Question about 2001 Mazda Tribute
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: My 2001 Mazda tribute column
The same thing happened to my 2001 Mazda Tribute. It was stuck in Neutral. The shifter cable fell off the little metal post under the steering column. To fix it I removed the plastic column covers. Put the round end of the cable back on the little silver colored post. Then secured it on the post with a ring type push nut from Ace Hardware. Total cost of repair was sixty cents. The cables are not always broken. They just fall of the little post.
Posted on Jul 20, 2009
Car Radio Battery Constant 12v+ Wire: Orange/Light Green
Car Radio Accessory Switched 12v+ Wire: Yellow/Black
Car Radio Ground Wire: Black
Car Radio Illumination Wire: Light Blue/Red
Car Stereo Dimmer Wire: N/A
Car Stereo Antenna Trigger Wire: N/A
Car Stereo Amp Trigger Wire: Light Blue
Car Stereo Amplifier Location: N/A
Car Audio Front Speakers Size: N/A
Car Audio Front Speakers Location: N/A
Left Front Speaker Positive Wire (+): Orange/Light Green
Left Front Speaker Negative Wire (-): Light Blue/White
Right Front Speaker Positive Wire (+): White/Light Green
Right Front Speaker Negative Wire (-): Green/Orange
Car Audio Rear Speakers Size: N/A
Car Audio Rear Speakers Location: N/A
Left Rear Speaker Positive Wire (+): Gray/Blue
Left Rear Speaker Negative Wire (-): Brown/Yellow
Right Rear Speaker Positive Wire (+): Black/Violet
Right Rear Speaker Negative Wire (-): Orange/Violet
Posted on Sep 29, 2009
This is actually a little tricky, open the hood, there will be a single screw holding the turn signal lamp in place take that off, here's the tricky part, take two flathead screw drivers and place them on either side of the turn signal housing pry it back and forth a little bit, it should begin to slide out directy in front of the car, it has tracks kind of like a dresser drawer, when you done replacing the light, just slide it back in and tighten the screw .
Posted on Oct 09, 2009
Tips for a great answer:
Jul 02, 2016 | Mazda Cars & Trucks
Jul 25, 2011 | 2001 Mazda Tribute
May 26, 2010 | 2001 Mazda Tribute
Jan 19, 2010 | 2001 Mazda Tribute
Nov 19, 2009 | 2005 Mazda Tribute
Jul 14, 2009 | 2001 Mazda MPV
Jun 16, 2008 | 2002 Mazda MPV
88 people viewed this question
Usually answered in minutes!