Question about 1999 Dodge Caravan

1 Answer

How does a blend door work (power) ? location ? on a 99 grand caravan .

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 103 Answers

They work by the ac control motor on the dash very seldeom they go bad..

Posted on Apr 19, 2013

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 11 Answers

SOURCE: REMOTE KEYLESS ENTRY 99 GRAND CARAVAN

INSTALLATION: REMOVE THE TOP DASH COVER USING A FLAT TIP SCREW DRIVER AND LOCATE THE CONNECTOR FOR THE RKE MODULE. THE CONNECTOR WILL BE SMALL AND LOCATED NEXT TO THE HVAC DISTRIBUTION DUCT. MOUNT MODULE AND INSERT THE CONNECTOR. SINCE THE BODY CONTROL MODULE IS INVOLVED WITH THE RKE THIS MAY OR MAY NOT WORK BECAUSE NOT ALL CONTROLLERS ARE THE SAME BUT IF YOU WOULD LIKE TO TRY TO PERFORM THE TASK TRY THIS. FOR PROGRAMMING:

  1. Using a functional key fob transmitter, unlock the vehicle and disarm the Vehicle Theft Security System.
  2. Insert ignition key into the ignition switch.
  3. Turn the ignition switch to RUN position without starting engine.
  4. Using a functional key fob transmitter, press and hold the UNLOCK button for a minimum four seconds (maximum ten seconds)
  5. While holding UNLOCK button, and before ten seconds passes, press and release the PANIC button. A single chime will sound to verify that the RKE module is set to receive the new Vehicle Access Code(s)
  6. Within 30 seconds of the chime, press and release the "LOCK" and "UNLOCK" buttons on the transmitter at the same time. Then press any one of the buttons. The BCM will sound an abbreviated chime to acknowledge that the programming of the transmitter has been completed and was successful.
  7. Repeat step 6 for all transmitters that will be used with this vehicle (up to 4 total)
  8. Programming mode will last for 30 seconds. To get out of programming mode sooner, turn the ignition OFF. A single chime will sound to verify that the RKE module will no longer accept additional Vehicle Access Code(s)
  9. When Vehicle Access Code(s) programming is complete, turn the ignition switch to the OFF position and verify RKE system operation using each key fob

Posted on Sep 27, 2008

djchillsnyc
  • 151 Answers

SOURCE: locate a fan relay switch

56541646.gif
check your blower motor resistor also, like in this pic
the fan relay is loacated driver side under the dash fuse box









Posted on Dec 16, 2008

mcgyver468
  • 710 Answers

SOURCE: fuse location for Grand Caravan's power windows

Under the driver's side dashboard is the fuses for all the windows and interior electrical devices. good luck

Posted on Apr 25, 2009

  • 1 Answer

SOURCE: 2001 dodge grand caravan power sliding doors not operating

You may have already checked this but there is a switch located close to the overhead button that will disengage the door buttons for child safety, is that turned off?

Posted on Jun 05, 2009

  • 373 Answers

SOURCE: Dodge Grand Caravan Sport 2001 Location of PCM

it is located on driverside behind front headlight next to radiator. fuse/relay box is just behind it

Posted on Apr 20, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why does the battery run down over night in my vehicle


Could be the radiator fan running. Check the temp switch and relay.

Oct 16, 2015 | 2002 Dodge Grand Caravan

1 Answer

2000 dodge grand caravan sport 3.3L flexonly blows cold air


You say you can hear the climate control work, but the blend door for the heater may not be moving. If both heater hoses are hot, I would suspect the blend door.

Dec 10, 2012 | Cars & Trucks

2 Answers

2005 grand caravan front heater and defrorst not working ,rear heater is working . i also hear a hissing noice on the passenger side


Just a suspicion: hissing noise comes from failed/jammed/malfunctioning motor to move the door
in the ducting to route heated air to the hoses/ports for "heater" and "defrost."
Problem: failure of motor/linkage to heater/defrost selector door under the dash on the passenger side.
Also sounds like you have not blown fuse to this selector door.
Also - hissing noise could be air being forced against the closed door (which should be open) - in this
case, you'd want to check the fuse to the heater/defroster actuator door.
The rear heater works since its function is not related to the operation of the front heater/defroster.

Jan 02, 2011 | 2005 Dodge Grand Caravan

1 Answer

Dodge gran caravan..my aircondition sometime work sometime just blow hot air..


check blend door for proper operation proply broken gears or door stuck its located on heater case.

May 27, 2010 | 2006 Dodge Grand Caravan

1 Answer

Heat is out on 1999 jeep grand cherokee limited


I had this problem on a 99 grand cherokee limited, It was the heater blend doors and if you have dual climate control one side usually goes out before the other. These blend doors are located behind the glove box unaccessible inside the HVAC shell.
(http://www.wjjeeps.com/hvac_sub_assembly.htm) Motor failures for this HVAC sub assemblies is also something to look for although much less common.
My local dealership estimated $$$$$$$$$950.00 because they have to remove the entire dash so I looked around for something else.
http://cgi.ebay.com/ebaymotors/Blen-Dor-Jeep-Grand-Cherokee-Blend-Door-Heater-Repair_W0QQcmdZViewItemQQhashZitem3eef1e1cd6QQitemZ270299700438QQptZMotorsQ5fCarQ5fTruckQ5fPartsQ5fAccessories

I used something similar to this and now have heat that is controlled solely by the knob nearest the driver. It wasn't very difficult just kind of a tight squeeze.
Hope this helps
GOOD LUCK

Jan 09, 2010 | 1999 Jeep Grand Cherokee

1 Answer

Were is the blend door located on the 2004 jeep grand cherokee overland


blend doors are located in the heater box behind the dashboard.. if you are having heating problems because of faulty blend doors, try heatertreater.com they have a permently quick fix solution that really does work. i have fitted quite a few with no problems, even better heat than standard jeep blend doors..
hope this helps

Dec 24, 2009 | 2004 Jeep Grand Cherokee

1 Answer

2001 dodge grand caravan power sliding doors not operating


You may have already checked this but there is a switch located close to the overhead button that will disengage the door buttons for child safety, is that turned off?

Jan 06, 2009 | 2001 Dodge Grand Caravan

1 Answer

My heater is blowing cold air 2005 dodge grand caravan


In this order check the following:
Antifreeze level
thermostat
blend door
blend door motor...accordianman

Dec 16, 2008 | 2000 Dodge Caravan

Not finding what you are looking for?
1999 Dodge Caravan Logo

77 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

75005 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7710 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...