Question about Cars & Trucks

Open Question

I have a diesel leak on my ldv pilot van from the back end of the top of the engine, does any one know what it might be please ?

Posted by on

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 398 Answers

SOURCE: 1997 ford e-350 diesel with a fuel leak at the engine

fuel injectors

Posted on Mar 09, 2009

alicantecoli
  • 22114 Answers

SOURCE: golf 1.6 diesel engine, electrical burning smell

please state year as i will need to know if tis a common rail or injector pump type of engine ,if it common rail then loose the silly plastic cover on top of the engine as if it is what i suspect then this cover is making engine hot and the coils on the injectors are overheating ,also i think no 4 injector has the sensor on it that times all the others in and this could be the one thats faulty,these injectors are expensive and the lead one is about 500 euros

Posted on Jul 16, 2010

  • 508 Answers

SOURCE: I have a F350 diesel non- tubo with a fuel leak in back at top. replaced o ring at back injector and replaced all hose clamps but still bad runing leak. What next?

This engine has fuel lines that run to each injector from the injector pump. On the older Fords they touch each other in places. This constant vibration from the engine has caused a pin hole in one of your fuel lines to the injector. You will need to find the bad line. Can be hard as some of these are buried and hard to see. The replacement line will need to be purchased from Ford as each fuel line has to be a certain length and they are all high pressure lines. I have seen this many times in the older Fords.

Posted on Apr 08, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My year 2000 diesel escort van wont turn over


sounds like cylinders are full of diesel you need to pull injectors to relieve pressure on cylinder.. it causes it to lock the engine up .. you might have left the key on with a leaking injector and filled the cylinder with diesel and then it would lock you engine.

Mar 30, 2014 | Chevrolet Express Cars & Trucks

1 Answer

LDV MAXAS PLATINIUM, 2006, 120BHP, 2.5 Does anyone


Hi
I would have though your garage would have either cleaned or replaced the aur mass sensor.
You can find this four/five pin plug somewhere between the air filter and the throttle housing or google its location.
These often dont show up well on diagnostic computers.
You can run engine with plug disconnected to see if it runs better or not. If it does then buy and fit a new sensor.
All that really controls your fueling is coolant sensor and air sensors....these often fail the most.
Good luck

Roger

Apr 24, 2017 | Cars & Trucks

2 Answers

Still need to know what of amount to put inautomatic for 50,000 service on 2007 dodge 2.8 diesel nitro as the sevice guys didn't do it have to take back as it has know dipstick can't you ta


Start with 3 quarts, then add until it just touches the end of the dipstick, run the engine until the ATF is hot to the touch and then top off to the marks between high and low..

Nov 06, 2012 | Cars & Trucks

1 Answer

Ldv pilot alternator pully diagram


HI WHAT DOES A ALTRENATOR LOOK LIKE IN A 02 LDV PILOT PLEASE

Jul 02, 2012 | Cars & Trucks

1 Answer

Wanting to know where thermostat is located. I believe its sticking causing van to heat up after being under load. May possibly need radiator flush. Im quite sure the head gasket is fine because she i


THE NORMAL LOCATION FOR A THERMOSTAT IS AT THE END OF THE TOP RADIATOR HOSE ON THE TOP OF THE ENGINE. THERE SHOULD BE A ROUND BALL SHAPED HOUSING HELD IN PLACE WITH TWO OR THREE BOLTS. UNDER THIS HOUSING, YOU WILL FIND THE THERMOSTAT. HOPE THIS HELPS. THANKS FOR AN HONEST RATING AND FOR USING FIX-YA. GOOD LUCK. PLEASE KEEP ME POSTED. IF YOU HAVE ANY FURTHER QUESTIONS, THEN PERHAPS A LIVE CHAT CAN ASSIST YOU.

May 23, 2009 | 1993 Toyota Previa

1 Answer

Starting problem


If its a 2005 it will be common rail, so you have to be carefull when dealing with this engine. The common rail has extremely high pressures which can harm you, also the fuel injectors are capacitor discharged and are high voltage. Now thats aside, look at the high pressure pump at the front of engine. If the code on it ends in 018 then its fed by an electrical fuel pump. These fuel pumps can fail. if it has another number then the HPP draws its own fuel. The symptoms are air ingress into the fuel lines, causing the fuel to run back to the tank. Its probably worse in cold weather due to the contraction of the fuel pipes in the cold. Check all fast fit connections for security. A trick is to put grease on the connections, it wont last long but might give you an idea where the leak is.

TL

Dec 20, 2008 | 2005 Peugeot 405

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

42 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...