Question about 1999 Honda Accord

1 Answer

I have one Honda Accord 1999. One time, when I was driving, brake and steering wheel locked; oil light, battery light and brake light were on. What's happened to my car?

When it happened, the engine didn't shut down. After that, I turned off the engine and turned it on again, my car still ran normally.

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Greenhorn:

    A rookie expert who has answered 20 questions on their first day.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 50 Answers

I have '99 accord LX 4cyl sedan and the ignition switch is a problem for these cars. I replaced my ignition 2 or 3 years ago because it would randomly shut off and sometimes not start back up right away. It only got worse until I fixed it, it would die on the highway or freeway sometimes. Haven't had that problem since. i think it cost like $240 or so. Also if you have an automatic, be careful, they are notoriously bad for going out after 100k miles. mine did and its an expensive fix. good luck.

Posted on Apr 20, 2013

Testimonial: "Thanks."

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
maklean
  • 1665 Answers

SOURCE: 1999 Honda Accord Coupe

See an example
DISASSEMBLY 1. Remove the suction pipe and the O-ring from the oil pump.
ad6db20.gif 2. Remove the rear cover with the gasket and pins. 3. Remove the cam ring. 4. Remove the rotor and vanes. 5. Remove the front side plate.
1868d6d.gif 6. Remove the inner and outer O-ring. 7. Remove the spring. When assembling, use a new gasket and O-ring.
47a7732.gif 8. Remove the pulley nut with the spring washer. 9. Pull off the pulley and the woodruff key.a12b5d7.gif 10. Remove the snap ring using snap ring pliers. 11. Drive out the pulley shaft with the bearing. If necessary, use plastic hammer

Posted on May 30, 2008

  • 25 Answers

SOURCE: 2003 Honda Accord Check Engine / Maintenaice Requeried

If you brought your car to Honda for service, they probably forgot to reset the maintenance reminder. If you took it to another shop, they probably did not know how to reset it. Anyway, the reset procedure is:

Put your key in the ignition
Turn the key to the II position for a couple of seconds
Then turn the key to the off position
Now push and hold in the odometer reset button
While still holding the odometer reset button, turn the key back to the II position
Hold for I think 10 seconds or so and your maintenance reminder light should reset it self.

Posted on Jun 20, 2008

polarcycle
  • 1392 Answers

SOURCE: car brake lights won t turn off when car is shut down 1996 Honda Odyssey

It should be your brake light switch. There is a little plate welded to the arm of the pedal that has a hole with a rubber stopper. The rubber stopper is most likely missing, or damaged. You should be able to take a flashlight and see the plate and the switch. If the hole is plugged up, you will need the brake light switch, if not, replace the plug.

Posted on Jun 02, 2009

Murphybanton
  • 2004 Answers

SOURCE: w reg honda accord se cuts out completely whilst

This is a fuel system problem.

Check the fuel pump located in the fuel tank beneath the back seat, and the fuel filter located in the hood.

Rate this.

Posted on Aug 30, 2009

  • 4044 Answers

SOURCE: brake lamp light on a 2002 Honda Accord SE

I assume you mean the one on the dash. This is an indicator that there is a problem in your braking system. Make sure it's not low on Brake fluid and have the brake system checked or check it yourself. If your going to check it yourself I recommend the Haynes repair manual on your vehicle as a reference.

Posted on Jul 30, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Key wont turn in ignition


03 steering wheel locked up and key won't turn - Honda Element ...

www.elementownersclub.com > ... > Maintenance and Service

Jun 8, 2010 - 11 posts - ‎6 authors
since Friday, I have not been able to turn my ignition key or unlock the steering wheel. i have already- used graphite lubes and sprays Dash lights won't turn off after exit and door lock - Honda ...
Aug 17, 2010
key won't turn, problem & fix
Sep 8, 2007
More results from www.elementownersclub.com

Honda Ignition Lock Repair - YouTube

? 10:49
https://www.youtube.com/watch?v=T01989YN2Ew
Jan 20, 2013 - Uploaded by Flip Keys
Learn to repair all types of Honda Steering Lock. Either wi... ... I am in NJ and dealing with a key that will sometimes not turn in the ignition cylinder on a 2005 Honda Element. .... (2006 honda accord ) .... It won't turn or come out. ... When you put the rightkey in the slot (and through the key reader part of the ...

Key Won't Turn in Lock - Drive Accord Honda Forums

www.driveaccord.net/forums/4.../219529-key-wont-turn-lock.html

Jan 14, 2016 | 2006 Honda Element

1 Answer

What does it mean when the maintenance required light flashes 10 times upon ignition?


most likely means a service is required , to check get the OBD codes read , this will tell you what the maintenance required is , i presume you've checked all the levels oil, coolant ,brake fluid,power steering fluid even washer bottle ?

Jul 08, 2014 | 1999 Honda Accord

1 Answer

I am using a honda of about 198,000 miles what precautions do i take to keep going,the car looks quite good. The model is 1999


Hi there

You'll need to do maintenance check on a regular basis. Basics for that is that on city driving, you change oil every 3 months or 3,000 kilometers. Regularly check the radiator fluid to avoid overheating and lastly... you have the wheels balanced and aligned (camber alignment) whenever you feel a wiggle or when the car starts favoring the right over the left.. almost forgot, brake fluid every year to rid of the moisture that could have accumulated from the lines.

hope this helps

Summary:

BLOWBAG -- B-batteries, L-lights, O-oil, W -water, B-brakes, A-air, and G-gas

Dec 28, 2010 | 1999 Honda Accord

1 Answer

1991 Honda Accord had the brakes change new rotors and pads. Drove 50 miles and the front drive axle where it goes into the front wheel looks and acts like it is stripped out. It's making bad noise if you...


