Question about Hyundai Motor 1998 Accent

2 Answers

MY CLUTCH STARTED SQUEEKING WHEN PRESSED

I've got a hyundai accent coupe e and my clutch started squeeking when the pedal was pressed so i put wd 40 on the joint that goes into the rubber plug into the gearbox but it may have gone in the rubber plug then i lost my clutch entirely but i started it up took the cap off the clutch fluid reservoir and pumped the clutch it's now come back enough to change gears but it doesnt seem 100 per cent and i fear the clutch tottally goin agian any body know wat could have caused the squeeking in the first place and if the wd40 could of lost the clutch completely or wat it could be thanx

Posted by on

  • linky1982 Mar 11, 2009

    thanks alot for help cheers

×

2 Answers

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 14 Answers

Dont use wd40 on it that will mess up the clutch the problem is in the throw out bearing when you put your foot on the clutch that ingages clutch and throw bearing together thats where the noise is comimg from bearing need to be replaced but you replace bearing replace everything in clutch

Posted on Mar 11, 2009

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 1,050 Answers

The squeaking would have either been caused by the clutch release bearing or the pilot bearing in the crankshaft if it has one (pilot bearing). It doesn't really matter as the transmission has to come of to repair either of these. It is hard to tell what you were describing, but whatever you do, don't spray any more WD 40 at anything! It will ruin your clutch and clutch fluid if it comes in contact with either. If the clutch fluid reservoir gets low, only use new brake fluid to top it up.

Posted on Mar 11, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 1998 accent gl makes a pressure like noise when i press the clutch down


This could be a dry pedal shaft bush ( bit of WD-40 spray) or the first signs that the master cylinder rubbers are dry and the cylinder is facing replacement.

Apr 09, 2014 | Hyundai Motor 1998 Accent

1 Answer

What is the ignition immobilizer on a 2000 accent


Hello William. On standard transmissions you have to press down the clutch to start the car, and on automatic transmissions you have to press down on the brake pedal in order to start the car. Look for your immobilizer under the dash at clutch or brake pedals depending on trans. Hope this was helpful, GOOD LUCK.

Oct 07, 2011 | 2000 Hyundai Accent

1 Answer

How do I determine if my clutch pedal ignition lock switch is bad on a 1996 Hyundai Accent?


YOUR CLUTCH START SWITCH.ENGINE SHOULD NOT START WHEN CLUTCH PEDAL RELEASED. YOUR ENGINE SHOULD START WHEN YOUR FOOT DEPRESSED CLUTCH PEDAL TO FLOOR..

Feb 23, 2011 | 1996 Hyundai Accent

1 Answer

Accelerator squeeking and internal crunching


Acc. squeek noise due to linkage issue, get it lubicated.

Regarding the clutch, you check the links, clutch plate springs condition. If there is wornout parts get it replaced. Gear shifting will be solved once you fix your clutch problems.

Jun 04, 2010 | 1998 Hyundai Elantra

3 Answers

2002 Hyundai Accent won't go into gear.


Probably the arm that holds the rtelease bearing in the bell housing has slipped out of place. Get someone to depress the clutch while you check the arm is not loose. If the cylinders are working then its most likely the arm is disconected. If you are lucky you may get it put back in place by looking through the inspection hole but most likely you will have to seperate the engine and gearbox. Sorry I havent better news for you.

Aug 06, 2009 | 2003 Hyundai Tiburon

2 Answers

Hyundia accent needs push started


IF THE STARTER WON'T CRANK U MAY HAVE A BAD CLUTHC SWITCH.IT IS ON THE CLUTCH PEDAL AND ONLY ALLOWS POWER TO THE STARTER W/CLUTCH PEDAL IS FULLY DEPRESED

May 06, 2009 | 2000 Hyundai Accent

1 Answer

I have a hyundai accent coupe e 1998 and now and again when i press the brake theres a kind of squeeking noise any ideas what it could be.


if u suspect a problem with your brakes inspect them or have them inspected! when they start making noise usually its time for new ones.

Apr 11, 2009 | Hyundai Motor 1998 Accent

1 Answer

To change gears, I need to fully press down on my clutch pedal to stop a grinding noise on my hyundai accent 2001Can I adjust the clutch cable,


Hi and welcome to FixYa,

In a manual 2001 Hyundai Accent, the clutch cable could be adjusted. The adjustment point is on the cable 'pad' where it enters the firewall in the engine compartment.
86c2d7d.jpg
To adjust, the slack or free play must be decreased. This is done by turning the adjusting nut clockwise. Check back by pressing on the clutch pedal to your preference.
73309c3.jpg
Good luck and thank you for using FixYa.

Feb 18, 2009 | Hyundai Motor 1995 Accent

2 Answers

Clutch pedal


hi there have you turned the clutch arm upside down and pushed the cluch release brging into the cover cliping it in to the cover as these have a pull type clutch.

Jan 07, 2009 | 2009 Hyundai Genesis

Not finding what you are looking for?
Hyundai Motor 1998 Accent Logo

354 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

63801 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21990 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...