Question about 2001 Nissan Sentra

Open Question

Where is the MAP sensor on a 2001 Nissan Sentra

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
pal03246
  • 726 Answers

SOURCE: 2001 Nissan Sentra Block Heater

You can't find one, because it doesn't have one.

Posted on Dec 17, 2008

Ad
  • 4 Answers

SOURCE: 2004 nissan sentra starts the stops. acts like

check your ecm connection

Posted on May 08, 2009

cj2176
  • 520 Answers

SOURCE: Where is the blower resistor on a 2001 Nissan Sentra?

Its actually not that bad to change. If you open the glove box and remove the screws then the screws along the bottom of the glove box at the bottom of the dash the box will slide out. Remember to disconnect the light if it has one. Now you will be able to see the underside of the dash. You can see a large black box that has wires and vacuum lines all over. You need to locate a small flat plate with two screws and a plug in the middle. Disconnect the plug and remove the screws. The resistor will come straight out. The back side will look like small coiled up springs of different sizes. Install in reverse.Hope this helps. Good luck. Please re-post with updates. Thanks cj2176.

Posted on Jul 13, 2009

  • 1986 Answers

SOURCE: where is 02 bank 2 sensor 1 placement on a 2001

Bank 1 means it's on the same side as your cylinder 1
Sensor 1 is the sensor that is located before the catalytic converter.

Posted on Sep 10, 2009

  • 752 Answers

SOURCE: I have a 2003 Nissan Sentra SE-R Spec V. o2 sensor location?!?1

theres always one on the intake manifold working its way down to catalytic convertor is the oxygen sensor 1 heater circuit(pre cat conv) signal while terminal #25 is oxygen sensor 2 heater circuit (post cat conv)

Posted on Feb 12, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Donde se encuentra el sensor map baro de mi nissan sentra 2000 1.8


Hola, eso se encuntre entre la manguera en donde entra aire a la cabina en donde se encuentra el filtro de Aire. Incluire un video para que veas en donde esta. Buena Suerte!

Jan 13, 2014 | 2000 Nissan Sentra

1 Answer

2001 nissan sentra 1.8L 4cyl. running codes P0105:P1605:P0171:P0325... engine idles fine when in park just not in gear, in gear it shakes pretty bad, also hesitates to accelerate when you press on gas...


code po105 refers to manifold absolute pressure(MAP)sensor/barometric pressure (BHARO) sensor -circuit malfunction==causes--wiring MAP sensor--BARO sensor--ECM
code p0171 refers to system to lean bank 1===causes intake/exhaust leak---AIR system MAF/MAP sensor fuel pressure /pump /injectors--HO2SW
code p0325 refers to knock sensor(KS) 1 bank 1-circuit malfunction====causes--wiring ---poor connections---KS
Check the exhaust flexible pipe at the manifold for cracks
have a fuel pressure test done on the fuel manifold to determine either pump/ filter or pressure regulator.
replace HO2S unit

Sep 21, 2013 | Cars & Trucks

2 Answers

1998 nissan sentra lost pick up speed and is jerking


first remove your map sensor and clean it with carburetor cleaner let it soak for a few hours and then reinstall it sometimes they get dirt or carbon build up and the pcm cant tell how much fuel to send

Jan 27, 2010 | 1998 Nissan Sentra

1 Answer

Seeking location of speed sensor 2001 sentra


Vehicle Speed Sensor is IN the Transaxle-is your ecu indicating VSS circuit is open? Check out Nissan Forums.com If so, most likely, the sensor is bad or unplugged.Circuit includes sensor,wiring from sensor to the ecu,and the ecu itself.

Dec 21, 2009 | 2001 Nissan Sentra

1 Answer

I need to know where the crank position sensor is on a 2001 nissan sentra GXE 1.8L . and which oxygen sensors are which numbers


it is wher the engine meets the transmission..on the flywheel...and the oxygen sensors bank 1 is the one before the catalyst....and bank 2 is the one after the catalyst....

Nov 13, 2009 | 2001 Nissan Sentra

1 Answer

Where is 02 bank 2 sensor 1 placement on a 2001 nissan sentra


Bank 1 means it's on the same side as your cylinder 1
Sensor 1 is the sensor that is located before the catalytic converter.

Sep 10, 2009 | 2001 Nissan Sentra

1 Answer

Crank sensor position location


Follow your plug wires to coil pack and module. Once you found the module, follow the wires from there to crank sensor on engine block.

Aug 06, 2009 | 2001 Nissan Sentra

Not finding what you are looking for?
2001 Nissan Sentra Logo

Related Topics:

63 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...