Question about 2004 Honda Accord
About to sell my 2004 Honda Accord Coupe.... need to disable the buttons. Not sure how to. Help?
Have you tried to disconnect the battery for a couple minutes and let it all reset?
Posted on Apr 20, 2013
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: 1999 Honda Accord Coupe
See an example
DISASSEMBLY 1. Remove the suction pipe and the O-ring from the oil pump.
2. Remove the rear cover with the gasket and pins. 3. Remove the cam ring. 4. Remove the rotor and vanes. 5. Remove the front side plate.
6. Remove the inner and outer O-ring. 7. Remove the spring. When assembling, use a new gasket and O-ring.
8. Remove the pulley nut with the spring washer. 9. Pull off the pulley and the woodruff key. 10. Remove the snap ring using snap ring pliers. 11. Drive out the pulley shaft with the bearing. If necessary, use plastic hammer
Posted on May 30, 2008
SOURCE: 2005 Honda Accord
behind the inside door handle by removing the inner cover you well find two screws remove them by the inside grab handle on the door there is a small rubber mat remove the mat on the upper right corner is a trim piece it just pops off once the screws and trim is removed use a small screw driver and go below the door panel and wedge it between the panel & door and pull back on the screw driver until you here a pop the door panel is held on by plastic clips :caution--when removing the panel DO NOT YANK ON THE DOOR PANEL. THE INSIDE DOOR HANDLE IS STILL ATTACHE D TO THE DOOR PANEL. if you dont unhook this cable before removing door panel you will break the plastic end of the cable if you break this you will have to replace the cable then this well involve removing the latch because the cable is hooked inside the latch hope this helps
Posted on Dec 02, 2008
You did not clarify which motor you have. Here are both diagrams.
The fuel injected model:
And the carb model:
Posted on Sep 10, 2009
Testimonial: "Guru this is amazing I have to ask where did you find this I have been on the web for days and just couldn't find one till now --I bow down God Bless"
remove upper and lower hoses
remove 2 10 ml bolts on top lift rad out and insert new rad
if there is auto trans remember to undo the lines from the rad
allways replace ruber bushings if the fall our or are missing
Posted on Jan 03, 2010
I show immobilizers where only started in the 1998 accords, if you have a remote starter and they used a key in the box bypass all you need to do is find the box under the dash open it up and use the key
Posted on Jan 31, 2010
Tips for a great answer:
Aug 16, 2016 | 2008 Honda Accord Coupe
May 27, 2016 | 1992 Honda Accord
Jan 23, 2016 | 1992 Honda Accord
Apr 28, 2014 | 2004 Lincoln Navigator
Dec 09, 2013 | 2006 Honda Accord
Jan 22, 2012 | 2004 Honda Accord Coupe
May 17, 2011 | 2000 Honda Accord
Mar 09, 2011 | 2004 Honda Accord
May 20, 2010 | 2004 Honda Accord
Feb 03, 2009 | 2004 Honda Accord
29 people viewed this question
Usually answered in minutes!