- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
DTC P0340: Camshaft position sensor A circuit (bank A). Probable cause:
1. The replaement sensor could be defective
2. Connector terminal contact dirty or corroded
3. Wire harness fault. Check for correct voltage, open, short to ground, short to voltage
4. Control unit software needs to be updated
5. Faulty PCM or ECM
Find the release bolt from underneath, measure the bolt position relative to edges or some other defined point that you can follow through the same points/edges to the top (you may have to estimate a little) and work out where to drill or remove the ply to reveal the release.
what you to check this . look where the wipers are there is a plastic vent , see if you can ply it up . there is a drain on each side to let water drian inside the fenders. here is the link to my garage I am on facebookhttps://www.facebook.com/TedsRepairs
UNLESS YOU ARE A VERY GOOD EXPERIENCED MECHANIC, WITH THE CORRECT TOOLS, I RECOMMEND A COMPETENT SHOP THAT WILL GUARANTEE THE WORK. OTHERWISE, IT'S RECOMMENDED TO BUY A HAYNES REPAIR MANUAL AND FOLLOW THE STEPS EXACTLY-ALSO THERE MAY BE EXACT INSTRUCTIONS ONLINE IF YOU GOOGLE >> CHANGE or REPLACE WATER PUMP DODGE NEON(and engine size)
the blower motor is mounted behind and below glove box,there are four screws holding a motor cover,then three screws holding the motor,and unplug the wires to it,a one hour job,$40.00 labor,blower motor=$40.00
Vehicles involved in the recall include the following:
1998-2002 Ford Ranger 1992-1997 Lincoln Town Car 1992-1997 Ford Expedition 1992-1997 Mercury Grand Marquis 1993-1998 Lincoln Mark VIII 1993-1995 Taurus SHO 1999-2001 Ford Explorer 1999-2001 Mercury Mountaineer 2001-2002 Ford Explorer Sport 2001-2002 Ford Explorer Sport Trac 1992-1993 E150-350 Vans 1997-2002 E150-350 vans 1993 Ford F-Series pickups 1993 Ford Bronco 1994 Mercury Capri 2003-2004 Ford F0150 Lightning 1995-2002 Ford F53 motor homes.
Check for dirty throttle body. Maybe IAC motor gummed up. If throttle body dirty, get some carb cleaner and a soft toothbrush and clean well. If this doesn't work, most likely an IAC (idle air control) motor.