster directly adjacent to the location of the clock).

Jul 08, 2009 | 2003 Subaru Forester

1 Answer

How do I replace the clock light bulb?


THERE IS NOT A BULB U CAN REPLACE.THE CLOCK NEEDS TO BE REPLACED.

May 01, 2009 | 1998 Subaru Forester

3 Answers

1999 Honda accord dashboard clock light


use a eyeglass flat screww driver to pry the clock assembly up and out , disconnect the clock assembly and remove the bulb by twisting the the blue or sometimes grey round plastic bulb bottom to remove it from the assembly. install new bulb , twist clockwise to lock in place , reinstall assembly

Mar 21, 2009 | 1998 Honda Accord

Not finding what you are looking for?
2000 Lincoln Continental Logo

Related Topics:

183 people viewed this question

Ask a Question

Usually answered in minutes!

Top Lincoln Experts

yadayada
yadayada

Level 3 Expert

80637 Answers

fordexpert

Level 3 Expert

5687 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Are you a Lincoln Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...