Brake Disc (Rotor) REMOVAL & INSTALLATION 1990-95 Accord
  1. If equipped with an air bag, disconnect the negative battery cable and properly disable the Supplemental Restraint System (SRS), as detailed in Section 6 of this manual.
  2. Loosen the lug nuts, then Raise and safely support the vehicle on jackstands.
  3. Remove the wheels.
  4. Remove the steering knuckle from the vehicle. Please refer to Section 8 for procedures.
  5. Remove the 4 bolts retaining the hub unit to the steering knuckle and remove the hub unit. Fig. 4: Remove the 4 bolts retaining the hub unit to the steering knuckle and remove the hub unit/rotor assembly 86809032.gif

  6. Remove the 4 bolts, then separate the hub unit from the brake rotor. Fig. 5: Remove the 4 bolts, then separate the hub unit from the brake rotor 86809033.gif
    To install:
  7. Assemble the disc to the hub unit and tighten the bolts to 40 ft. lbs. (55 Nm).
  8. When installing the hub to the knuckle, use new self-locking bolts and tighten them to 33 ft. lbs. (45 Nm).
  9. Install the steering knuckle.
  10. Lower the vehicle and check for proper brake operation.
  11. If equipped, enable the SRS system and connect the negative battery cable.
prev.gif next.gif

Oct 29, 2010 | 1991 Honda Accord

3 Answers

What does the B1 warning light on Honda Accord mean? and how can it be reset


This is a service required warning light
B" indicates the following services are due:
- Change engine oil and filter, inspect brakes, check parking brake adjustment - Inspect : steering components, suspension components, rubber boots, brake lines, fuel lines, exhaust system, fluid levels and conditions "1" indicates: - Rotate tires

Sep 22, 2010 | 2007 Honda Accord Sedan

1 Answer

What does it mean when my brake lamp light comes on in my 1999 honda accord 4 cylinder


it means your brake pads are worn and as a result your brake pad pistons have had to be displaced well enough to lower the level of brake oil in the brake oil make up tank. You may need to top up your brake fluid or replace your brake pads.

Sep 13, 2010 | 1999 Honda Accord

1 Answer

Inatallation 92 honda accord power steering pump


Hey, here's the procedure, disable air bag, if equipped w/ one, disconnect the pump return hose from the reservoir and place the end in a large container. Plug the port in the reservoir. Start the engine and turn the steering wheel lock to lock several times, until fluid stops running from the hose. Turn off engine immediately. Re-attach hose. Disconnect the inlet and outlet hoses at the pump. Remove the drive belt. Remove the mounting bolts/nuts and remove pump.
Install in reverse order. Adjust belt tension,fill ps reservoir and bleed any air from the system (to bleed air from system, fill reservoir, start engine and allow to idle, turn wheel from side to side all the way several times. Shut off, fill if necessary.
. Tighten bolts to : Thru bolt 30 ft lbs., mounting nut 16 ft lbs.

Dec 26, 2008 | 1992 Honda Accord

1 Answer

Maintenance


120,000 Miles (192,000 Kilometers) : All Applicable Models OPERATION COMPONENT ADJUST DRIVE BELTS, INSPECT AIRBAG SYSTEM Ten years after production. INSPECT BRAKE HOSES & LINES Including ABS. INSPECT DRIVESHAFT/PROPELLER SHAFT DUST BOOTS, INSPECT ENGINE COOLING SYSTEM HOSES & CLAMPS, INSPECT EXHAUST SYSTEM, INSPECT FLUID & LUBRICANT LEVELS, INSPECT FRONT BRAKE SYSTEM, INSPECT FUEL LINES & CONNECTIONS, INSPECT LIGHTS & CONTROLS, INSPECT PARKING BRAKE Adjust if necessary. INSPECT REAR BRAKE SYSTEM, INSPECT STEERING GEAR/RACK, INSPECT STEERING RACK BOOTS, INSPECT SUSPENSION COMPONENTS, INSPECT TIE ROD ENDS, INSPECT VEHICLE UNDERBODY, INSPECT WATER PUMP. REPLACE AIR CLEANER ELEMENT, REPLACE AUTOMATIC TRANSAXLE FLUID, REPLACE ENGINE OIL, REPLACE ENGINE OIL FILTER, REPLACE MANUAL TRANSAXLE FLUID, REPLACE SPARK PLUGS, REPLACE TIMING BELT If it is an In-Line4 OPERATION COMPONENT INSPECT VALVE CLEARANCE, REPLACE BALANCER BELT.

Oct 08, 2008 | 1997 Honda Accord

2 Answers

Ignition is locked


You can try a combination of things, one suggestion i have is to turn the wheel in any free motion it can, and turn the key, or PUSH the key into the ignition and try it that way, or there is a little push button to get the key turning.

Oct 05, 2008 | 1996 Honda Accord

Not finding what you are looking for?
1999 Honda Accord Logo

257 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

76848 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...