Question about Cars & Trucks

1 Answer

1993 chevy 2500 pickup 6.5 turbo diesel starts easy but dies acts like it runs out of fuel will not start or very hard to start replaced fuel pump fuel filter and fuel pump relay

If you wire fuel pump direct to battery it stays running but thats not fixing problem

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 122 Answers

If it runs and dies.i would check fuel pressure and make sure its not getting air in the fuel sound like air in fuel

Posted on Apr 19, 2013

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
maverick_809
  • 2 Answers

SOURCE: 99 chevy blazer wont stay running

You will want to check the fuel filter you installed to make sure that it is installed correctly. Most of the replacements are a one way filter to allow fuel to go from the tank to the engine but to not go the other direction so if by chance it is installed backwards then you would have this problem.

Posted on Mar 19, 2013

  • 57 Answers

SOURCE: Chevrolet 2500 Not Running, May Be Fuel Filter Sensor

That red wire is only for the fuel heater.will not cause a no start.try pumping the primer pump on top of the fuel flter hsg. but first open the bleed screw,which is black plastic also located on the top.this will eliminate any trapped air that might have entered the fuel intake system.if the pump does not get firmer and harder to push, then you have a leak in the fuel supply lines or the ck valves in the fuel filter hsg or stuck open. Still no start have it scanned to ck fuel pressure while cranking.it should be close to 5000 lbs

Posted on May 14, 2008

  • 99 Answers

SOURCE: Chevrolet 2500 Not Running, May Be Fuel Filter Sensor

if it dont have good compression it will not start check the comp and make sure there no water in oil if fuel pressure is low it will not pop the injector open try some starting fluid

Posted on Jan 26, 2009

flacooo1
  • 172 Answers

SOURCE: I have a 2002 chevy blazer 4.3L that wont start

are you using the original key ?? sounds wear but in the key switch there is a sensor that detects if the right key is in use otherwise it will kill the power to the fuel pump or it can be a fuse look under the left rear passanger seat there is another set of fuses and the other set of fuses are on the driver side near the door and there is another set of fuses and relays inside the hook next to the battery

Posted on Apr 01, 2009

  • 218 Answers

SOURCE: 1995 JEEP GRAND CHEROKEE RAN AND DIED WILL NOT START

IS IT THE 4.0L?IF SO U MAY HAVE A BAD CRANKSHAFT POSITION SENSOR.

Posted on Apr 28, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 2001 Chevy 2500 HD 6.6 L turbo diesel won't


fuel injection pump is failin or has issues--getta haynes manual for pro car maintenance

May 30, 2012 | 2001 Chevrolet Silverado 2500HD

1 Answer

1993 6.5 desil turbo chevy 2500 5speed runs good when you drive it 40 miles and shut it off for 15or20 min it wont start backup unless you pull it or let it cool off overnight what could be wrong


FUEL DRIVER MODULE MOUNTED ON PUMP WILL CAUSE HARD TO NO START HOT
SMALL BLACK BOX MOUNTED ON DRIVER SIDE OF FUEL PUMP
TRY COOLING IT OFF WITH WATER NEXT TIME TO SEE IF TRUCK STARTS FASTER

May 08, 2011 | 1993 Chevrolet C/K 2500

1 Answer

2000 chevy ck 2500 5.7L 4x4


Get a fuel pressure gauge and measure on the fuel supply line on the rear of the inlet manifold. In my experience you need close to 4Bar while cranking. Priming pressure should be about 4.4Bar. This test will eliminate a variety of possible problems. I have had a variety of problems and found this very helpful.

May 14, 2010 | 1997 Chevrolet C/K 2500

1 Answer

2000 chevy ck 2500 5.7L 4x4


Is Check engine light on..?
Your problem sound like a fuel pressure related .If you have a fuel pressure tester, check the fuel pressure dont't drop. (key on engine off)

Mar 24, 2010 | 1997 Chevrolet C/K 2500

3 Answers

My 1993 Chevy 350 fuel injected pickup just quit


Check to see if there is any power getting to the fuel pump, if there is 12 volts going to the fuel pump then replace the pump, if there is no voltage present, the problem could be the fuel pump relay, a fuse, or a break in the wiring.

Jan 23, 2010 | 1993 Chevrolet C/K 3500

1 Answer

1994 Chevy 4 Dr. 2500 6.5 Diesel start and stall problem


1994 Chevy Truck K 2500 Suburban 4WD V8-393 6.5L DSL

Fuel Cut Solenoid: Testing and Inspection
An inoperative shutdown solenoid can cause a no-start condition. Disconnect solenoid harness connector and with ignition switch in the "ON"
position momentarily touch solenoid harness connector to solenoid connector. If a "click" sound is heard, the solenoid circuit is operating
properly. If "click" is not heard, the system should be diagnosed as follows:
1. With test lamp connected to ground and the ignition switch in the "ON" position, backprobe the shutdown harness connector. If the test lamp
does not light check for open circuit form the ignition switch to the solenoid.
2. If the test lamp lights, check the ground circuit between solenoid stud and injection pump cover to see if connectors are clean and tight. If the
connections are not clean and tight repair and retest.
3. If the ground circuit is "OK", remove the injection pump cover. Connect a jumper wire between solenoid ground connector and ground. With
the ignition switch in the "ON" position, momentarily touch shutdown solenoid harness connector to shutdown solenoid terminal. If solenoid
operates, check for internal injection pump problem.
4. If the solenoid will not operate, replace the shutdown solenoid.
_____________________________________
Fuel Cut Solenoid: Service and Repair
REMOVE OR DISCONNECT:
1. Remove pump cover.
2. Terminal contact nuts.
3. Solenoid.
INSTALL OR CONNECT:
1. Solenoid in the pump cover.
- On the shutdown solenoid, make sure that the linkage is free.
- On the cold advance solenoid, make sure that the plunger is centered so that it will contact the check ball in the fitting.
2. Insulating washers on the terminal studs.
3. Terminal nuts and tighten to 1 Nm (9 in lbs).
4. Pump cover.
5. Inspect solenoid operation prior to installing the pump cover. Use a 12 volt DC power source.

fcd8cd6.jpg

Sep 10, 2009 | 1995 Chevrolet K2500

1 Answer

1995 Chevy Diesel, Randomly dies


Sounds like you have a problem with the crank sensor.They can have an intermitant fault.like an open curcuit Try changing the sensor.good luck hope that was helpfull.

Jul 24, 2009 | 1995 Chevrolet C/K 2500

3 Answers

1998 Chevy tahoe Hard to start when cold


replace your MAP sensor(manifold absolute pressure) the map sensor is the computer for your fuel pressure regulator telling how much pressure. Unless your tahoe runs like **** going up hill than it inevitably your fuel pump

Feb 17, 2009 | 1999 Chevrolet C/K 2500

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

323 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76848 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...