Question about Cars & Trucks
Posted by Anonymous on
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
There will be adjustment screws located on at least two different spots surrounding each headlamp. By turning these screws you move the angle of the headlamp. Most shops will do this at a very resonable rate, I say this because improper headlamp angle may lead to a ticket, or at least a warning. To say the least, they have to be at specific angles and heights. Good luck.
Posted on Feb 20, 2009
The headlamps are adjusted by a wheel which can be operated by aphillips screwdriver. There's a hole in the top of the headlamphousing or radiator support which leads to the wheel with little teethon it on the back of the headlamp. The lamps on your car emit a veryshort but wide beam, so no horizontal adjustment should be needed.
Posted on Aug 13, 2009
Helps to remove the battery, but small ahbds can do it.
Directly behind the lens is a big round cap ... twist it off. The bulb is held in place with a spring that locks in to a notch in the holder. When handling the new bulb, don't touch the glass. The oil from your skin will cause it to shatter when turned on.
Posted on Oct 23, 2009
The adjustment screws/nuts should be located either on the top of the headlamp assembly,
behind the headlamp assembly, or near the frame rail by the radiator
You will have vertical adjustment screws for each independent beam (separate highs and separate lows, but will be same screw if highs and lows are the same bulb). You may also have additional horizontal adjustment screws as well
Park your car on a level ground 30 feet from a wall and measure the height from the ground to the bulb and mark on a wall (do this for highs beams and low beams if the bulbs are separate, if highs and lows are the same bulb, only do it for the lows)
For Low Beams: If the headlights read VOR, then aim the brightest part or cutoff part just below the mark on the wall. If it says VOL or nothing, aim them 2 inches below the mark on the wall.
For High Beams (if separate from low beams): Aim the headlight directly at the line you marked on the wall.
Posted on Nov 04, 2009
Tips for a great answer:
Apr 04, 2018 | Kia Cars & Trucks
Mar 10, 2018 | Toyota Cars & Trucks
Feb 15, 2015 | 2006 Pontiac Torrent
Nov 23, 2013 | 2005 Kia Sportage
May 04, 2011 | 2005 Kia Sedona
Dec 31, 2010 | Kia Sedona Cars & Trucks
Feb 04, 2018 | 2006 Nissan Murano
Jan 03, 2009 | 2004 Kia Optima
25 people viewed this question
Usually answered in minutes!