Question about Cars & Trucks

Open Question

How do i adjust the headlights on my 2004 ford f-150 lariat

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: My 2004 F-150 Ford Truck will not engage into 4 wheel drive low.

I am going to ask a dumb question....do you have it in neutral and the brake mashed when you switch to 4WD LOW? I believe that is what my book says to do.

Posted on Oct 27, 2008

Ad
  • 2 Answers

SOURCE: can't adjust 2004 Ford Expedition headlight

I had a similar problem on my 04 expedition. I just bought it and the headlights were aiming too far down. A rather larger gap was noticeable between the headlight and the hood. The so called adjustment bolt did nothing. I removed the headlights and found 2 issues. On the adjustment bolt there is a washer. Make sure when you re-install the headlight the washer sets on top of the plastic slot and is visible when looking down behind the headlight. Without the washer being in the correct location it will not tighten the headlight in place.
Second I found the adjustment bolt adjusted nothing. It merely tightened the headlight in place. What I had to do was to loosen this bolt and physically move the headlight into place and the re-tighten the bolt. Hence the slot is the adjustment. Turning the bolt CW or CCW did not move the headlight.
I tried several things trying to figure why the lights would not move until I realized I could move the light with my hands and tightened them in place using the adjustment bolt.

This may not be your issue but I found the owners manual instructions to be useless.

Posted on Jan 02, 2009

  • 1779 Answers

SOURCE: 1988 ford truck f-150 xlt lariat cant get current to fuel pump

Have you checked the 'inertia switch' which in the event of an accident shuts off the fuel supply to prevent a fire . It's usually located in the cab on pass. side. Some models have one reset button, some 2 which have to be pressed at the same time. If that's not it, here's how the power to the pump SHOULD work, you will have to follow the path to see where it stops. When you turn the key on it turns on the EEC power relay on, this relay then provides power to the PCM (power control module) and the control side of the fuel pump relay. Power for the fuel pump is supplied through a fuse link or high current fuse attached to the starter solenoid (battery side). From the fuse link or high current fuse current flows thru the fuel pump relay and inertia switch to the fuel pump. The fuel pump relay is controlled by the PCM. When the ignition switch is turned on the fuel pump will operate, if the switch is NOT turned to start position, the PCM will shut off the fuel pump off after 1 second. This is to avoid flooding the engine when it is not running, just key on. So check out to see if you have a fuse link or a high current fuse and if they are blown.

Posted on Apr 15, 2009

  • 1986 Answers

SOURCE: adjusting headlights on my 2004 ford taurs

The adjustment screws/nuts should be located either on the top of the headlamp assembly, behind the headlamp assembly, or near the frame rail by the radiator support.

You will have vertical adjustment screws for each independent beam (separate highs and separate lows, but will be same screw if highs and lows are the same bulb). You may also have additional horizontal adjustment screws as well

Park your car on a level ground 30 feet from a wall and measure the height from the ground to the bulb and mark on a wall (do this for highs beams and low beams if the bulbs are separate, if highs and lows are the same bulb, only do it for the lows)

For Low Beams: If the headlights read VOR, then aim the brightest part or cutoff part just below the mark on the wall. If it says VOL or nothing, aim them 2 inches below the mark on the wall.

For High Beams (if separate from low beams): Aim the headlight directly at the line you marked on the wall.

Posted on Oct 05, 2009

  • 1986 Answers

SOURCE: how do i adjust headlights on 2004 ford ranger?

The adjustment screws/nuts should be located either on the top of the headlamp assembly, behind the headlamp assembly, or near the frame rail by the radiator support.

You will have vertical adjustment screws for each independent beam (separate highs and separate lows, but will be same screw if highs and lows are the same bulb). You may also have additional horizontal adjustment screws as well

Park your car on a level ground 30 feet from a wall and measure the height from the ground to the bulb and mark on a wall (do this for highs beams and low beams if the bulbs are separate, if highs and lows are the same bulb, only do it for the lows)

For Low Beams: If the headlights read VOR, then aim the brightest part or cutoff part just below the mark on the wall. If it says VOL or nothing, aim them 2 inches below the mark on the wall.

For High Beams (if separate from low beams): Aim the headlight directly at the line you marked on the wall.

Posted on Nov 04, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the location of the fuses for the headlights


location of the fuses Marcos, headlight and DRL fuse locations 40,23,25,R03. See your manual or check links. Check the attached links,instruction and guides, Good luck
"I hope this helped you out, if so let me know by pressing the helpful button. Check out some of my other posts if you need more tips and info."
Ford 150 Fuse Box Diagram
Headlight Fuses F150online Forums
Ford Series XIII 150 F150 2004 2014 fuse box diagram Auto Genius

Jul 24, 2016 | 2004 Ford F150

1 Answer

I have a 1988 ford f-150 xlt lariat with a 302.my battery keeps going dead.I pulled the battery terminals off while running and turned on headlights and fan blower and it didnt shut off,does this mean


Check and make sure no interior lights are on, the most common is the vanity lights in the visor drawing the battery down or the interior lights coming on at night from a defective switch inside one of the doors

Nov 30, 2012 | 1988 Ford F 150

1 Answer

Which fuse is for licence plate light on a 2004 ford f 150 lariat


The license plate light is probably tied in with the parking light fuse. check the headlight fuse.

Mar 30, 2011 | Ford F-150 Cars & Trucks

1 Answer

2004 f150 lariat left turn signal won't blink when headlights are on it just stays on


One of the turn signal bulbs is blown or the flasher needs replaced.

Feb 09, 2011 | 2004 Ford F150

1 Answer

How to replace dashboard lights 2006 f-150


have you tried the dimmer switch? its not normal for those to go bad especially all of them at once could possibly be a bad insterment panel

May 10, 2010 | 2006 Ford F-150

2 Answers

Rear power sliding window doesnt work fuse ok 2004 f 150 larait


Same on my '03 Lariat SuperCrew. I took out the "electric motor" aka 'regulator' and replaced it with a salvage - $150.
Got home and connected both of them separately - they both work for 1/4 of a second, then they cease working for no rhyme or reason. I'm angry because I just blew $150, and the problem hasn't been solved. Looking at the switch next.

Jun 11, 2009 | 2006 Ford F-150

1 Answer

I have a 2005 F-150 Lariat 5.4L. I turn the 4X4


sound like the transfer acuator failed

Jun 04, 2009 | 2004 Ford F150

1 Answer

My 2004 F-150 Ford Truck will not engage into 4 wheel drive low.


I am going to ask a dumb question....do you have it in neutral and the brake mashed when you switch to 4WD LOW? I believe that is what my book says to do.

Oct 24, 2008 | 2004 Ford F150

2 Answers

Ford f-150 lariat super crew


hey very frustrating i know mine does the same it looks to me that the problem is revolving around the throttle body or the tps throttle positioning sensor i was looking at all the postings on here sounds legit

Sep 22, 2008 | 2004 Ford F150

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

41 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76070 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...