Question about Cars & Trucks

Open Question

Replace water pump on 1988 honda accord - Cars & Trucks

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
maklean
  • 1665 Answers

SOURCE: 1999 Honda Accord Coupe

See an example
DISASSEMBLY 1. Remove the suction pipe and the O-ring from the oil pump.
ad6db20.gif 2. Remove the rear cover with the gasket and pins. 3. Remove the cam ring. 4. Remove the rotor and vanes. 5. Remove the front side plate.
1868d6d.gif 6. Remove the inner and outer O-ring. 7. Remove the spring. When assembling, use a new gasket and O-ring.
47a7732.gif 8. Remove the pulley nut with the spring washer. 9. Pull off the pulley and the woodruff key.a12b5d7.gif 10. Remove the snap ring using snap ring pliers. 11. Drive out the pulley shaft with the bearing. If necessary, use plastic hammer

Posted on May 30, 2008

Ad
  • 31 Answers

SOURCE: how do u replace a shifter cable for a 1988 honda accord lx

remove cable from transmission,follow cable behind engine,along exhaust pipe,then up through floor into center console.along the way you will find retainer clips (on both ends of cable) which hold the cables in place,and also underneath you will find a fastner which holds cable to bottom of floorboards and a panel with a rubber gasket in which the cable goes up into the console through. you must then remove center console to release the other end of cable.Once cable is loose go under car in the middle of the cable and pull out from floor then pull the other end out from engine compartment.

Posted on Jul 26, 2008

jpetrovic06
  • 8 Answers

SOURCE: vaccum line diagram for a 1988 honda accord

http://www.pauldesign.ru/honda/shopmanual/62se320.pdf

There is a Vaccum diagram in that manuel.
make sure you are looking at the correct engine diagram
You mostlikely have the A20A3 or A4 that is the diagrams you should be looking at.
Good luck.

Posted on Nov 03, 2008

pittmanc
  • 194 Answers

SOURCE: what all is involved with replacing water pump on 1986 Honda Acc?

your water pump is in the timing case and requires you to take timing case, timring belt, motor mount and water pump off, then you have to put all back on but you will need to make sure you reset the timing before starting the engine

Posted on Dec 15, 2008

alicantecoli
  • 22156 Answers

SOURCE: 1988 honda accord 2 door I need to change clutch

no remove gearbox but you might need to lower subframe to gain access ,use an engine lift to support gearbox or a block and tackle so you can pull it out and not have to lower it

Posted on Jan 13, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Replace water pump honda accord


Is coolant leaking at the water pump?

Jun 03, 2013 | 2006 Honda Accord

2 Answers

Oil pan drain plug stripped 1988 Honda Accord


Just go to the parts store with your old plug and buy a new self tapping plug that you can replace it with. Pump is on the crank shaft.

Jan 05, 2010 | 1988 Honda Accord 4 Door

1 Answer

What is the clearance between the oil pan drain and the oil pump on a 1988 Honda Accord 2.0L?


it's a long ways I believe that year has the pump on the front of the crank shaft. However the pickup screen is 3/4 inch away.

Jan 05, 2010 | 1988 Honda Accord 4 Door

1 Answer

Can not get JUICE to fuel pump replaced pump & relay will run if i put gas in CARB?88 honda accord


Did you check #1 fuse 15 amp to see if it were blown? This fuse also controls the fuel pump. This Test procedure is from Mitchell Repair.
moz-screenshot-1.png9769a1b.jpg v\:* {behavior:url(#default#VML);} o\:* {behavior:url(#default#VML);} w\:* {behavior:url(#default#VML);} .shape {behavior:url(#default#VML);} Normal 0 v\:* {behavior:url(#default#VML);} o\:* {behavior:url(#default#VML);} w\:* {behavior:url(#default#VML);} .shape {behavior:url(#default#VML);} Normal 0

Nov 25, 2009 | 1988 Honda Accord 4 Door

1 Answer

Where is fuel pump located and how easy is it to replace for 1988 honda accord dx


its in the fuel tank. there is an access panel in the trunk, behind the rear seat. you are lucky its so easy.

Sep 22, 2009 | 1988 Honda Accord 4 Door

2 Answers

1988 Honda won't start


the problem is most likely the fuel pump has seized up, the reason for this is when u run out of gas the pump which uses the gas around it to cool gets very hot and the bearings seize up, get this kink of complaint all the time on fixya.

Mar 01, 2009 | 1988 Honda Accord 4 Door

1 Answer

88 honda accord water comin thru heater


Check the drains for the cowling area, notorious for plugging with leaves,dirt,sticks,bugs,lint,ect...

Feb 05, 2009 | 1988 Honda Accord 4 Door

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

51 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...