Question about 2006 Jeep Grand Cherokee

Open Question

What is the minimum rpm at idle for 2006 jeep grand cherokee

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: 2002 jeep cherokee laredo

the only problem that vehicle has is with cooling fans is relay/module or electrical harness to module that burns up located behind and under right front headlamp assy must remove headlamp to access relay/module that is what powers up fan motor module assy.

Posted on Aug 10, 2008

johnnyblazen
  • 6 Answers

SOURCE: change the time on the clock in a 2006 jeep grand cherokee

Hold the time button down until the time blinks and you can use the Tuner to set the time. Push the tuner in to switch from Hours/Minutes and when you're done just wait till it stops blinking.

Here's the manual too if you want it.

Posted on Mar 11, 2009

66 chrgr
  • 1011 Answers

SOURCE: 2004 jeep grand cherokee idling problem

check your throttle position sensor and idle air control solenoid.

Posted on May 14, 2009

  • 1 Answer

SOURCE: 2004 jeep grand cherokee idling problem. Revs motor 200 to 500 rpms higher while driving.

I had the exact same problem on my 04 GC. I put some Techron Concentrate Plus Fuel System Cleaner in from Wal-Mart and it seemed to fix the problems right away. Let me know.

Posted on Jun 01, 2009

  • 90 Answers

SOURCE: HOW TO REMOVE HEADLIGHT ASSEMBLY 2006 JEEP GRAND CHEROKEE

remove the 7mm bolt in the centre top of lamp unit then with a big screwdriver just behind headlamp prise outwards quite firmly

Posted on Jul 03, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Loud idle running hot


loud,
my guess, wild, is its not noise, (rattling or banging etc)
its just too high RPM ?
HOt.
the RPM is 800 RPM ,if not?idle controls are out of control

Nov 25, 2013 | 2006 Jeep Grand Cherokee

1 Answer

Jeep Grand Cherokee shuts off at idle while stopped. RPM fluctuates then engine eventually dies.


your idle air control valve is going out located behind the throttle body.

Feb 12, 2013 | 2001 Jeep Grand Cherokee

2 Answers

2002 jeep grand Cherokee change batt. Now it starts but won't run?


Because you disconnected the battery you lost the long trim value,you will now have to relearn the idle,start the vehicle idle it to 1500 RPM,hold for a minute,idle should stabilize,turn on A/C let it idle,for a minute,now your done,

Aug 19, 2012 | 2002 Jeep Grand Cherokee

1 Answer

Red lightining sign on dash grand 2006 grand cherokee jeep


Your alternator is not charging, thats fine when the motor isn't running but if it is running you are on borrowed time and it won't be shortly. If you need to drive some distance to reach an auto electrican charge the battery up first and use the minimum number of electrical accessories possible while you are driving there.

Jun 02, 2012 | 2006 Jeep Grand Cherokee

1 Answer

I have a 2006 grand cherokee. Sometimes without warning when I come to a stop (after driving with no lights,warning,etc.) My truck hesitates when I accelerate. The rpm's go all the way up, and my truck...


could be a bad idle control valve. causing idle surge and rise and stick open to allow a large vacuum leak in your manifold which would cause those Symptoms of rough acceleration and loss of power similar to a missfire.

Mar 16, 2011 | 2006 Jeep Grand Cherokee

1 Answer

I have a '97 Jeep Grand Cherokee Laredo 4.0 liter that won't idle


Check your throtle postition sensor. It monitors what postion the throtle is at and sends that info to the ecm. It will go bad and cause that problem.

Feb 09, 2010 | 1997 Jeep Grand Cherokee

1 Answer

1997 jeep grand cherokee. low idle 500 rpm, runs fine but letting off the throttle it dies. starts right back up fine.


Most of the time an engine is supposed to idle at 5-600 RPM in Driveif it's not you can up the idle. But you also may have a vaccume leak.

Dec 21, 2009 | 1997 Jeep Grand Cherokee

1 Answer

2004 jeep grand cherokee idling problem


check your throttle position sensor and idle air control solenoid.

May 14, 2009 | 2004 Jeep Grand Cherokee

1 Answer

Rpm for a 1990 cherokee laredo


Should idle at 750-875. I would not exceed 950 and would not go below 700.

Dec 31, 2008 | 1997 Jeep Grand Cherokee

3 Answers

Rough idle stalls at low rpm's


check your transmission fluid,the motor will stall when fluid is low

Dec 06, 2008 | 1996 Jeep Grand Cherokee

Not finding what you are looking for?
2006 Jeep Grand Cherokee Logo

Related Topics:

47 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

75005 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7711 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...