Question about Cars & Trucks

1 Answer

Where is the TCC solenoid on a 2000GMC yukon xl 4x4? is it inside the transmission pan or does it go on from the outside?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Genius:

    An expert who has answered 1,000 questions.

  • Master
  • 1,150 Answers

It is inside the transmission.

Posted on Apr 20, 2013

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 289 Answers

SOURCE: 2002 Sunfire TCC Solenoid replacement

hi..the transaxle converter clutch . tcc. uses a solenoid -operated valve located in the automatic transaxle to mechanically couple the engine flywheel to the output shaft of the transmission through the torque converter.that reduces the slippage loss in the converter.reducing emissions.but check the vss first.which is called the vehicle speed sensor.they both work together .if the vss is not working right it wont call on the tcc.
check this out..
thank u..
rate me..

Posted on Mar 06, 2009

Molson02536
  • 3854 Answers

SOURCE: p1744 enginge code tcc solenoid circuit

DTC P1744 is "TCC - Excessive Slip Detected During Full TCC Engagement". Which means that the Torque Converter Clutch (TCC) is disengaged or the EPC pressure is at the minimum.

The most likely cause is a sticking or bad TCC solenoid inside the transmission. You can check the connector at the transmission to make sure it is clean and tight and that it is not damaged in any way.

If the TCC and wiring is okay, then pressure testing of the transmission will need to be done.

A new torque converter from Ford is about $265.00 and about 4 hours labor. Throw in a $40.00 TCC solenoid and I don't think it'll be more than $700.00 at worst.

If the pressure test is good then it's just going to be the $40.00 tcc solenoid and the cost of the transmission oil and filter changed which should be around $150.00

Good luck and hope it's just a loose wire harness to the solenoid which would cost $0.00 and just your time to locate the break in the wire. The other thing to, is to add a transmission fluid additive that would restore the clutch pack in the transmission and Torque Converter.

Posted on Nov 17, 2009

Testimonial: "thanks a lot very helpful and detailed explanation"

  • 61 Answers

SOURCE: to change the tcc solenoid can it be done by

The transmission will not have to be removed for this, however, the valve-body assembly will need removal. This can be accessed by taking off the pan on the transmission.

Posted on Nov 17, 2009

Testimonial: "very helpful thank you "

  • 37 Answers

SOURCE: Transmission Solenoid

Not Hard at all... www.TransmissionGarage.com

Posted on Dec 30, 2009

  • 14585 Answers

SOURCE: I need to now if if the transmission 3-2SHIFT

It's on the inside. it's part of a package. try some tranx first. get it at a parts store

Posted on Jun 16, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Where is the shift solenoid located in a 2001 Isuzu' rodeo 3.1 liter and how many are their


it's located inside the bottom of the transmission pan You have to remove the pan to get at it and replace it.

Sep 13, 2016 | 2001 Isuzu Rodeo

3 Answers

Where is the TCC solenoid located


It's in the transmission. Remove the trans pan and it is on the solenoid package. But the solenoid may not be the problem. Could be the wiring, plugs(inside and outside the trans), torque converter, or the computer. 7b32d407-41bb-449c-8dd9-0a5f7effbf7f.gif

May 14, 2014 | 2004 Chevrolet TrailBlazer

1 Answer

2002 Yukon denali xl won't shift into first


first do you have any transmission fault code.On a few code pcm act like : no first gear, no tcc , and so on, PCM try to protect transmission when code are set.

Sep 27, 2013 | GMC Cars & Trucks

1 Answer

Is the module and/or solenoids inside of the transmission or outside of the transmission on a 1993 ford F250?


The transmission control module is part of the engine controller in the firewall behind left fenderwell.There is a solenoid block inside the Transmission pan that contains 5 solenoids , 2 shift,1 coast , 1 tcc and 1 pressure control.Various engine sensors also input into the transmission controller such as TPS ( throttle position sensor ) , map/mass ( engine load ) , and engine rpm.Also there is a trans temp sensor built into solenoid block and a range sensor on the side of trans that tells the computer where there gear selector is.Vehicle speed sensor also inputs into transmission controller.It takes a lot of data to decide what gear the transmission should be in.

Feb 25, 2011 | Ford F-250 Cars & Trucks

1 Answer

Where is the Transmission Solenoid Located for 2001 cadillac deville, inside or outside transmission. i have a transmission trouble code of p0741. Transmission runs good, it shifts normal as always. i...


The TCC solenoid is located inside the transmission. Replacing the solenoid usually does not fix the problem when it comes to a P0741 code. It is usually due to debris getting caught in the TCC regulator valve or the tubine shaft seals being worn out. This usually results in a transmission overhaul.

Dec 27, 2010 | 2001 Cadillac DeVille

2 Answers

Whats a tcc solenoide


TCC stands for "TORQUE CONVERTER CLUTCH" this is part of the torque converter of thetransmission and is controlled by an electric solenoid inside the transmission pan attached to the trans valve body.

Jan 31, 2010 | 1996 Nissan 200SX

2 Answers

Transmission not shifting into overdrive.


check and replace the VSS (vehickle speed sensor) IT IS ON THE OUTSIDE OF THE TRANSMISSION

Nov 05, 2009 | 1993 Saturn SL2

2 Answers

2002 Sunfire TCC Solenoid replacement


hi..the transaxle converter clutch . tcc. uses a solenoid -operated valve located in the automatic transaxle to mechanically couple the engine flywheel to the output shaft of the transmission through the torque converter.that reduces the slippage loss in the converter.reducing emissions.but check the vss first.which is called the vehicle speed sensor.they both work together .if the vss is not working right it wont call on the tcc.
check this out..
thank u..
rate me..

Mar 06, 2009 | 2002 Pontiac Sunfire

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

16 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75051 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...